When applying the brakes pedal went to the floor, and the vehicle rear ended another vehicle. Dealer can't find the cause.
1995 Chevrolet Blazer brakes complaints
Page 7 of 19: complaints 161 to 190 of 531, newest first, as owners wrote them.
Was traveling 50mph when the ABS brakes failed while operating in 2wd mode. It's a 4wd vehicle. Would have to keep distance of few car lengths. Been to dealers & had them replaced 5 times. Mechanic could not solve the braking problem.
Consumer was driving at 45 MPH and applied the brakes, the brakes jumped three times, and brake pedal went straight to the floorboard. Abs system kicked in and locked up.
When driving at any speed and applying brakes, the ABS system works intermittently, and vehicle will skid.
Abs systme is working intermittently and there is a loud knocking noise coming from the ABS system.
Abs brakes vibrate when pushing brake peddle, it shakes whole vehicle
While applying the brakes left front brake would lock without indications. Dealer has been contacted. Please provide further information.
Since purchased the anti-lock brake system experiences noise when braking and vehicle to skidding.
Anti-lock brake system is working intermittently.
Anti-lock brake system locked up occasionally. When pressing on the pedal it did not go down all the way, all power was lost. Mechanic is aware of the problem, cannot determine if the repair work can be done.
Since purchased the front wheel disc brakes experiencing excessive wear due to calipers not applying pressure evenly to pads.
When applying the ABS brakes on dry pavement pedal goes to the floor, causing extended stopping distance. Master cylinder replaced.
Driving down the hwy at approx 55mph on dry road, slowed down to go around a curve, front brakes locked but not the back brakes. Felt like a power surge. Brake pedal was still depressed to the floor. Vehicle fishtailed and rolled over into a ditch.
The ABS light comes on & stays. Have been to dealer & was informed by mechanic the problem could be the ABS mode solenoid sensor. The light can come on while traveling just 10mph. Will go off when vehicle is turned off.
While driving on the highway on dry road noticed traffic was slowing down. Went to apply brakes, and brakes went completely to the floor, felt softand couldn't control vehicle, ABS failed.
While driving engine check light will light up. When the brakes are applied it feels like the power assist brakes are lost, consumer says that the brake could be stood on and there would be no response. Deale rhas been contacted.
When applying the brakes pedal went to the floor and the vehicle rear ended another vehicle. Currently, dealer has vehicle.
Whenever the ABS brakes are applied, at various speeds and various surfaces, they would lock up & vehicle would slide. Can happen when going up hill & use ABS brakes. Will be taking vehicle to dealer to check out problem.
While driving at 35 MPH another vehicle ran a red light, and consumer's vehicle rear ended the other vehicle on the right hand side due to the ABS system locking up, an vehicle skidding.
While driving 35mph came upon stopped vehicles on highway and had to stop suddenly. Brake pedal went to the floor. Did not feel ABS working. Vehicle failed to stop & rearended vehicle in front. Air bags did not deploy. Brakes were just serviced prior to accident.
When driving at any speed, the anti-lock brake system kicks in, causing vehicle to accelerate. *ak
Antilock brakes activate at the slightes bump or during turns resulting in brake fading and accidents.
When traveling under any normal braking and upon depressing the brake pedal on dry or wet surface, pedal traveled to the floorboard, resulting in extended stopping distance, brake faded away. Consumer has contacted the dealer, dealer has yet to replace parts. Please provide any further details.
In panic stops, it feels like the brakes are not working. The pedal gets spongy and feels like sliding on ice. Looked up the federal safety agency list, mfg campaign 19i005000 is listed for this problem. Chevrolet via 1‑800‑222‑1020 number says no such campaign exists.
Abs brake system isn't working.
Ongoing problem with pressing hard on brake pedal to get vehicle to stop properly. Vehicle experienced extended stopping distance. Vehicle been in/out of dealer shop, and some repairs were made. But did not correct the problem . Can the federal safety agency help or provide additional information.
Brakes failed prior to recall notice resulting in vehicle collision, no deployment of air bags during collision. (attorney for consumer) mjs (99v006)
While driving on any type of bumpy road and applying the brakes at 30 to 40 MPH there is a spring type noise coming from the brakes.
When using the emergency brake, electrical windows did not work. Dealer contacted, and stated emergency brake was cutting the wires to the harness. Repairwork done at owners expense. Provide further information.
While driving applied brake pedal, brakes would not go down. After applying for 5-10 seconds, brakes give and still will not go to floor. Dealer contacted and is aware, no recall. Problems still exists. Provide further information.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 Chevrolet Blazer?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history