Check a VIN

Chrysler 300 check engine light comes on

210 of the 4,930 owner complaints about the Chrysler 300 describe check engine light, most of them for the 2006 model year.

owner complaints
210
worst model year
2006
typical repair cost reported
$1,000
typical mileage
70,000
Is there a fix? No recall or service bulletin covers this area of the car yet.

By model year

Often reported together

Stalling 59Misfire 16Won't shift 14ABS 14Loss of power 13Jerking 12Wipers 10Hesitation 9

Trouble codes mentioned

P0456 3P1004 2U1428 1U0402 1U0100 1P1DD2 1P1DC7 1P0850 1P0735 1P0730 1

What owners say

Filed Oct 8, 2026 · Electrical · AL

On my way to work all the lights on my dashboard lights on and immediately goes off and my passenger side front window lets down. After work I went to the ABC store to get a bottle of liquor and turned my car off on [XXX] and turned my car off came out the store and had yo reach through my driver side window to open my car because my key not touching the door handle would work. I let the back seat down and pulled the emergency trunk lock and took my ratchet to check my battery since no lights was on in my car and the upon touching the battery the panic horn sounded and all my lights came on yet upon cracking my car the air conditioner blew hot air and the temperature controlled didn’t work and read on low yet blowing hot air and my stereo system is not functioning properly. Upon arriving home and turning the car off I later went outside to crank it again and had to follow the same steps as I had the first time at the ABC store and received the same result. My engine light came on a couple weeks ago and upon scanning my car read replace gas cap and evaporator system which I have done and the problem still exist with my engine light being on yet until today my car was running well in spite of the engine light being on. Months ago I took my car to Voyles Chrysler dealership because all my lights on the dash came on and said something similar to service immediately and they ran a computer scan and informed me that there wasn’t anything wrong. Yet today had proved something is going on with my electrical system INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Oct 7, 2026 · TX

Finnegan completed manufacturer emissions recall UB4 (evaporative canister) on my 2015 Chrysler 300S, VIN [XXX], on [XXX]. After that repair the check engine light returned. Independent scan showed code P0456 on the same EVAP system. I asked Finnegan to inspect their completed campaign work at no charge. They required a paid diagnostic. Chrysler cases [XXX] and [XXX] were opened and closed; Chrysler said they cannot override the dealer fee. I did not refuse a repair. I refused a paid diagnostic on work already performed under a manufacturer campaign. I want Finnegan to inspect the UB4 work at no charge or explain in writing why a paid diagnosis is required. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Sep 21, 2026 · TX

2015 Chrysler 300S VIN: [XXX] Mileage: 198,677 Finnegan Chrysler Jeep Dodge Ram, [XXX], completed manufacturer emissions recall UB4 (evaporative emissions canister replacement) on this vehicle. After that repair the check engine light returned. On XXX, AutoZone scanned the vehicle. The only code stored was P0456, EVAP System Leak Detected (very small leak). The scan identified the Emission System Integrity Monitor (ESIM), which mounts on the canister, replaced under UB4. The dealer service advisor, [XXX], said the vehicle would have to be diagnosed again and that I would have to pay for the diagnosis if they found something other than the original recall item. She said a manager would call back. I did not receive a call back. I opened Chrysler Customer Care case XXX. I have not authorized a paid diagnostic or signed a paid repair order. I am requesting that the completed UB4 repair area and related EVAP/ESIM components be inspected at no charge. I am filing this report because the same evaporative emissions system set a leak code after a completed manufacturer campaign, and the servicing dealer required a paid diagnosis before inspecting that work. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Sep 6, 2026 · Airbags, Electrical · TX

Vehicle received passenger airbag inflator recall service at Viva CDJR in El Paso, TX. The dash disassembly disturbed adjacent wiring/BCM connections, and after driving, vibration caused a short/ground fault, creating runaway wipers, A/C failure, transmission limp mode, check engine and power steering lights while in transit. Dealer has kept the car for over two weeks and refuses to scan diagnostic trouble codes or inspect the recall-adjacent wiring harness. The vehicle has never experienced this issue prior to the recall service.

Filed Apr 15, 2026 · Airbags · 106,272 miles · FL

The contact owns a 2005 Chrysler 300. The contact stated that the vehicle was repaired under the federal safety agency Campaign Number: 16V352000 (Air Bags); however, after retrieving the vehicle the following day, the vehicle experienced several failures while driving. The A/C was inoperable, the vehicle was running rough, the check engine warning light was flashing, and the vehicle almost stalled while coming to a stop. Additionally, the contact became aware that there was a hole in the fuel tank. The dealer was notified of the failures, but no assistance was provided. The manufacturer was notified of the failure, and a case was filed. The manufacturer followed up with the dealer, and the contact was later informed that no assistance would be provided because the failures were unrelated to the recall, as per the dealer’s assessment. The vehicle was not diagnosed or repaired. The failure mileage was approximately 106,272.

Filed Dec 16, 2025 · Transmission · 174,862 miles · CA

The contact owns a 2007 Chrysler 300. The contact stated that while driving at 70 MPH, the vehicle failed to accelerate as intended while depressing the accelerator pedal. The contact was able to coast to the side of the road. The contact's granddaughter was a passenger in the vehicle. The check engine warning light and the Electronic Throttle Control warning light were illuminated. The contact was able to restart the vehicle. The contact stated that the engine revved abnormally, and the vehicle started to move forward independently. The contact depressed the brake pedal to the floorboard. The contact used force to depress the brake pedal. The contact stated that after a while, the vehicle returned to function as intended; however, the failure persisted. The contact stated that while the vehicle was stopped at a traffic light or stop sign, the brake pedal and accelerator pedal needed to be simultaneously depressed. The vehicle was taken to the dealer, where it was diagnosed, and determined that the PCV vacuum hose had failed. The vehicle was repaired; however, the failure persisted. The contact's brother inspected the vehicle and noticed that the PCV vacuum hose was not connected to the upper intake manifold and that the hose had a two-inch split at one of the ends of the hose. The contact's brother reconnected the hose. The contact stated that the dealer was supposed to have replaced the hose. The failure was progressively worsening, and the vehicle was no longer being driven. The manufacturer was notified of the failure via certified mail. The failure mileage was 174,862.

Filed Mar 22, 2025 · Engine · GA

Vehicle manufactured 12/2021. Purchased NEW 5/28/2022. Slight oil consumption between changes. Noticed engine had rough idle similar to misfire August 2024 shortly after an oil change@24,272 mi. NOTE Check Engine light did NOT appear. Car taken to dealership on 10/9/2024 with complaint of rough idle and diagnosed. Service Record states: diagnosed pending multi-cylinder misfire - valvetrain is slightly noisy - removed both valve covers to find Cylinders 1,4,5,6 have ROCKER ARMS WITH NEEDLE BEARING FAILURE (emphasis mine) - no cam damage-replaced all rockers on both sides-complete. Part# 5184296-AH: ARM VALVE (09043001), Qty 24 + 2 gaskets. Service report does NOT note if lifter or other parts were inspected. Repair conducted 10/15/2024@26,039 miles. Asked at pick up OIL WAS NOT CHANGED AFTER REPAIR - TOLD NOT NECESSARY. Returned for follow up testing for rough idle (same as before rocker arm repair) and requested oil change on 12/3/2024@27,279 mi to remove potential metal shavings. Service Report states: diagnosed and observed engine while idling - no roughness in idle - all mounts good. Requested inspected by FCA Factory Tech. Service advisor promised and after a follow up call refused to arrange for Factory Tech inspection. Taken to another dealership on 2/24/2025 at 29,215 miles. Was aware of previous repair. No diagnosis performed. Service report: found vehicle to operate as designed - no problem found. Refused to arrange Factory Tech inspection. Vehicle continues to have rough idle due to misfire and makes ticking noise on both sides which can be heard in cabin. Problem was not fixed properly or other parts need replacement. FCA refuses further inspection. No oil pressure, particulate or consumption testing conducted. No lifter inspection conducted. Oil sample sent for lab for testing (metal ppm). Customer Service would send to case manager. Filed NCDS case and discussions with attorney. Reduced performance. Engine will not last. FCA needs to buy back.

Filed Mar 21, 2025 · Engine · GA

Vehicle manufactured 12/2021. Purchased NEW 5/28/2022. Slight oil consumption between changes. Noticed engine had rough idle similar to misfire August 2024 shortly after an oil change@24,272 mi. NOTE Check Engine light did NOT appear. Car taken to dealership on 10/9/2024 with complaint of rough idle and diagnosed. Service Record states: diagnosed pending multi-cylinder misfire - valvetrain is slightly noisy - removed both valve covers to find Cylinders 1,4,5,6 have ROCKER ARMS WITH NEEDLE BEARING FAILURE (emphasis mine) - no cam damage-replaced all rockers on both sides-complete. Part# 5184296-AH: ARM VALVE (09043001), Qty 24 + 2 gaskets. Service report does NOT note if lifter or other parts were inspected. Repair conducted 10/15/2024@26,039 miles. Asked at pick up OIL WAS NOT CHANGED AFTER REPAIR - TOLD NOT NECESSARY. Returned for follow up testing for rough idle (same as before rocker arm repair) and requested oil change on 12/3/2024@27,279 mi to remove potential metal shavings. Service Report states: diagnosed and observed engine while idling - no roughness in idle - all mounts good. Requested inspected by FCA Factory Tech. Service advisor promised and after a follow up call refused to arrange for Factory Tech inspection. Taken to another dealership on 2/24/2025 at 29,215 miles. Was aware of previous repair. No diagnosis performed. Service report: found vehicle to operate as designed - no problem found. Refused to arrange Factory Tech inspection. Vehicle continues to have rough idle due to misfire and makes ticking noise on both sides which can be heard in cabin. Problem was not fixed properly or other parts need replacement. FCA refuses further inspection. No oil pressure, particulate or consumption testing conducted. No lifter inspection conducted. Oil sample sent for lab for testing (metal ppm). Customer Service would send to case manager. Filed NCDS case and discussions with attorney. Reduced performance. Engine will not last. FCA needs to buy back.

Filed Dec 19, 2024 · Engine · 96,000 miles · FL

The contact owns a 2014 Chrysler 300. The contact stated while driving at an undisclosed speed, the vehicle briefly vibrated before returning to normal functionality however, the failure became a regular failure. The check engine warning light was illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the engine. The vehicle was not repaired. After investigating the failure, the contact related the failure to Technical Service Bulletin: 09-002-14. The manufacturer was notified of the failure and referred the contact to the federal safety agency Hotline for assistance. The failure mileage was 96,000.

Filed Nov 21, 2024 · Engine, Fuel system · CA

2006 Chrysler 300 Touring 3.5L V6 engine. Car has intermittent stall at slow speeds or at complete stop. Sometimes feels like it stumbles, other times it dies suddenly and unable to tell the engine shut down. I have to put car in park and completely switch the ignition fully off and turn back on to start position. When it stalls while rolling, I have to brake and bring car to full stop, with no power steering, and go through the same start procedure. No trouble codes are generated, and no check engine light indicator illuminated. Car usually starts right up, but sometimes I have to keep cranking starter, stumbles to catch as if starving for fuel. A/C was on first two times but also happens with A/C off. Research online reveals an open recall for the fuel tank on the 300C model with a 5.7L or 6.4L engine. Problems described on the 300C model are nearly identical to what my 300 Touring is experiencing. PCM replacement does not correct problem. Some noticed it happening only with a full tank. Stopgap measure is to only fill no more than 3/4 tank. I am currently testing this idea. The safety issue is significant and twofold; three times I have had one other adult and two children in the car. While stalled at a major intersection traffic signal trying to restart the engine, other vehicles approached from the rear at 50-55 MPH. A rear end collision with children in the back seat would likely be fatal. Secondly, during a stall event while the car is moving, it is extremely difficult to steer the vehicle to a safe place, and braking takes significant pedal pressure once power assist bleeds off. This is a serious concern and obvious collision hazard, as I may not be able to stop or steer to a safe location or avoid a hazard. I had the car at the dealer for over three weeks in July 2024 and they were unable to duplicate the issue. Their answer was to drive car until it happens more frequently. This is unacceptable. No other solution or repair was provided.

Related recalls

No recalls on record for this model year.

Questions about the Chrysler 300 check engine light

Why does the check engine light come on in the Chrysler 300?

Owners who report it most often also describe engine stalls while driving, misfire or rough idle and stuck in gear or won't shift, and the codes they mention most are P0456, P1004 and U1428.

Which Chrysler 300 years have check engine light problems?

The model years with the most reports are 2006 (51 complaints), 2007 (27 complaints) and 2012 (24 complaints).

How much does it cost to fix check engine light on the Chrysler 300?

Owners who mentioned a price put the repair at about $1,000 (median of 11 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.

VIN decoder

See the problems and recalls for an exact car

Buying a used Chrysler 300?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history