2018 Chevrolet Volt electrical problems

Filed Nov 2, 2026 · Electrical, Engine · UT

My 2018 Chevy Volt is experiencing the EXACT same symptoms as GM's Battery Energy Control Module (BECM) Warranty Extension Program N232432680 AND Program N202307990 AND TSB 19-NA-206. My vehicle falls within the guidlines of affected vehicles, yet GM will not honor their program specifications. My vehicle has stalled while driving on the highway, not started, reduced power, and will not charge or depletes a full charge within 30 minutes. I stalled while driving 75 mph on a freeway. My car also would not allow me to shift into park while returning home, then tells me to shift into park when I am trying to tleave for work. GM tells me that "Your VIN does not fall within the repair requirements, even though your vehicle exeriences everything taking place and meets the standard requirements." The dealership tells me that I have to take it up with GM. I have children I drive to school, I drive to work, and I do not think that something of this nature, with the EXACT SAME symptoms that GM claims is happening, with the EXACT SAME codes related to the issue, with very possible safety issues being experienced should be overlooked. This has been happening for months, and I have been trying to explain to GM and the service department at the dealership what is going on, they have proof of what is going on, but I do not qualify because of my VIN even though, as stated by GM, "This specific program extends coverage to 15 years or 150,000 miles regardless of whether your specific VIN shows an active safety recall."

Filed Oct 27, 2026 · Electrical, Fuel system · WI

My 2018 Chevrolet Volt LT (VIN [XXX]) suffered a Battery Energy Control Module (BECM) failure at 142,185 miles. Gandrud Chevrolet in [XXX], diagnosed the failure, citing GM Technical Service Bulletin 18-NA-261 and diagnostic codes U2619, U2620, U2621, U2622, U2623 and U2624. The dealer replaced the BECM (part 24296900), programmed it, and performed associated work. The repair was completed XXX. The invoice was $3,160.70; I am seeking $3,066.25 in reimbursement for the qualifying repair expenses. GM denied coverage because my VIN is excluded from Special Coverage XXX, despite the dealership-confirmed BECM failure. I pursued the matter through GM Customer Assistance (case 106790207), mediation (case XXX), and Wisconsin DATCP (case XXX). GM maintained that the special coverage does not apply to my VIN. the federal safety agency previously investigated BECM failures under PE23022. However, owners continue to report similar problems in 2026, including reduced propulsion, inability to drive or restart, charging failures, and reported BECM failures. I ask the federal safety agency to review these 2026 complaint records alongside mine: XXX A sudden loss of propulsion can leave a vehicle unable to maintain speed or move safely with traffic, creating a potential crash risk. I am concerned that VIN-based coverage exclusions may leave vehicles susceptible to the same failure without an effective remedy. Please review these reports collectively, reassess whether the current coverage captures the affected vehicles, and determine whether further investigation, expanded coverage, or a safety recall is warranted. I can provide my repair invoice, diagnostic documentation, and GM’s written denial. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Oct 24, 2026 · Electrical, Fuel system · UT

While driving through a canyon to get home, my check engine light came on and I saw the message "Propulsion Power Reduced" on my dash. The speed limit on that road is 65 mph, and I lost power going up a hill and went from 65 mph on cruise control to 48 mph. There are a lot of cars on that road, and it could've caused a serious accident. My vehicle does exactly what the GM extended coverage describes and is within the parameters, but somehow my vehicle does not qualify. This could've been bad on that road is it was raining or snowing.

Filed Sep 25, 2026 · Electrical, Fuel system · OH

FAILURE SUMMARY & SAFETY RISK: While operating in live traffic, the vehicle experienced a sudden loss of motive power and entered a "Propulsion Power Reduced" failsafe mode, creating a severe rear-end collision hazard. The vehicle is currently grounded and remains available for inspection upon request. WARNING SYMPTOMS & DIAGNOSTIC CODES: The instrument cluster illuminated the Malfunction Indicator Lamp (Check Engine), the ABS warning indicator, and displayed a persistent "Propulsion Power Is Reduced" message. A diagnostic trouble scan confirmed active high-voltage communication failures and powertrain faults: U2603 (Lost Communication with Hybrid/EV Battery Interface Control Module), P25A2 (Brake System Control Module Requested MIL), and ABS code C0500-00. PRIOR HISTORY & FAILURE TO CURE: This identical high-voltage Battery Energy Control Module (BECM) failure previously occurred in December 2025 at 97,808 miles and was presented to an authorized Chevrolet dealership for repair. The facility claimed the vehicle was repaired, but the exact same catastrophic high-voltage failure recurred in under 4,000 miles (at 101,635 miles). MANUFACTURER POLICY & OBSTRUCTION OF REPAIR: General Motors recognized this hazardous defect under Special Coverage N232432680 (covering BECM replacement for 15 years/150,000 miles at $0.00 cost). This policy links to GM Master Bulletin 07-00-89-037S mandating direct-bill Courtesy Transportation for grounded safety defects. Despite this, when presented for warranty repair, the authorized Chevrolet dealership explicitly refused intake and refused to honor the transportation mandate, stating on the record: "Yes, I do decline". GM Corporate (Case 98734634) admitted coverage applied but failed to compel franchise compliance, leaving a dangerous, immobilized high-voltage hybrid vehicle stranded without access to safety-mandated repair bays.

Filed Aug 27, 2026 · Electrical, Transmission · TX

The vehicle frequently fails to register that the transmission has been shifted into Park. When this happens the instrument cluster displays "Action Required / Shift to Park" and the power (STOP/START) button will not shut the vehicle off. The condition is intermittent. I can usually clear it only by shifting through the gear positions and back into Park repeatedly, sometimes many times, before the vehicle will power down. SAFETY RISK: Because the transmission control module does not confirm Park, I have no assurance the parking pawl is engaged when I leave the vehicle, creating a rollaway hazard. The vehicle also cannot be shut down, which leaves its systems energized and drains the 12-volt battery, risking being stranded. I now apply the parking brake at every stop as a precaution. WARNING MESSAGE: The "Action Required / Shift to Park" message first appeared within days of purchase. I bought the vehicle used on 07/29/2026 at 69,471 miles and reported the fault to the selling dealer on 08/10/2026, twelve days later. CONFIRMED BY DEALER: Yes. On 08/19/2026 the selling dealer's service center diagnosed the cause as "internal shifter microswitch failure" and recorded the correction as "Replaced Transmission shifter controller assembly and cleared codes" (repair order 1133072). The fault returned within approximately half a day. On 08/26/2026 the dealer opened a second order for the same concern, recording the same cause and the same correction and listing the same part, shifter assembly part number 13540961 (invoice 1133224). The vehicle is currently at that service center and the defect is not corrected. The condition is worsening — it occurs more often and takes more attempts to clear than when first reported. The vehicle is available for inspection. It has not been inspected by the manufacturer, by police, or by an insurance representative.

Filed Aug 5, 2026 · Electrical, Engine · TX

While driving on a highway the car started to hesitate, a message appeared on the console "Propulsion power is reduced" and the engine light turn on. After driving some miles, a new message appeared: "Engine unavailable, service soon" and the car only ran on electric power, no motor engine. I had the same problem 3 year ago and the dealer identified the problem as a shorted EGR valve. This time I knew this shorted EGR valve burns the F3 fuse. I managed to get to a car part shop and bough several fuses (15 amp). After replacing the fuse 3 times I managed to get to the dealer. The repairs cost $3000+ (up from $1000+ 3 years ago). This problem is well documented on the GM service technical bulletin "21-NA-116" dated February, 2023. Three years ago I was in the middle of nowhere in South Texas and it took 6 hours to get a tow truck This time I was lucky enough to be close to to a town that the remain battery power was enough to get to the store where I bought the fuses. GM should recall this part and do a proper fix

Filed Jul 31, 2026 · Electrical, Fuel system · UT

The Vehicle had a the BECM fail at 64,000 miles. This is a known issue that GM still refuses to recall, and is refusing to warranty

Filed Jul 24, 2026 · Electrical, Fuel system · FL

The Battery Energy Control Module (BECM) failed. Before repair, the check-engine light appeared intermittently, the vehicle sometimes had difficulty starting, and the indicated electric range could suddenly drop from about 30 miles to zero despite a charged high-voltage battery. When this occurred, the gasoline engine started unexpectedly. The air conditioning also intermittently blew warm air until the vehicle was restarted. These symptoms created a safety concern because propulsion mode and indicated range could change without warning, and the vehicle could fail to start in traffic or another unsafe location. An authorized Chevrolet dealer confirmed the problem. The dealer retrieved DTCs U2624 and U2629, performed circuit testing, and diagnosed an internal short in the BECM causing loss of communication with high-voltage battery modules. The dealer stated this failure caused the warning light, starting issue, sudden loss of indicated battery range, and air-conditioning symptoms. The BECM was replaced and programmed after removal of the high-voltage battery assembly. The warning light first appeared about one month before repair, with the other symptoms becoming more apparent in early July 2026. The vehicle had approximately 80,918 miles when inspected. The failed component was retained by the dealership as a core and is not available to me for inspection. To my knowledge, the vehicle was not separately inspected by police, insurance, or GM engineering personnel. My vehicle was excluded from GM Special Coverage N232432680 even though it is a 2018 Chevrolet Volt with the same confirmed BECM failure addressed by that program and the federal safety agency investigation PE23022. I paid $3,970.56 for the repair. I am filing this complaint because this defect can cause no-start, loss of indicated battery range, warning lights, unexpected propulsion changes, and potentially reduced propulsion, while some affected 2016–2018 vehicles appear excluded from the special coverage.

Filed Jul 6, 2026 · Electrical, Fuel system · TX

The car suddenly lost power and produced error messages on the screen. I had to quickly change lanes to get out of traffic on the highway. My dealer diagnosed the issue as a BECM malfunction and quoted a repair cost of approximately $3500. However, due to my car originally being registered in California, this failure is not covered under GM Special Coverage Bulletin N232432680 (issued March 2024), which provides an extended warranty for BECM issues on affected 2016-2018 Volts up to 15 years or 150,000 miles. My VIN does not qualify for this coverage despite the vehicle being within the model years affected by known BECM soldering/connection failures. This appears to be part of a broader pattern of BECM defects in 2016-2019 Volts that can lead to sudden loss of propulsion, as previously investigated by the federal safety agency. GM should extend coverage or issue a recall for all affected vehicles, as this defect compromises vehicle safety and leaves owners with expensive out-of-pocket repairs for a known issue.

Filed Apr 29, 2026 · Electrical, Transmission · PA

The vehicle (2018 Chevrolet Volt) is experiencing an intermittent failure of the Battery Energy Control Module (BECM). Diagnostic trouble code P1E5B was stored in the system. This is a well-documented defect in this vehicle population that frequently results in a sudden, unexpected loss of propulsion power while driving ("Propulsion Power Reduced" mode), posing a significant safety risk in high-speed traffic. ​Although a Chevrolet dealership confirmed the presence of the stored fault code, they refused to perform the repair under the extended warranty (Special Coverage N23243268) because the Check Engine Light was not actively illuminated at the exact time of inspection. The manufacturer requires the vehicle to be operated until the fault recurs, exposing the driver and others to the danger of stalling on highways or at busy intersections. The failed component remains in the vehicle and is available for inspection.