Anti-lock brake module failed.
1993 Chevrolet S10 brakes complaints
Page 4 of 6: complaints 71 to 100 of 140, newest first, as owners wrote them.
When applying the brakes they slip before fully stopping the car.
Ea94-038, the defective ABS system malfunctioned when pressing the brake pedal, causing extended stopping distance. Dealer cannot determine problem.
When driver makes a panic stop the truck pulls to the right. This only happens when the ABS brakes kick in . When applying the regular brakes, the truck does not pull.
While applying the ABS brakes at 35mph, the brake pedal would go to the floor. This would cause an extended stopping distance for the vehicle.
Abs brake system failed, causing an accident.
Often times when brakes are applied the pedal goes to the floor and the vehicle keeps on going. The dealer has replaced the master cylinder on the vehicle.
When applying the brakes, the ABS brakes are subjected to an intermittent failure which causes the vehicle to have extended stopping distance.
Brakes are very sp0ngy. When making an emergency stop the brakes go all the way to the floor, and the vehicle keeps on going, making a loud noise. The dealer has been notified. *ak dealer has flushed brake system, serviced rear brakes, adjusted rear brakes, and freed up calipers, however problem still occurs, consumer has received recall regarding the ABS electronic modular, however dealer stated recall repair was not necessary, consumer is wondering why he has spent $1452.92 in brake repairs since 1996 if there is nothing wrong the brake system.
When the driver applied the brakes the pedal went to the floor, and the driver had to stand on the brakes to get the truck to stop. Dealer has readjusted number of times. The dealer states that they will not fix the brakes under warranty anymore.
Ea94-038; upon making a sudden stop noticed a loud noise coming from under the hood. Pedal traveled to the floorboard, resulting in extended stopping distance and brake fade away. Consumer has contacted the dealer, dealer unable to determine the problem.
Brake pedal goes to the floor with truck responding poorly to pedal application pressure. Please describe details.
Brakes: driving approximately 20mph in dry conditions applied brakes and there were no brakes. Waited a few seconds and tried again and the brakes worked fine. Have not had any problems since.
When applying the ABS brakes the pedal will travel to the floor, causing extended stopping distance. Please give any further details.
Almost has to apply both feet to the brake pedal. To apply the brakes at high speeds, it takes alot of pressure to apply the brakes.
Applied brakes while backing out of parking lot. Anti- lock brakes shut down, vehicle went into skid, wet on pavement. Computer check showed motor relay pump had gone out.
Ea 94-038, while driving at 10 MPH, the defective ABS system failed without warning, causing the pedal to touch the floor, and making a grinding noise in which the vehicle did not stop and caused an accident.
Vehicle equipped with ABS brakes, had no brake power at all causing vehicle to run into gaurd rail, resulting in injury. Dealer told owner it was the ABS module which he is replacing.
When applying the ABS brakes the pedal will travel to the floor, causing extended stoppping distance resulting in an accident. Please give further details.
Brakes lock up and start sliding in rain or snow. On bumpy highyway brakes will lock up. Has not taken to a dealer for repair because they say there was nothing wrong with it when it was checked in 1993.
When applying the ABS brakes on wet or dry pavement they failed, causing extended stopping distance. Mechanic states that the rear brakes may need adjusting or the slides on the disc caliper may need service. Please add further details.
When applying the ABS brakes, the brakes failed.
Antilock brakes failed 3 times, once resulting in loss of control.
While driving experienced ABS failure, on wet pavement brakes tend to lock up from stop to start position, brakes grab, then cause vehicle to skid, result, near accidents.
When applying the ABS brakes at speed of10- 25 MPH during wet conditions the vehicle's right front brakes locked up.
Abs brakes failed, causing vehicle to lose control, resulting in a crash.
While driving in wet or dry weather ABS brakes did not work , had no braking power, the owner ran into a ditch.
# ea94-038, in wet or dry weather the rear anti-lock brakes lock up *ak consumer states rear brakes lock up with the slightest touch of the brake pedal, consumer contacted manufacturer and was referred to nearest dealer, consumer states he has has 8-10 different dealers look at brakes and was told they either need to be adjusted or replaced, and was then told they don't need to be adjusted the readjust on their own, consumer was also told they have no idea what the problem is.
Vehicle fire caused by an electrical short in the alternator wiring; also ABS brakes failed.
Brakes failed, causing accident/injury.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1993 Chevrolet S10?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history