2006 Chevrolet Silverado 2500: ABS light or ABS activating

Filed Sep 26, 2016 · Brakes · 49,952 miles · NY

When normal stopping ABS activates and keeps activating until pedal goes to floor and brakes do no function, there are no warning lites and no indication of a problem.I was under the impression that any ABS failure would revert system to regular brake system. This is very dangerous.

Filed Nov 19, 2014 · Brakes · 41,200 miles · IN

Brake lines have rusted out. Abs warning light came on, then soon after ABS service light came on. Had to replace all of the lines and 3 calipers where lines had rusted to the caliper. Vehicle only has 41200 miles on it. Cost me $861 to have them replaced. Service technician said he had never seen lines that were that bad for a vehicle with such low mileage. One of the lines crumbled at the touch when it was removed.

Filed Jan 18, 2014 · Brakes · 52,500 miles · NC · crash

I was preparing to slow down as I approached my driveway. When I applied my vehicle's brakes, the brake pedal went completely to the floor. My vehicle did not slow down and I had to utilize me emergency brake and also shift into a lower gear in order to slow down. I was unable to slow down enough to safely make a turn and subsequently my vehicle travelled thru a ditch area and came to a stop in my front yard. Completing a check of my vehicle's brake system, I learned that my master cylinder was completely empty. I had my vehicle towed to a local garage where I was told the vehicle's complete braking system lines had rusted away causing all brake fluid loss and needed to be replaced. All brakes lines were replaced from the master cylinder to the ABS module and then to each brake system at the wheel. The cost of the work was $598.00. My vehicle is a 2006 model year and is in excellent shape, however I'm very unhappy with the braking fluid lines failing with only 52,500 miles on my vehicle. I don't understand why there has been no safety recall notice on the part of general motors. The local dealership refused to assist me with the matter and at this time I'm completing this complaint. The national highway transportation safety administration needs to take immediate action upon general motors to ensure higher quality of brake lines are installed instead of substandard brake lines. I was lucky that I was not involved in a more serious accident/incident with the brakes failing. I would also like to see general motors reimburse me in full for the cost of the repairs.

Filed Jul 21, 2013 · Brakes · 63,000 miles · NY

Towing trailer, while parking trailer, brake pedal got spongy, then went to floor, total brake loss. Rusted brake line ruptured under drivers seat by ABS module, all brake lines will need replacement.

Filed Oct 31, 2012 · Brakes · 30,000 miles · WV

When coming to a stop a speeds of 10 MPH or less, brake pedal goes towards the floor as if the ABS is activating, causing loss of braking. It occurs on all types of driving surfaces and in all weather conditions. Problem has gotten worse with time. Dealership says there is no known problem... However the internet says differently! Problem occurs almost every time you are making a slow approach to a stop, which is usually when other vehicles or pedestrians are in front of you.

Filed Nov 30, 2011 · Brakes · 67,576 miles · NY

Vehicle almost hit garage due to pulsing of brakes during dry stop. An inspection revealed fluid leakage at the ABS module under the cab. Brake lines appear severely pitted and corroded.

Filed Oct 23, 2011 · Brakes · 78,000 miles · OH

When coming to a stop, at speeds of less than 5mph, the brake pedal goes to the floor as if the ABS is activating. This happens on smooth dry pavement. Taken to several mechanics and dealers and everyone says everything is working the way it should. I've heard of other owners of this make/model experiencing the same problems. Whenever I let someone else drive my truck, I make sure I stress that it will not stop when it should, so far no wrecks. [xxx] information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).

Filed Jun 30, 2011 · Brakes · 80,000 miles · NY

The ABS on my 2006 silverado activates on low speed stops on dry pavement causing the brakes to release. It is not the typical ABS action that most people are familiar with, where the brakes release and apply - it is the brakes releasing and not reapplying under pressure, while foot is on brake. I have gone through an intersection while towing a horse trailer and had many near-miss incidents coming into toll booths, stop signs and red lights. Have almost rear-ended vehicles because of this. This needs to be a recall item. It is dangerous, very expensive to fix and prone to happen again once fixed.

Filed May 17, 2011 · Brakes · 45,000 miles · ME

Tl* the contact owns a 2006 chevrolet silverado 2500. The contact was driving approximately 5 MPH and as the brakes were appplied, the ABS activated abnormally. The vehicle continued to accelerate and after applying the brakes numerous times, the vehicle eventually slowed down. The failure only recurred when driving 10 MPH or less. The vehicle was taken to an authorized dealer where they advised that there was not a recall pertaining to the brakes. The vehicle was in the process of being repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 45,000.

Filed Apr 7, 2011 · Brakes · 30,600 miles · MA

Abs activation at slow speeds preventing stopping of vehicle. Dealer and gm refused to participate in repair, stated the sensors were contaminated from rust and therefore not defective, the problem is environmental and we cannot assist you with the repair.. There is no ABS warning light coming on and this is identical to the problem found on earlier models 1999-2002 which were recalled. I was told I need to replace the front wheel speed sensors @ a cost of 460.00 dollars to correct the problem. This happens almost every time the vehicle comes to a stop causing it to surge forward, it will cause a collision..

Filed Feb 1, 2011 · Acceleration, Brakes · 60,000 miles · 00

I have a 2006 chevrolet silverado 2500 hd four wheel drive that is not stopping properly at low speeds. The ABS system is letting go at slow speeds causing the brakes to let go. This could be a very serious situation at a crosswalk with children. I reported the problem at the local dealer and they said it was a common occurrence due to rust affecting the ABS brake sensors. The cost of the sensors was 135.00 each plus about three hours labor total close to $600.00. I think this should be a recall issue as it is not caused by wear.

Filed Oct 6, 2010 · Brakes · 20,000 miles · PA

Tl* the contact owns a 2006 chevrolet silverado 2500. The contact stated that when the brake was applied, the ABS activated, causing the brake pedal to fade. The contact called the dealer who stated that defective brake sensors were the cause of the failure. The contact called the manufacturer and filed a complaint; he was informed that they would call him back and to take the vehicle to the dealer. The vehicle had not been repaired. The failure mileage was approximately 20,000 and the current mileage was approximately 22,000. Updated 12/23/10*lj updated 01/04/11