2000 Chevrolet Tracker body problems

Filed Aug 18, 2014 · Body, Suspension · 107,000 miles · IN

Frame has rusted through serious safety issue where tire is about to sink in.

Filed Jun 12, 2012 · Body, Steering · 85,000 miles · OH

Front suspension cross-member of my 2000 chevrolet tracker has corroded through the heavy gauge metal adjacent to a support bolt and risks affecting the structural integrity of the vehicle. This is a heavy gauge structural member that should not have rusted through. Severe rust-through is the result of improper metal surface treatment by the manufacturer and needs to be recalled. Please force the manufacturer to address this safety-of-life issue on these vehicles as a catastrophic collapse of this component, if it occurs during driving, results in wheel collapse because this member supports the wheels a-frame. I estimate this rusting has been ongoing since 2009 even though I just saw it in 2012. I base this on the fact that in 2012 there was a hole rusted through the cross member that I could fit my thumb through however, holes of this size usually take a few years to develop and I never noticed it previously. This means that sub-surface rusting was occurring for a few years with surface rust obscuring this, which explains why the hole was not visible until just recently (when the surface rust collapsed, it exposed the hole beneath it).

Filed Jul 22, 2011 · Body · 98,657 miles · WV

I bought a 2000 chevy tracker off a use car lot about two months ago we test drove it and it done fine untill about a month ago my wife was driving my grand daughter to her practice and the left front tire started a voilent wobble so I looked under the front end and descovered that the sub frame cross member on the left side had rusted and collapsed inside its self and it has done it a few times after that and the only way to stop it is to put on the brakes and go under 30 MPH and thats dangerous when cars are right behind you I just waiting for a wreck so I started researching about the tracker and it appears that the cross member rusting is a defect problem and ive tried to find one to do the repairs myself if I could I think chevy company sould have to address this problem being it was a defect no matter when you purchased the vehical or missed the recall if any because its still a on going hazzard that could get someone killed or injured the used car lot was probley aware of the problem but any how I was just wondering if anything can be done except the obvious fix myself. Thank you.

Filed Apr 22, 2011 · Body · 85,000 miles · NC

Refer to special extended coverage 06186 for 2000 chevrolet tracker, front crossmember rusting out causing wheels to shake and make vehicle difficult to control.

Filed Dec 18, 2010 · Body, Suspension · 100,000 miles · IN

I was backing up down a short lane of 25 feet or less. I heard a loud popping sound. I then pulled out onto a major highway (us-41). I traveled approximately 1 mile, coming upon a stoplight, the light turned red, upon applying my brakes, the vehicle suddenly pulled drastically to the left, at which time the right brakes locked up, the left brakes, did not work at all. I proceeded very cautiously home ( a trip of 15 miles). At which time I took the vehicle to my mechanic, after his evaluation of the vehicle, and a very brief road trip, informed me of "something he has never seen in his 25 years of being a mechanic) the crossmember that supports the upper and lower control arm was rusted thru. This caused the erratic steering, and the loss of ability to control the vehicle during a braking situation.this vehicle does have a recall (06186) but I was never notified! I have owned this vehicle since it was new, if I was notified, I would have definitely had it checked, since it is a vehicle my wife drives during the winter. General motors should notify owners of this vehicle about this problem it is dangerous........no questions.

Filed Feb 23, 2010 · Body, Suspension · 109,000 miles · WV

2000 chevrolet tracker hard top corroded suspension front cross member, noticed the steering was not right when I would tap the brake-pulled to the left--had it checked and the 2 front cross members were completely rusted out and hanging down! I called gmc and they refused to help saying its not been reported and I had too many miles on my car, 109,000. I researched the internet and gmc has fixed this problem on vehicles over 150,000 miles under special circumstances-safety issue. I also found recalls on same vehicle-but soft top not hard tops. I want them to fix my vehicle because this is a safety issue and this tracker is barely 10 years old. Gmc knows about this, I have saw where this has been investigated in 2007 by you, and if not fixed someone could seriously get hurt!

Filed Jan 20, 2010 · Body, Suspension · 86,000 miles · PA

Tl*the contact owns a 2000 chevrolet tracker. While driving 45 MPH the contact heard a noise and the vehicle pulled to the right. The contact was able to continue driving the vehicle; however, the driver found rust on the front cross member and it was broken. The a-arm has began to separate from the cross members. The dealer confirmed that the VIN was not included in the recall. The contact stated that he was responsible for ordering the bolts needed to repair the vehicle. The failure mileage was 86,000. Updated 02/17/10. *lj the consumer stated it was discovered that his vehicle was included in the recall and the dealer repaired the vehicle free of charge. Updated 02/18/10

Filed Mar 17, 2008 · Body, Visibility · 120,000 miles · MA

3/17/08 to: general motors, chevrolet (customer complaint ? Recall), the federal safety agency *my customer complaint (chevrolet tracker):* -late last year, my wife had received the gm letter. -I took the vehicle to the dealership, in dec. 2007 to ragsdale chevrolet in spencer, ma. -ragsdale?s technician put the car on the lift and inspected the car. -they said that the crossmember was ok, that the crossmember would not be replaced by chevrolet until there were actual holes in the crossmember (why??). -on 3/12/08, I was driving the vehicle, and when I applied the brakes, the car was pulling severely to one side. -that evening, I looked under the car and the passenger side suspension attachment (?a? Arm) to the crossmember was only partially attached due to severe corrosion (several large rusted-through holes) at that area of the crossmember. -I called ragsdale and returned the car to their service dept. Mgr. (glenn) on 3/13/08. On the trip to ragsdale, the car?s body flexed so much when braking, that the windshield developed a crack. -I told glenn about the windshield crack and he said that ragsdale would not do anything for me on the windshield replacement, to take it up with chevrolet, and my auto insurance would take care of it (basically, lacking any customer service skills). -I asked glenn how ragsdale?s inspection _only three months prior_ did not show a problem, yet there was major corrosion now. Glenn said that ragsdale had the same problem of another tracker that was inspected by them in october 2007. -glenn offered _no_ apology for ragsdale service personnel not adequately performing the december inspection. I am very displeased by ragsdale?s poor service last december; there could have been a very serious accident due to ragsdale?s inadequate inspection of the crossmember. There appears to be _no_ oversight of this service department performing serious safety inspections that were mandated by chevy..

Filed Jan 16, 2008 · Body · NH

Took 2000 chevy tracker to my regular mechanic to check for rust/corrosion and possible crossmember rusting. He found more than that, not only the crossmember but just about the entire underframe of the automobile. Gm dealer will honor recall from gm however they tell me I need to spend about an extra 1500 for them to repair the crossmember extensive corrosion. And there is more rusting of this automobile. Even if I spent 2-3k on repairs of rust, the rest of the frame is rusting. And I still owe on this car. I do not feel safe in this auto, afraid the frames will break when traveling over frost heaves or any highway. Gm needs to take responsibility for this inferior auto.

Filed Nov 2, 2007 · Body, Suspension · WI

The front crossmember is horribly rusted. The previous owner(s) looked to have welded extra support to the area that the crossmember attaches to the control arm. I originally thought the previous owner hit something, but upon closer inspection there is no damage as the result of a collision. I just noticed this today, and do not at all feel safe driving anywhere until this is fixed. A 7 year old vehicle should not be rusting frame parts off!!