Lower ball joint, lower control arm, one side (b) had to be replaced, along with tire (other front tire previously replaced for irregular wear); problem found upon yearly state inspection.
2000 Chevrolet S10 suspension complaints
Page 2 of 2: complaints 11 to 19 of 19, newest first, as owners wrote them.
The front wheel bearings in my 2000 s-10 4x4 keep going out. The dealer has replaced the right and left bearings before the warranty ran out and I've replaced the right twice and the left once myself.
Consumer states that while driving and no warning the stabilizer bar snap causing the consumer to lose steering control and was force to pull over. Dealer notified ts
Vehicle would wobble / vibrate when driving 30 or more MPH. Dealer was not notified at this time. Feel free to provide any further information.
Left front wheel bearing had to be replaced due to excessive wears. Dealer contacted . Feel free to provide any further information.
Lower ball joint was replaced at 38,000 miles. Currently, problem has reoccurred. Dealer notifed. Feel free to provide any further information.
Premature failure of left front wheel bearing. Replacement of expensive bearing/hub assembly required.
Left and right lower ball joints were very loose causing excessive tire wear. Yh
No summary listed for above vehicle.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2000 Chevrolet S10?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history