While driving vehicle about 25 MPH the consumer tried to step on the brakes, but didn't have any brakes. The pedal went all way to the floor. Then he tried again and they worked.
1994 Chevrolet S10 brakes complaints
Page 9 of 19: complaints 221 to 250 of 532, newest first, as owners wrote them.
While driving the truck applied the brakes and the brakes seem like they shut off, and that caused the driver to hit another vehicle.
Brakes failed, causing accident.
Anti-lock brakes failed.
Ea94038; in wet conditions the ABS braking system malfunctioned, causing the brake pedal to fade/extended stopping distance, increasing a risk of an accident. *ak dealer has replaced pads, shoes, calipers, and has resurfaced rotors, problem still exists.
Intermittently when the brakes are applied the pedal goes to the floor , the vehicle makes a loud noise and the vehicle will not stop. The owner has had the brakes replaced 4 times by the dealer.
Intermittently when the brakes are applied it took longer than normal for the ABS to engage. The dealer will be notified.
When brakes are applied the brake pedal would go to the floor and the vehicle would continue to roll. Also the brakes grind. The dealer has replaced the front brakes on the vehicle.
Brakes failed.
Abs brake system has failed numerous times.
Brakes failed.
Anti-lock brakes failed, pedal went to the floor without stopping vehicle.
Ea94-038:while driving at approx 40 MPH applies brakes for quick stop for about3-5 sec no brakes,this usually happens in wet conditions, sometimes hears noise. Dealership cannot find problem. Consumer changed rotors/rear wheel cylinder to larger sizes. Seems to be working better, does not have defect that often as before. Consumer states cheap grade of brakes works better because it's softer and not made of metal. *ak consumer states that antilock brakes engage, but vehicle does not stop.
When brakes are applied , the pedal goes to the floor vehicle has inadequate stopping power. Dealer notified. *ak consumer states that the ABS are not working.
Consumer noticed the brake warning light on. He went to apply the brakes , the pedal went to the floor and the vehicle did not stop. The dealer replaced the brake modulator. *ak consumer states after repair, there was still a soft brake pedal, so dealer replaced the left front wheel speed sensor, failure occurred again and dealer replaced master cylinder at no cost to consumer, a week later same failure occurred and now consumer refuses to drive vehicle, dealer checked the ABS modulator and stated that it was no good.
Brakes lock up at low speeds on wet pavement , the brake pedal goes to the floor at high speeds, and the vehicle does not stop in a reasonable amount of time. *ak dealer retorqued spindle unit and bleed brakes, problem has reoccurred since.
Abs brakes are subject to intermittent failure, causing entended stopping distance. When brakes are applied the pedal goes to the floor and the truck does not stop.
When driving in damp weather the brakes do not work when first applied.
Abs brakes sometimes fade/make a roaring noise.
Failure of the ABS brake system.
In wet conditions the defective ABS braking system malfunctioned when applying the brakes. The front right side vehicle locked up and slides, causing extended stopping distance. Dealer cannot determine problem.
When applying brakes, pedal sometimes goes to floor with no braking effect, sometimes makes loud grinding noise followed by no braking effect, wet/dry surface, various speeds; an independent dealer replaced front brake pads & rear brake shoes, problem still exists.
Abs brakes lock up/vehicle takes a long time to stop.
When it is raining or snowing and have to apply the brakes in a sudden stop the brakes will lock up, and the truck will get going. When this happens the steering locks up, and there is no control in the steering wheel. This only happens when it is wet out side. This has been an on going problem since 96.
When applying ABS brakes in a panic stop, vehicle had an extended stopping distance, causing an accident. Cause unknown. *ak
When making a sudden stop the vehicle will not stop . Owner states that when he pumps the brakes they will. The dealer has not been notified.
When brakes are applied at low speeds the brakes will not stop upon impact. The dealer has been notified.
Anti-lock braking system not reliable to stop vehicle each time brakes are applied. Pedal intermittently goes to floor, causing extended stopping distance; near causing crash. Mostly on wet pavement. Not checked by dealer as yet. Vehicle available for inspection.
Under normal weather conditions brakes were applied , ABS engaged and vehicle failed to stop. The dealer was unable to duplicate the problem. The dealer put a new set of brake lines on the rear.
When applying the ABS brakes in a sudden stop, the pedal is going to the floor and there is an extended stopping distance. Please describe details.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 Chevrolet S10?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history