Consumer reporting excessive wear of brake pads and rotors, from 17,614 to 35,500 miles there were three sets of brake rotors and two sets of brake pads replace on the vehicle, and the problem reoccurs. The dealer has been notified. *nlm water leak on passenger side floor, driver side door rattles going over bumps, both front windows outer molding comes off, moldings replaced, humming noise from front wheels when coming to a stop, wheel bearing / hub replaced.
1999 Chevrolet Blazer body complaints
Page 2 of 2: complaints 11 to 21 of 21, newest first, as owners wrote them.
Due to location of drainage hose, the top pin hinge on passenger and driver doors rusted out. Consumer has contacted dealer. *ak the hinge bushings are showing signs of wear, the dealer admits there is a problem with the drain locations, consumer states with the corrosion present on the hinge pins there is a possibility of breaking.
The vehicle experienced clunking noise in the front end due to loose body mounts, this problem has occured on two occasions. Nlm
Vehicle experiences stalling, after stalling there is a burning smell, dealer has replaced the fuel pump, crank sensor, map sensor, PCM, fuel pump module, vehicle still experiences stalling, consumer feels problem is an electrical problem. Ses light flashed at times, dealer replaced coil wire. Keyless entry inoperable, dealer replaced receiver, remote module, and reprogrammed transmitters. Consumer states vehicle has excessive wind noise on both sides. There is a clunk when backing up and turning left or right. Overhead panel goes blank in morning, when first starting vehicle, dash and gauges will not light up, and overhead compass was replaced. Consumer states gas mileage is not as good as it used to be. Ses light illuminated.
I have contacted chevrolet and they will not assume responsibility for the frame weld failing. They acknowledge the vehicle is unsafe to drive, but offer no remedy other than replacing the frame at my own expense. They could not provide me with a cost to do this type of replacement. I feel this is a potential safety issue effecting other owners. I would like to see chevrolet take responsibilty for what is obviously a manufacturing defect. I realize the vehicle is out of warranty because of miles, but it is a 2 year old vehicle which a reasonable person should expect the frame to last beyond that time.
Power locks on hatch back door is inoperable, causing no enter or exit from that door, cause unknown. Please give any further details.
Internal bracing is inadequate and has, as a result of the apparent lack of structural integrity of the mounting brackets (and internal mounting structures), caused a few welds to begin splitting and begun to cause denting in the sheet metal on the side of the vehicle.
Door hinges/slides/rollers fail to secure the door in the open position causing injuries when door has closed on consumers.
Pulley makes squealing sound and could cause drive belt failure.... Tire would rub on iner fender well when making turns. Front suspension make a squeeking or creeking sound at any speed when going of any type of bump.....driver side seat adjustment lever broke off in my hand when trying to adjust front seat position.
There is hot heat coming from the vents under the dashboard, and one of the vents is right near the gas pedal.
Hatch raises to vertical, or near vertical position. Opened garage while vehicle was in garage with hatch open and garage door busted hatch. Exact same thing happened on a friend's suburban. Hatch should only open to horizontal or angled position - not vertical. Dealer charged $1300 to replace hatch!!!!!
VIN decoder
See the problems and recalls for an exact car
Buying a used 1999 Chevrolet Blazer?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history