I bought my car, Chrysler 300 2021 at the Hemet CA Dealership in 2021. Hemet Chrysler Dodge Jeep Ram. The car presented with several issues including, difficulty starting, engine misfires, stalling, and decreased fuel efficiency. The low fuel warning light on my car's dashboard would not come on when gas was low at all, until it left me stranded in the freeway far away from home and a dealership. I had to take it in to closest car service center to have the fuel pump replaced. These fuel pumps should last for 100,000 miles or more. My car had only 69,101 miles. The gas level on the dashboard was stuck at the level when I added gas the last time, again not indicating that it needed more gas. I do not see any recalls issued on FUEL PUMP for my cars year, make and model. But a lot of people have reported the same issues. Can someone respond to this email? I want Chrysler to understand that this is not acceptable. This issue should be part of a recall. VIN [XXX] Kindly, [XXX] [XXX] [XXX] VIN [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Chrysler 300 misfire problems
32 of the 4,930 owner complaints about the Chrysler 300 describe misfire or rough idle, most of them for the 2006 model year.
- owner complaints
- 32
- worst model year
- 2006
- typical mileage
- 52,000
By model year
Often reported together
Check engine light 16Stalling 8Hesitation 4Engine failure 4Knocking 3Sudden acceleration 2Won't shift 2
Trouble codes mentioned
P0300 2
What owners say
Vehicle manufactured 12/2021. Purchased NEW 5/28/2022. Slight oil consumption between changes. Noticed engine had rough idle similar to misfire August 2024 shortly after an oil change@24,272 mi. NOTE Check Engine light did NOT appear. Car taken to dealership on 10/9/2024 with complaint of rough idle and diagnosed. Service Record states: diagnosed pending multi-cylinder misfire - valvetrain is slightly noisy - removed both valve covers to find Cylinders 1,4,5,6 have ROCKER ARMS WITH NEEDLE BEARING FAILURE (emphasis mine) - no cam damage-replaced all rockers on both sides-complete. Part# 5184296-AH: ARM VALVE (09043001), Qty 24 + 2 gaskets. Service report does NOT note if lifter or other parts were inspected. Repair conducted 10/15/2024@26,039 miles. Asked at pick up OIL WAS NOT CHANGED AFTER REPAIR - TOLD NOT NECESSARY. Returned for follow up testing for rough idle (same as before rocker arm repair) and requested oil change on 12/3/2024@27,279 mi to remove potential metal shavings. Service Report states: diagnosed and observed engine while idling - no roughness in idle - all mounts good. Requested inspected by FCA Factory Tech. Service advisor promised and after a follow up call refused to arrange for Factory Tech inspection. Taken to another dealership on 2/24/2025 at 29,215 miles. Was aware of previous repair. No diagnosis performed. Service report: found vehicle to operate as designed - no problem found. Refused to arrange Factory Tech inspection. Vehicle continues to have rough idle due to misfire and makes ticking noise on both sides which can be heard in cabin. Problem was not fixed properly or other parts need replacement. FCA refuses further inspection. No oil pressure, particulate or consumption testing conducted. No lifter inspection conducted. Oil sample sent for lab for testing (metal ppm). Customer Service would send to case manager. Filed NCDS case and discussions with attorney. Reduced performance. Engine will not last. FCA needs to buy back.
Vehicle manufactured 12/2021. Purchased NEW 5/28/2022. Slight oil consumption between changes. Noticed engine had rough idle similar to misfire August 2024 shortly after an oil change@24,272 mi. NOTE Check Engine light did NOT appear. Car taken to dealership on 10/9/2024 with complaint of rough idle and diagnosed. Service Record states: diagnosed pending multi-cylinder misfire - valvetrain is slightly noisy - removed both valve covers to find Cylinders 1,4,5,6 have ROCKER ARMS WITH NEEDLE BEARING FAILURE (emphasis mine) - no cam damage-replaced all rockers on both sides-complete. Part# 5184296-AH: ARM VALVE (09043001), Qty 24 + 2 gaskets. Service report does NOT note if lifter or other parts were inspected. Repair conducted 10/15/2024@26,039 miles. Asked at pick up OIL WAS NOT CHANGED AFTER REPAIR - TOLD NOT NECESSARY. Returned for follow up testing for rough idle (same as before rocker arm repair) and requested oil change on 12/3/2024@27,279 mi to remove potential metal shavings. Service Report states: diagnosed and observed engine while idling - no roughness in idle - all mounts good. Requested inspected by FCA Factory Tech. Service advisor promised and after a follow up call refused to arrange for Factory Tech inspection. Taken to another dealership on 2/24/2025 at 29,215 miles. Was aware of previous repair. No diagnosis performed. Service report: found vehicle to operate as designed - no problem found. Refused to arrange Factory Tech inspection. Vehicle continues to have rough idle due to misfire and makes ticking noise on both sides which can be heard in cabin. Problem was not fixed properly or other parts need replacement. FCA refuses further inspection. No oil pressure, particulate or consumption testing conducted. No lifter inspection conducted. Oil sample sent for lab for testing (metal ppm). Customer Service would send to case manager. Filed NCDS case and discussions with attorney. Reduced performance. Engine will not last. FCA needs to buy back.
Engine constantly leaking coolant from multiple areas on the engine. Have had to constantly get it repaired at least once a month. Also have had constant cylinder misfires, fuel injector system keeps going bad
bought the car 04/27/2023 check engine light came on 2 days after purchase, got a code read at autozone it was codep0302 its a misfire in cylinder 2 only causes vehicke to go into "limp mode" loses power dies whike driving 3 occassions. ive paid to get ut serviced twice and its still not fixed , causing driveabikitt/ emmissions/ecu concern.
My car has been at the first dealership (Brewbaker Dodge, Montgomery, Ala.) on November 11, 2020. I got the car back March of 2021. The problem of misfires on cylinder 1 side, hesitation when proceeding from a red light, and stalling out. The problem continued so; I took it to another dealership (Stiver Dodge, Prattville, Ala.) in August 2021. I was given the car back in February 2022 stating to me that the problem may correct itself after being driven until after my birthday (March 2022). So, to this date my car is still at the Dealership and Chrysler Star Team has no clue what is wrong with this car. I'm still paying a car note, insurance, and renewing the license plate for this car every year and moth. Chrysler knows that there is an issue with the 3.6L Pentastar engine. No one wants to help me in this situation, but all parties involved wants my money but no real solution(s). I need someone that's going to advocate for me on my behalf. I just want Chrysler at this point to just put a new engine in the dang car and cover the charges at their expense for their defective engine. Chrysler seriously knows what's going. As long as my car has been at this Dealership For over a year, how could the engineers who designed this engine not know what's wrong with? This car has very low miles to be 8yrs old with major issue. And FCA doesn't want to admit to this engine (3.6L Pentastar) being a defective engine. Look at the class action lawsuits pertaining to this. Please Sir / Ma'am help me make sense of this. Thank you.
Esc off light comes on and transmission does not shift has loss of power gets extremely bad gas mileage. Whole engine shakes and bucks as if misfiring., cruise control nor sport mode engage.
Diagnostic shows misfire in cylinder 8. Vehicle has 123,000 miles on it. I am told it is a lifter or cam and that I need a new engine. This vehicle is 7 years old and has been maintained. After reading reviews the hemi engine is known to break down. The estimated cost for a new engine approximately $ 7,000. Vehicle all of a sudden idled very rough took in and major work needed to be done. Wish chrysler would back their vehicle.
Misfiring after spark plugs have been changed. Coil was checked as well as injector pulse, which were fine. Engine lights stays on and misfiring happens when car is idle.
Engine stalled. Restarted. Cleaned electric control throttle. Ran 2 days with no problem except for rough idling (this was happening before first shut down). Engine stall, restarted. Drove home. Today engine stalled again. Two of incidents occurred while stationary and once in motion.
Related recalls
No recalls on record for this model year.
Questions about the Chrysler 300 misfire
Which Chrysler 300 years have misfire or rough idle problems?
The model years with the most reports are 2006 (7 complaints), 2014 (5 complaints) and 2005 (4 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Chrysler 300?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history