1997 Chrysler Concorde steering problems

Filed Mar 17, 2009 · Steering · 60,000 miles · TX

Bad cradle bushings grinding noise when driving,turning,and breaking loud bang when overdrive is initiated and very bad alignment front driver tire started smoking and the brake rotor was hot enough to burn flat spots on my finger tips.

Filed Feb 18, 2009 · Body, Steering · 143,500 miles · IL

I have experienced alot of play in the steering of my chrysler concorde 1997. After inspection it was found that the front cradle bushings where worn away. I have owned this car for 2 years. I looked at a web site concerning this and other problems with this and other chrsler models. And is concerned about the issues related to severe and catastrophic failures with these vehicles.

Filed Dec 5, 2008 · Steering · 120,000 miles · WV

I have a 1997 chrysler concord. I had a severe clunking noise in front end. After several trips to the garage and almost $1000 later I had replaced both inner tie rod ends, all 4 cradle bushings as well as both swaybars in front end. Not to mention front end alignments after each repair. Then my left tie rod had to be replaced again within a bout a month. The problem was eventually fixed and noise stopped until now. Six months later I'm experiencing the same noises and a lose tie rod again. I have seen all the complaints about chrysler and note that they don't include the 1997 model as having these problems but I do with my 97 concord. I have 2 children that ride in my vehicle and this is really unsafe. If the tierods break or come lose you can't steer the car. This problem really needs to be addressed by chrysler and fixed.

Filed Nov 19, 2008 · Steering · 115,000 miles · GA

Complete steering failure on 199 chrysler concorde.

Filed Feb 11, 2004 · Steering · DC

Consumer 1997 concorde driver side tire turned right while driving down a hill and stopped. *ts after having the vehicle towed, the consumer was informed the inner tie rod had failed and the outer tie rod was about to fail. The dealer stated it looked as if the vehicle had been work on previously, and whom ever did the work did not place the tabs back in place and because of that the tie rods eventually stripped and fell out of place. The consumer stated the rack and pinion was replaced and the previous dealer did stated they did have to remove the tie rods in order to replace the rack and pinion, however they refused to reimburse the consumer because it had been over 5 years since the repair.

Filed Jan 13, 2004 · Steering · 52,000 miles · WI

Power steering is out or very hard to turn until the car is warmed up. I bought this car in aug. Of 2003. This has failed atleast 120 times. Doesn't matter if it is summer or winter. Was checking to see if this was recalled. It wasn't so I made a complaint.

Filed May 29, 2003 · Steering · 71,904 miles · CA

While making a left turn, vehicle suddenly lost power steering and the tires locked up. This was causeb by rack and pinon failure.

Filed Mar 8, 2002 · Steering · OH

Steering was losing control or not responding properly because of the nuts / bolts, and a faulty bushing needed to be replaced on rack and pinion. Dealer and manufacturer notified. Feel free to provide any further information.

Filed Jul 20, 2001 · Steering, Visibility · NJ

Rack and pinion replaced 2 times in three years, making knocking noise again......AC evaporater replaced 3 times in 3 years (dealer said if it was fixed within 12 months it would still be under warrantee, not mentioning the 7 yr warrantee extension) instrument panel would turn off intermittanly now it seems to be not working at all,,,, check engine light has been on for 2 years... Dealer resets it and it works for about 2 weeks(serviced 5 times) ... Regulator in pass. Door does not lift power window

Filed Nov 28, 2000 · Steering, Tires · IL

Vehicle experiencing problem with rack and pinion being replaced by dealer on three occasions. Replacement was done under warranty, but causes of failure are still unknown. *ak the tires were prematurely worn on outside edges.