2020 Chevrolet Colorado engine problems

Filed Oct 26, 2026 · Brakes, Engine · IA

2020 Chevrolet Colorado 2.5L, approximately 81,500 miles. I experienced a sudden loss of power brake assist. There was no warning noise associated with the failure; the brake pedal became extremely hard and required substantially greater pedal pressure to stop the vehicle. The vehicle was inspected by an independent professional mechanic. Inspection found that the brake booster vacuum pump itself was not the primary source of the failure. The failure was at the engine exhaust camshaft interface that mechanically drives the vacuum pump. The camshaft drive was damaged and no longer properly operated the vacuum pump, resulting in loss of brake vacuum assist. This is not normal brake-pad or rotor wear. The hydraulic brakes remained functional, but without the vacuum assist the pedal effort increased dramatically, creating a significant braking safety concern. The vehicle has been removed from normal use pending repair. I am reporting this because failure of an engine component that drives the brake vacuum pump can cause sudden loss of power brake assist.

Filed Oct 23, 2026 · Brakes, Engine · CA

Vacuum pump for brakes failed and damaged the whole engine to be replaced because of faulty vacuum pump design

Filed Oct 21, 2026 · Engine · IN

The engine malfunctioned, specifically the 4 camshaft actuator solenoid valves, making the car unable to safely drive. The check engine light came on, likely indicating the car was unsafe to drive. GM issued GM Special Coverage N232430470 covering 2020 Colorado's with a 3.6L V6 engine for the Bank 2 exhaust camshaft actuator solenoid up to 15 years/150,000 miles. This was confirmed by a Chevy dealership. The vehicle was not inspected by the manufacturer, police, or insurance representative. My check engine light first came on 09/05/26, however, the check engine light did disappear later in the week. It came on again 09/27/26, so i decided to have the car inspected, despite the fact that the check engine light later went away.

Filed Sep 1, 2026 · Brakes, Engine · TX

While driving my 2020 Chevrolet Colorado through [XXX], the truck began having difficulty accelerating. As I exited the highway and turned into a gas station, the truck suddenly lost power. The steering became extremely difficult, and I lost normal brake assist. The brake pedal became extremely hard, and I had to apply extreme force to stop the truck and avoid crashing into a wall at the gas station. Fortunately, no collision occurred. The truck was towed to Ed Corley Ford in [XXX] because I was stranded in a remote area with very limited options. They diagnosed a failed/broken vacuum pump and told me replacing it should make the truck operable so I could drive it home to [XXX]. I authorized the repair. After replacing the vacuum pump, they told me they started the truck and heard an abnormal sound. They shut it off, and when they tried to restart it, the truck would not start. They wanted to perform additional diagnosis, but I declined and had the truck transported back to [XXX] for evaluation by a Chevrolet dealership. Huffines Chevrolet Lewisville inspected the truck. Their technician removed the camshaft position sensor and used a borescope to inspect the camshaft. They documented that the camshaft is damaged at the end where it connects to the vacuum pump and stated the actuator pin was most likely bent due to the vacuum-pump failure, damaging the camshaft and causing it to be slightly out of time. I have also been informed of engine damage. The truck remains inoperable and is currently available for inspection. I am concerned this is a safety defect because the vacuum-pump failure resulted in a sudden loss of normal brake assist while I was driving and was followed by camshaft/engine damage. I am asking the federal safety agency to investigate this failure and similar Chevrolet Colorado complaints. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Aug 13, 2026 · Engine · CA

a/c control knocks out tempter senor and gauge goes to zero and check engine light comes on, gas mileage goings to hell, turn off engine clutch fan runs for several minutes, can still touch water hoses by hand and not even hot. This is a big safety problem because I'm looking at the gauge and now causing more smog! Chevrolet Merele Stone in Porterville CA had it all day reporting A GM Strat sticking ,it was a brand new gm delco and senor and still doing it . It's a $1000.00 to repair itThey had to jump start my truck went picking it up. tried to charge the battery over night but dead battery, had to replace it $250.00 expense, and $189.00 to denoised. Called GM for a appointment in Visalia to check the problem 42 mile on way from home and showed up to No APPOINTMENT!

Filed Aug 7, 2026 · Engine · 36,500 miles · WY

The contact owns a 2020 Chevrolet Colorado. The contact stated that while reversing out of the driveway, the check engine warning light illuminated. The failure recurred while driving 65 MPH. The vehicle was taken to AutoZone, where DTCs P0024 and P0014 were retrieved, indicating exhaust camshaft position system performance issues for Bank 2 and Bank 1. The contact associated the failure with GM Special Coverage Number: N232430470 (Camshaft Position Actuator Valve Solenoid - Bank 2 (Left Side) Exhaust). The vehicle was then taken to the dealer, where the diagnostic result was confirmed. The dealer swapped the camshaft position sensor actuators between both banks and cleared the codes. The contact was advised that the cause of the failure would be determined if the diagnostic trouble codes returned. The vehicle was not repaired. The manufacturer was notified of the failure and informed the contact that the VIN was not included in the special coverage. The failure mileage was approximately 36,500.

Filed Mar 23, 2026 · Engine · 119,000 miles · AR

The contact owns a 2020 Chevrolet Colorado. The contact stated that while operating the vehicle, the check engine warning light remained illuminated. The vehicle was taken to an independent mechanic, who diagnosed the vehicle with camshaft position sensor failure. The contact was informed that the camshaft position sensor needed to be replaced. The vehicle was not repaired. The local dealer and manufacturer were notified of the failure, but no assistance was provided. The contact was informed that the VIN was not under a Manufacturer Extended Warranty coverage related to the failure. The failure mileage was 119,000.

Filed Jul 3, 2025 · Engine · TX

The component that failed is the camshaft position actuator. My check engine light came on. Had my vvt solenoids replaced and the mechanic told me the actuator needs replacing. GM has issued a special bulletin to fix this part for the same year make and model as my truck but my vin doesn’t meet the criteria. I have only owned this vehicle for 8 months.

Filed May 8, 2025 · Engine · WV

Unknown. When my truck reaches a certain speed it is jumping or missing, it feels like a brake is sticking but I’m told it is a problem with my transmission, torque converter, going bad. It is getting worse. It cuts the power down on the vehicle. If I can go faster than 60 it doesn’t do it.

Filed Mar 31, 2025 · Engine · 67,000 miles · UT

The contact owns a 2020 Chevrolet Colorado. The contact stated while driving 70 MPH, the check engine warning light illuminated. The contact stated that the vehicle started to lose motive power. The vehicle was taken to Auto Zone and was diagnosed with exhaust camshaft position actuator failure. The vehicle was then taken to a dealer where it was diagnosed with exhaust camshaft position actuator failure. The local dealer was contacted; however, the vehicle was not repaired because the vehicle was not under recall. The manufacturer was made aware of the failure. The failure mileage was approximately 67,000.