The contact owns a 2015 Chevrolet Corvette. The contact stated that while the vehicle was on a trailer dynamometer machine, a plastic piece at the bottom of the accelerator pedal fractured. The accelerator pedal slid up and became stuck in the full-throttle position and had to be manually returned to the normal position. The contact stated the engine overheated, and the stop button failed to turn off the vehicle. The ABS and traction control warning lights were illuminated. The vehicle was towed back to the residence. The failure mileage was approximately 40,000.
Chevrolet Corvette abs comes on
114 of the 5,049 owner complaints about the Chevrolet Corvette describe aBS light or ABS activating, most of them for the 2000 model year.
- owner complaints
- 114
- worst model year
- 2000
- typical repair cost reported
- $2,000
- typical mileage
- 45,000
Is there a fix? There are 3 recalls for this area of the car. See below
By model year
Often reported together
Brake failure 5Headlights 4Warning lights 3Battery drain 3Won't shift 2Stalling 2Power steering loss 2Loss of power 2
Trouble codes mentioned
C1214 2P0101 1
What owners say
Normal driving conditions while in Z-mode in moderate traffic, an audible bang was heard, however there was no immediate issue. A few minutes later the Check Engine Light, ABS, Traction Control and other lights appear on dash. Once lights appear, brakes fail and no longer slow the car down, the gas pedal only revved the car and could no longer accelerate. The car was still on and “driving”, I just didn’t have acceleration or brakes. I put my turn signal on and eventually was able to safely pull off the road and stop the vehicle utilizing Neutral and the Emergency Parking Brake. I was in genuine fear of crashing due to not having brakes or acceleration and felt that if the parking brake and/or neutral failed, then I’d have to crash to stop the vehicle. Not having brakes or acceleration put myself, my passenger, and every vehicle around me when it occurred at risk of injury. This has occurred twice in less than 1 year of ownership with this vehicle and I’ve taken it to two dealerships, Mike Reichenbach Chevrolet and Rick Hendrick Chevrolet. When it first occurred in December 2023, I was also in Z-Mode in light traffic, after it occurred, I drove slowly to the dealership with the hazard lights on. The second time I brought it to a dealership was after the first dealership couldn’t find the cause nor replicate the issue. The codes were cleared by the first dealership, but the car was still operating roughly and not as designed. The third time, in July 2024, it was brought to Rick Hendrick Chevrolet where the service invoice says “GOOD POSSIBILITY THE AFTERMARKET GPS UNIT PLUGGED INTO THE DLC PORT IS SHORTING OUT THE VEHICLE COMMUNICATION CIRCUITS AND CAUSING INTERMITTENT ELECTRICAL ISSUES. MAY BE ALSO CAUSING BATTERY DRAIN ISSUE.” The device referred to is called Bouncie, I got it AFTER this first occurred and the service team there is blaming both of these occurrences on the device. No repair was performed as the issue couldn’t be replicated.
The contact owns a 2006 Chevrolet Corvette. The contact stated while driving at speeds above 25 MPH, the ABS system failed, causing the front brakes to activate without the driver depressing the brake pedal. During the failure the active handling warning light was illuminated. The vehicle was taken to an independent mechanic who diagnosed that the active handling control module wiring harness was faulty and needed to be replaced. Additionally, while operating the vehicle the low beam headlights inadvertently turned off. The mechanic diagnosed that the wiring harness for the exterior lighting needed to be replaced. The vehicle was not yet repaired. The manufacturer and local dealer were notified of the failure. The contact was informed that the vehicle was previously repaired under the federal safety agency Campaign Number: 14V251000 (Electrical System, Exterior Lighting). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was 50,000. The contact stated that he pulled the fuse box and wiring from the car. In the photos, we can see a damaged wire around a tight bend that has created tension and caused a faulty connection.
I purchased my 2005 Corvette C6 from a used car dealership on 4/30/2023. The car was fine for the first week. The second week I began getting a lot of error codes specifically: Service Active Handling System Service Traction Control Service ABS Shocks Inoperative Service Fuel System. At times it would go into limp mode. I would find a safe place to pull off. I would shut the car off and it would not restart. I would check the relays under the hood and the passenger floorboard. Eventually it would restart and drive again until the next time. I have replaced the following components: Battery cables with factory replacement New Battery, twice New high output alternator and a new belt. These items solved the many codes. Now I get Service Traction System, and the traction control shuts off. When this happened last, I got a P0101 MAF sensor error. Replaced the MAF Sensor 8/13. Has not happened as of yesterday. I have checked all of the grounds, added a new ground system called the Big Three. I should not have to put all this work into a well documented issue not only in the C6 but other models.
I own a 1998 Chevrolet Corvette. The EBCM can have an issue. Complains of traction control, ABS braking and AH active handling. This can cause issues when driving with no ABS active. I have seen numerous complaints about this issue here and on various forums. Unfortunately the part needed to correct the issue is no longer available and for some reason cannot be repaired. Used parts are costly (2K or more) and no guarantee they work. GM should provide replacement part or work around. If not available they should offer total car buy backs for a fare price depending on condition or offer an exchange for a corvette that can be repaired.
The service active handling and the traction control error is appearing on my cars instrument panel. Causing the cars ABS system to activate the front brakes while driving.This reaction causes the car to pull to the left, nearly causing an accident. It has random affected my car here recently. In that years that I have owned the car I have not had an issue. However, I see that this issue has been widely reported on this generation. Although I don’t see a recall for this issue. I do see that this is very dangerous. I feel lucky that this did not happen as I was traveling at a higher rate of speed or I probably would have wrecked the car.
Almost every C5 (1997-2004) Corvette is affected by a faulty electronic brake control module. When this module fails, the car illuminates the ABS and traction control light. And displays service abs and service traction control messages. This is a serious safety issue as when this happens, the abs brakes no longer work nor does the traction control. It blows my mind how this has never been recalled especially on a rear drive sports car.
My corvette as well as many others from 97-04 suffer from the active handling ABS/traction control system going bad. The part is known as the ebcm. When it goes bad (if cruise is engaged) the car will disable cruise control suddenly causing car to slow down. Also, when the system fails while moving it cause cause uneven brake feeling and you loose the ABS and traction control systems . Gm has discontinued the parts required to repair this and this issue has been major safety concerns for many years now affecting many 97-04 corvettes. Also a part of this system is the steeling wheel position sensor which is also discontinued. Swps can send wrong info to the other computers and the car will make erroneous 'corrections' that can lead to brakes being applied at any moment while driving.
The ebcm traction control module , ABS control modules and the steering wheel position sensor for the c5 corvettes made from 1997 thru 2000 are no longer manufactured by general motors or licensed to an after market manufacturer for production as an after market replacement. When these modules go bad there is a risk for accidents or death while driving as the ABS system that works in conjunction with these modules will lock up one or more of the brakes causing the driver to swerve into other lanes. This happened to me when my steering wheel position sensor failed. We corvette owners are forced to drive with the traction control off because we cannot find new replacement ebcm modules, ABS modules of steering wheel position sensors . Our only recourse is to buy a used unit from a totaled 1997 thru 2000 corvette at high prices and the are also defective at times according to corvette fprum members. General motors continues to license after market manufacturers to make replacement ebcm modules, afbs modules and steering wheel position sensors for corvettes manufactured in 2001 thru 2004 so why can't the license an after market auto part manufacturer to make these sensors for 1997 thru 2000 corvettes? Can the us government force gm to make these parts for the 1997 thru 2000 corvette due to fact that these parts are vital for the 1997 thru 2000 corvette to be safe on the road??
I experienced loss of control by skidding and almost leaving the road toward a dropoff while applying the brake since the ABS, active handling, traction control systems have been malfunctioning at 35mph on a mountain road applying the brake as I was going around a sharp curve I believe the cause of this malfunction of the ABS/ah system is a faulty ebcm which is known by countless members of the corvette owners community as a safety issue that should have been recalled a long time ago. If I would have known about this issue without an active recall I would not have bought the car. Several times this has happened in varied situations and I cannot rely on these safety features to save my life if something occurs that would send me out of control into another vehicle or over a steep cliff like in the close call I mentioned earlier in this text. Gm does not value my life as much as I do and this recall would have bankrupted them shortly after 2000. I'm sure there are hundreds of thousands of wrecked corvettes and loss of life due to this failure to recall them so they should be able to afford it 20 years later
Related recalls
Service brakes
- What is wrong
- General Motors LLC (GM) is recalling certain 2020 Chevrolet Corvette and Cadillac CT4, CT5 and XT4, 2021 Chevrolet Trailblazer, and 2020-2021 Buick Encore GX vehicles. Sensor connection contamination in the electronic brake boost system may cause an interruption of communication between the sensor and the brake boost system.
- Risk
- If communication with the sensor is interrupted, the electronic brake boost assist could be lost. Extra pedal force will be required to slow and stop the vehicle, increasing the risk of a crash.
- Remedy
- GM will notify owners, and dealers will replace the electronic brake boost module, free of charge. The recall began December 9, 2020. Owners may contact Chevrolet customer service at 1‑800‑630‑2438, Cadillac customer service at 1‑800‑333‑4223, or Buick customer service at 1‑800‑521‑7300. GM's number for this recall is A202307260.
Recall number 20V588000 · Recall details
Parking brake
- What is wrong
- General Motors LLC (GM) is recalling certain model year 2015 Chevrolet Corvette vehicles manufactured August 20, 2014, to September 4, 2014. In the affected vehicles, only one of the rear parking brake cables may be fully seated and engaged, resulting in the parking brake only operating on one of the rear park brake drums. Without the parking brake working on both rear wheels, the vehicle may roll away if parked on a steep gradient. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard No. 135, "Light Vehicle Brake Systems."
- Risk
- If the parking brake cable isn't fully seated and engaged on both of the rear park brake drums, the vehicle may roll away if parked on a steep gradient, increasing the risk of a crash.
- Remedy
- GM will notify owners, and dealers will inspect and correct the park brake cable installation, as necessary, free of charge. The recall began on October 31, 2014. Owners may contact Chevrolet customer service at 1‑800‑222‑1020. GM's number for this recall is 14620.
Recall number 14V568000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Certain passenger vehicles were produced with one or both rear brake hydraulic lines that can come in contact with or be affected by heat from the left engine exhaust manifold and the left exhaust pipe. The brake fluid could reach elevated temperatures and boil.
- Risk
- If the brake fluid boils in a rear brake line, the effectiveness of the rear brake system would be reduced which could result in a brake line leak and loss of brake fluid. If enough fluid leaks from the rear brake system so that brake pedal application can no longer build pressure to the rear brakes. The operator of the vehicle will experience limited braking which could result in a crash.
- Remedy
- Dealers will (1) inspect the left engine exhaust manifold clip for proper alignment and placement on the body-mounted stud. If incorrect, they will reposition the clip on the brake lines and reinstall the clip on the stud; (2) the dealer will verify that both rear brake lines have the proper clearance to the left exhaust pipe. They will reposition the lines by bending as necessary; (3) dealers will remove the machining tab from the rear differential housing. Also, dealers are to inspect the brake lines for wear in these related areas and repair or replace if there is any sign of wear-through on the nylon overcoating. The recall began on january 18, 2005. Owners should contact cadillac at 1‑866‑982‑2239 or chevrolet at 1‑800‑630‑2438.
Recall number 04V525000 · Recall details
Questions about the Chevrolet Corvette abs
Why does the abs come on in the Chevrolet Corvette?
Owners who report it most often also describe brake failure, headlights failing or too dim and multiple warning lights, and the codes they mention most are C1214 and P0101.
Which Chevrolet Corvette years have aBS light or ABS activating problems?
The model years with the most reports are 2000 (25 complaints), 1998 (13 complaints) and 2002 (13 complaints).
How much does it cost to fix ABS light or ABS activating on the Chevrolet Corvette?
Owners who mentioned a price put the repair at about $2,000 (median of 10 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used Chevrolet Corvette?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history