Chevrolet G10 recalls
There are 5 safety recalls on record for the Chevrolet G10, covering 56,219 vehicles in total across all the models in each campaign. Newest first.
Chevrolet G10 recalls by model year
All recalls
Service brakes, hydraulic: foundation components: disc: rotor
- What is wrong
- Vehicle description: light duty pickup trucks and multi-purpose passenger vehicles. One or both front brake rotor/hubs were built with an out-of-specification gray iron that can fail during the life of the vehicle.
- Risk
- If a driver continues to drive with a cracked rotor, the cracks could continue around the wheel mounting bolt circle and ultimately result in a wheel separation.
- Remedy
- Dealers will inspect the rotors for a core date of "287" and, if found, replace the rotor.
Recall number 98V033000 · Recall details
Steering: linkages
- What is wrong
- The steering linkage assemby contains a relay rod tapered-stud attachment nut that was not torqued to proper specifications.
- Risk
- The tapered stud can loosen and the driver would notice a lag in the responsiveness to steering wheel inputs. Eventually the relay rod stud can fracture resulting loss of steering control.
- Remedy
- Dealers will remove the existing crimped nut and install a new nut torqued to specifications.
Recall number 96V187000 · Recall details
Electrical system: wiring: fuses and circuit breakers
- What is wrong
- Water intrusion into the kick panel areas in front of both the driver and passenger doors can cause a corrosion path between the battery feed and the electrical ground.
- Risk
- This condition can cause an electrical short leading to ignition and combusion of the plastics in the electrical components of the vehicle resulting in a vehicle fire.
- Remedy
- Dealers will replace the 25 amp circuit breakers with 25 amp fuses in the fuse block; remove a temporary paper fuse-block cover; install a plastic shield over the fuse block; replace and reorient the power door lock relay (if equipped); inspect the remote keyless entry module (if equipped) for signs of corrosion, replace if corroded, and reorient it; and apply additional body sealer in key areas.
Recall number 96V186000 · Recall details
Service brakes, hydraulic: power assist
- What is wrong
- The brake pedal assembly has a pushrod pin that is too small and it is installed in the wrong position, causing an increased brake pedal ratio and a decreased master cylinder stroke.
- Risk
- The reduced master cylinder stroke results in failure tomeet the partial system failure requirements of fmvss 105, "hydraulic brakesystems". A further reduction in braking ability at a time when partial systemfailure has occurred could result in a vehicle crash.
- Remedy
- Replace the brake assembly.
Recall number 92V127000 · Recall details
Seats
- What is wrong
- Seat back of the rear bench seat may break away from the seat cushion in an accident.
- Risk
- Seat occupant would be subject to greater injury; vehiclewould not comply with fmvss 207.
- Remedy
- Install reinforcement that runs from side of seat back frame assembly to seat cushion frame assembly, strengthening the seat back.
Recall number 91V040000 · Recall details
Questions about the Chevrolet G10 recalls
How do I check if my Chevrolet G10 has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the Chevrolet G10 have?
5, covering service brakes, hydraulic, steering and electrical system.
VIN decoder
See the problems and recalls for an exact car
Buying a used Chevrolet G10?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history