Rusted brake line resulting in total brake failure while driving and attempting to stop
2006 Chevrolet Silverado brakes problems
101 complaints (55% of all complaints for this car). Typical mileage when it fails: 60,500. 2 crashes reported.
- owner complaints
- 101
- of this car's complaints
- 55%
- typical mileage
- 60,500
- crashes
- 2
- recalls
- 0
Which part fails
- Antilock/traction control/electronic limited slip4
- Foundation components: hoses, lines/piping, and fittings3
- Foundation components: disc: rotor1
At what mileage
Complaints by mileage at the time of the problem.
Chevrolet Silverado brakes problems in other years
Specific symptoms reported on the 2006 Chevrolet Silverado brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
No recalls on record for this model year.
What 2006 Chevrolet Silverado owners say
Most recent owner complaints, unedited.
Tl* the contact owns a 2006 chevrolet silverado. While driving 35 MPH and attempting to decrease in speed, the brake pedal traveled to the floorboard and failed to stop the vehicle. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was 86,642.
This vehicle has had multiple brake issues since new. First off, it goes through front brake pads and rotors too frequently. First replaced around 25k and again around 60k. This vehicle has mostly been used for long highway trips, ny to fl etc., not around town. Used in rural area. Next, several brakes lines have burst and had to be replaced. The last incident luckily was in my driveway. Having dual brake cylinders on these trucks does not seem to help if a brake line bursts. I needed the emergency brake to stop it on almost flat ground. A recurring problem is with the ABS. Evidently they rust easily, especially in salt belt states, then corrosion on the sensor and hub causes it to activate for no reason. It does not activate the computer control or give warning. It happens intermittently. I had to have one front hub replaced in 2013 and another in 2014. Now I am having to replace one of those again with the dealer recommending to replace both. The cost is over $750 per side. There were recalls on previous year models but not 2006. This is ridiculous and the brake line issue has been going on with chevrolet for a very long time. I had to replace most lines on my 1996 silverado. I can't believe that nhsta allows this to go on year after year. Nothing is more important than braking, nothing!
My vehicle with 57,000 miles had the brakes go out while driving without warning. I took it to a mechanic who said the front brake lines had rusted and broke. I have had the work completed. I feel this is a product defect for a low mileage vehicle. It is very well taken care of and has very few miles on it, and I have owned it since it was new. I have been in contact with chevrolet and they will not provide me with any answers. They keep telling me to take it to a dealership, however the dealership has told me there is nothing they can do.
While approaching a traffic signal my brake pedal went all the way to the floor. I drove my vehicle slowly home and checked brake fluid level. It was low and I topped it off. I tried the brakes again and once again the pedal went to floor. I went under the vehicle and brake fluid was dripping off the cross member just behind the engine. I could see that all the brake lines were very rusty. I was able to get the vehicle to big o tires. After inspection, it was found that the brake line had rusted through and all the others were in very bad shape and I had all the lines replaced. After some research I found this was a known problem and gm has redesigned the lines but, refused to recall and replace the lines. You need to research this problem further and insist on a recall before someone is killed. I am the original owner and as indicated by the mileage the vehicle is not driven that much and very well taken care of.
Tl* the contact owns a 2006 chevrolet silverado. While the vehicle was coming to a stop, the anti-brake system engaged independently and caused the brakes to fail. The failure recurred intermittently. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 9,000.
I was driving the truck away from my home , when I steped on the brake pedal it went to the floor. I got the truck stopped with the parking brake. When I inspected the brake lines they were all extremely rusty and one had burst. Fluid leaked out and there was no pedal at all. The brakes were gone with no warning.
Traveling 60 MPH on the highway and approached a red traffic light. Applied the brakes to stop with other traffic. Brake pedal went completely to the floor with approximately 10% braking power. No warning lights on dash. Fortunately the traffic light turned green and traffic moved prior to a crash. Crash was guaranteed if traffic light had not changed. Brake fluid level fine. Brake line under drivers side rusted and burst. No warning signs.
While applying breaks on dry surfaces and coming to a stop the ABS kicks in and pedal goes to the floor. This causes the stopping distance to increase. I have almost rear-ended stopped and parked cars and ran into my garage door. There have been to many close calls so I have pulled the fuse to shut off the ABS.
While traveling on the expressway in my 2006 chevrolet silverado with 26,000 miles on the odometer, I attempted a transient lane change while taking evasive action in order to avoid a hazardous situation. When coupled with the brakes I noticed longer than usual engagement. As a result, I was forced onto the shoulder and had to use multiple downshifts in concert with the emergency brake to bring the vehicle to a halt. It sounded like a train stopping on rails. I proceeded to drive home with hazards on,u never exceeding third gear. The following morning I noticed clear oil underneath the front end of the vehicle. I believe this is an extremely dangerous vehicle and a less experienced driver would have been killed or extremely injured. Lastly, I have also been noticing inconsistency with steering resistance. Sometimes the steering is considerably looser than at other times. I have dismissed this disconcerting sensation by assuming it is weather/humidity related.
Questions about the 2006 Chevrolet Silverado brakes
Does the 2006 Chevrolet Silverado have brakes problems?
Owners have filed 101 complaints about the brakes of the 2006 Chevrolet Silverado, 55% of all its complaints, more than any other problem.
At what mileage do 2006 Chevrolet Silverado brakes problems start?
The typical (median) mileage in owner complaints is 60,500 miles.
Was there a recall on the 2006 Chevrolet Silverado brakes?
There is no recall for this problem on this model year.
What year does the Chevrolet Silverado have bad brakes?
The Chevrolet Silverado model years with the most brakes complaints are 1999 (1,003 complaints), 2000 (607 complaints) and 2001 (418 complaints).
Other 2006 Chevrolet Silverado problems
Suspension 15Electrical 14Airbags 11Engine 10Steering 9Tires 9Fuel system 8Transmission 8Body 6Wheels 6Lights 5Visibility 5Seats 4Seat belts 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2006 Chevrolet Silverado?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history