Driver side door latch broke twice, tail gate latch broke twice, hazzard light defective, ABS brake light signal kept coming on
1995 Chevrolet Silverado brakes complaints
Page 2 of 2: complaints 11 to 29 of 29, newest first, as owners wrote them.
As it turns out my other gmc car (olds alero) ABS is also inoperative at 40k miles. Gmc may have a bigger problem.
Abs system malfunctions causing vehicle pulling while braking . Yh
The brakes pads failed at 35,000 miles, dealer would not replace, we did and have not had to again now at 84,000 miles, air conditioner relay sensor switch went bad, we paid to have replaced, windshield wipers do not come on half the time, nor does the horn does not work half the time.
Intermittently when brakes are applied on wet and slippery surfaces front wheels lock up, resulting in extended stopping distance.
Abs light illuminated, inspection did not show any problems, however vehicle accident occurred when ABS locked up. Mjs
Master cylinder is defective. Master cylinder controls brakes at this time, and it leaking brakes fluid, also, the seat frame is breaking on driver's side,and voltage gauge is not working.
Brakes making noise in rear, an axle also replaced. Nlm
When applying the brakes rear end of the vehicle jumps. Dealer has replaced rear brakes 4 times, and the front brakes have been replaced twice a year. Dlr can't find cause of the problem.
Transmission locked up in second gear and would not shift out of gear up or down. Also, ABS brake system has a defect in the system, causing extended stopping distance when pedal is pushed. In addition, A/C unit replaced three times/ electric seat wiring is defective/ door handles keep bending when attempting to open doors, and rear seal leakage. Repair work and replacements done at owner's expense. Problems still occur. Provide further information.
Vehicle is decelerating when put in drive. When going around a sharp curb at 20 MPH the vehicle will die out without prior warning. Also, power brakes went out, and the consumer almost had an accident.
Steering wheel would shimmy when brakes are applied. Dealer/manufacturer are not notified at this time.
When applying the brakes the pedal goes to the floor and vehicle does not stop. Dealer said it was master cylinder, problem still exists.
Abs brakes failed, pedal went to the floor, causing extended stopping distance, resulting in rear end collision. Also, replace master cylinder.
When brakes are applied the pedal will intermittently go down to the floor, not stopping the vehicle.
At 25,000 miles replaced pads/rotors, then again 40,000miles within two weeks. Later, same defect occurred again. This time changed rotors pads/calpiers. Still defect is occurring. Hears griniding noise, usually left front wheel goes out. Dealership final analysis, cannot find problem. This defect is a potential for an accident.
When brakes are faulty has to stop in advance or come down on brakes hard. The dealer has repaired the braking system on vehicle.
Coming upon stop sign & started to apply brakes; could feel brakes pulsing. Vehicle started to shake & then brakes locked up or grabbed. This happens to front brakes only. Took to dealer & could not find anything wrong. Been happening for over a year.
While driving at about 40 MPH vehicle was involved in an accident. The airbags did not deploy, the brakes and the steering wheel locked up , causing the vehicle to spin out of control.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 Chevrolet Silverado?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history