Check a VIN

1994 Chrysler Concorde steering problems

33 complaints (10% of all complaints for this car). 2 crashes reported.

owner complaints
33
of this car's complaints
10%
crashes
2
recalls
0

Which part fails

  • Linkages: tie rod assembly
    15
  • Rack and pinion
    7
  • Steering wheel/handle bar
    4
  • Hydraulic power assist system
    4
  • Hydraulic power assist: pump
    2
  • Rack and pinion: rack
    1
  • Linkages
    1
  • Gear box: shaft pitman
    1

At what mileage

Complaints by mileage at the time of the problem.

0k-25k
25k-50k
50k-75k
75k-100k
100k-125k
125k-150k
150k-175k
175k-200k
200k+

Chrysler Concorde steering problems in other years

199319941995199619971998199920002001200220032004

Specific symptoms reported on the 1994 Chrysler Concorde steering

Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.

Power steering loss 9

Related recalls

No recalls on record for this model year.

Related investigations

Steering column separationOpened May 7, 2003, closed July 22, 2003

Mr. Larry a. Sackey submitted a petition to the federal safety agency by letter dated april 18, 2003, requesting that agencyfurther investigate the defective collapsible steering shaft system on 1987-1995 vehicles manufactured by the daimlerchrysler corporation.in part because of 49 cfr ? 30120(g), the federal safety agency has decided to limit the scope of the petition vehicles to 1993-1995 models, excluding the 1993 jeep grand cherokee and 1994-1995 dodge ram series trucks that were recalled (93v210 & 96v230) for steering column failure.if the analysis of these vehicles had identified a potential problem, the scope could have been expanded in an investigation.a review of odi's data base shows no recent complaints and a lack of a complaint trend concerning the subject issue on the subject vehicles as a whole or by individual models.therefore, the petition is denied.for details, see federal register notice volume 68, no. 130, july 8, 2003.

DP03002

Steering system rack and pinionOpened October 29, 1999, closed September 13, 2001

There is no summary currently available

EA99031

Steering system rack and pinionOpened June 28, 1999, closed October 29, 1999

Since opening the preliminary evaluation (pe), odi has received 6 additional complaints.during the pe it was determined multiple failure modes are involved in this matter.the warranty claim rate is high for a steering system concern.the issues reported involve premature wear out at the rack and pinion interface with the inner tie rod end(s), binding and sticking of the steering gear, cracked or broken tie rod ends, sheared rack and pinion assembly bolts, and wear out of the rack and pinion mount bushings.many of the complainants mention steering wonder and loose steering.three of the most recent complaints allege a complete loss of steering due to sheared bolts.odi is upgrading this pe in order to perform a thorough technical analysis of the various system failure allegations and to quantify the effect that these failures have on vehicle control.

PE99044

What 1994 Chrysler Concorde owners say

Most recent owner complaints, unedited.

Filed Mar 16, 2006 · Airbags, Steering · 26,000 miles · CA

I have a 1994 chrysler concorde which has air-bag problem which I was told would cost me $500 to replace a clock spring by bob baker in carlsbad, ca. I refused stating that daimler chrysler should treat that as a drive train defect and replace it. I also had a failure of the steering and paid for that out of pocket.

Filed Jan 30, 2004 · Steering · 173,680 miles · NY

The tie-rods in my 1994 chrysler concorde have failed repeatedly since I purchased this vehicle, causing excessive vibrations as well as depleted steering ability. Additionally my steering wheel is approx. 45 degrees offset from center. My dealer replaced my tie-rods at approx. 150,000 miles under warranty purchased with my vehicle. My vehicle is at 173,680 miles now and the tie-rods are once again in need of replacement. I am concerned these parts are deffective due to excessive force put on them because of a severe vibration in the steering column. It has been less than six months since the tie rods were last replaced, and even after they were replaced the last time my dealership was unable to return the steering wheel to the center position for forward travel.

Filed Jun 13, 2002 · Steering · CA

Steering wheel shakes at high speeds. Took vehicle to mechanic and they stated that tie rod bushing was completely worn out. Dealer was aware of problem. *akchrysler appears to be aware that the front left and right tie rod bushings do not last as normally as they should. The tie rod bushings failure causes a potential loss of steering.

Filed Jul 23, 2001 · Steering · TX

Bolt cap at rod connected to the rack and pinion became unscrewed and fell out. This caused tie rod to become loose, and driver lost steering control while turning into a driveway. Wheel turned sideways. It slid along and into gravel. Vehicle towed to dealership and was repaired.*ak

Filed Feb 5, 2001 · Steering · NV

Right side cylinder of power steering is moving around too much when looking under hood while someone else turns. This creates a problem with main cylinder that causes right wheel to flap all over the place.

Filed Nov 13, 2000 · Steering · AZ

Both front tie rods were reported lost from dealer. Should not be driven until repairs were done. Manufacturer notified, and informed consumer that vehicle was not covered under a recall due to VIN. Please feel free to provide any further details on this matter.

Filed Oct 17, 2000 · Body, Steering · TN

Hood won't stay up because prop rod seals are leaking. Nlm

Filed Oct 10, 2000 · Steering · MI

Car started pulling to the left and ABS warning light comes on periodically, upon further inspection I found that both tie rod ends are wore and very sloppy. Chrysler garage said that these are not recall items and that I will have to pay for repairs.

Filed Oct 2, 2000 · Steering · CA

Tie rod on the left front end came apart resulting in loss of steering control, it turned out that a locking mechanism for the inner tie rod ends was missing. Nlm

Filed Sep 7, 2000 · Steering · CA

Nut holding tie rod fell off, causing loss of steering. It was suggested that nut left loose on assembly line

Questions about the 1994 Chrysler Concorde steering

Does the 1994 Chrysler Concorde have steering problems?

Owners have filed 33 complaints about the steering of the 1994 Chrysler Concorde, 10% of all its complaints.

At what mileage do 1994 Chrysler Concorde steering problems start?

Not enough complaints include the mileage to tell.

Was there a recall on the 1994 Chrysler Concorde steering?

There is no recall for this problem on this model year.

What year does the Chrysler Concorde have bad steering?

The Chrysler Concorde model years with the most steering complaints are 1996 (61 complaints), 1995 (41 complaints) and 1994 (33 complaints).

Other 1994 Chrysler Concorde problems

Transmission 71Brakes 50Fuel system 48Engine 44Seats 25Suspension 23Electrical 22Lights 22Body 20Airbags 15Acceleration 14Visibility 11Locks 7Seat belts 3Tires 1

VIN decoder

See the problems and recalls for an exact car

Buying a used 1994 Chrysler Concorde?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history