2001 Chrysler Sebring electrical problems

Filed Jun 18, 2014 · Electrical · 89,000 miles · AL · fire

Tl* the contact owns a 2001 chrysler sebring. The contact stated that while traveling 10 MPH, the vehicle stalled without warning. The contact smelled a burning odor coming from the vehicle. The vehicle failed to restart. Upon inspection, it was found that the wires in the interior fuse box melted. The vehicle was repaired. The manufacturer was not notified of the failure. The failure mileage was 89,000 and the current mileage was 92,000.

Filed Jul 18, 2013 · Electrical · 88,003 miles · WI

After stopping and parking car, it was a completely dead sound when I tried to start it again. This has happened twice so far in a month. I jacked up the car on drivers side, just let down the jack; and it started both times. The locks don't work and the windows can only be controlled by the driver. Checked all fuses but the bottom line is this car has electrical problems.

Filed Feb 3, 2012 · Electrical, Engine · 60,000 miles · MS · crash

2001 chrysler sebring turns off while driving - the exact same problem as the hundreds of thousands of chryslers recalled last year. Everyone wants to try a body control module, fuel pump, new crank shaft but the problem keeps occurring - perhaps because they were not aware of this recall/problem as not even my local chrysler dealership knew. This has happened to me frequently over the past 1.5-2 years or so, it comes and goes. I was rear ended once but it was light enough (thank god) that it did not cause any damage. Extremely dangerous. Almost a quarter of a million chrysler vehicles were recalled last year for this problem. As of right now, I believe just van/crossover models - why not all models with this same problem? Please leave your complaints on the message boards alone and bring them to the federal safety agency so that chrysler can be held accountable for these issues.

Filed Dec 19, 2011 · Airbags, Electrical · 136,000 miles · MI

Tl* the contact owns a 2001 chrysler sebring. The contact was driving approximately 30 MPH and the air bag warning indicator began to illuminate. The warning indicator remained illuminated until the engine was turned off. In addition, the cruise control and horn failed to operate. The vehicle was taken to an independent mechanic, who stated that the failure was due to a defective clock spring and could result in the air bags not properly deploying. The manufacturer was not made aware of the failure. There was a technical service bulletin, item number 082700, pertaining to the air bag failure. The approximate failure mileage was 136,000.

Filed Oct 12, 2011 · Electrical, Lights · 55,000 miles · OH

Dashboard cluster lights work intermittently and other electrical problems. Talked to a auto electric specialist who told me this is a known problem and has had several customers with same problem. The dealership must repair the problem because they are the only ones with the equipment to fix it and the dealers are charging over $1,500 to fix. With so many people having the same problem it seems like it should be on the recall list. It certainly is a safety problem.

Filed Jul 29, 2011 · Electrical, Visibility · 90,000 miles · SC

Tl* the contact owns a 2001 chrysler sebring. The contact stated the horn and the drivers rear window failed to function properly. The horn would not work and the window would not open or close. The vehicle was taken to a local mechanic who performed a diagnostic test that located the failure within the window regulator and the horn wires. The vehicle was not repaired. The failure mileage was 90,000 and the current mileage was 100,000. Updated 8/30/11 *cn updated 09/26/11

Filed Aug 11, 2010 · Electrical · 119,000 miles · GA

Tl*the contact owns a 2001 chrysler sebring lx1. While driving, the vehicle stalled and would not shift out of first gear. The vehicle was taken to the dealer who stated that the electrical wiring caused the failure to occur. The vehicle was not serviced. The failure and the current mileages were 119,000.

Filed Jun 30, 2010 · Electrical, Visibility · 87,600 miles · ID · fire

1. Normal use of fan blower with A/C or heater in a 2001 chrysler sebring sedan lxi. 2. Blower becomes inoperative intermittently at all speeds with either A/C or heater on. The intermittent part of the problem has been occurring since my wife bought the car new. Fan blower motor was replaced twice, blower resistor block was replaced three times. In troubleshooting the problem, I found that the contacts of the power wire from the blower fan to the blower resistor at the resistor electrical connector developed a high resistance thus causing the contacts to overheat. The contacts overheated to the point of melting both sides the connector's plastic together. In order to replace the resistor, I had to break the plastic of the resistor connector in order to remove it. Further examination revealed the presence of a smoke trail coming from the pin 1 (power wire) side of the connector. Several days before, I thought I detected the odor of a burning electrical component. If the contact had not changed, thus lowering the resistance, a fire would definitely result. The melted plastic of the connector ends leads me to say that a fire did occur. The resistance was high enough to melt the plastic, but not blow the 30 amp fuse. 3. The electrical connector blower resistor was cut off. Since there are no replacement connectors available, I used insulated female "spade" quick disconnect terminals crimped to each wire to connect the blower resistor. A small dab of rtv silicon was applied to each terminal to help lock them in place. Before reinstalling a new blower resistor, I enlarged the hole to the air duct where the resistor mounts into. The original hole cut out from the factory was too small for the resistor to easily fit into. This I feel contributes to the problem. I have kept the old parts as evidence.

Filed Nov 16, 2009 · Airbags, Electrical · 97,000 miles · DE

Bought used in 2007 sebring 2001 at 87k miles. At round 95k, while pulling out of parking space, heard cracking noise in steering wheel..resulting in no horn, air bag light cont illuminated so can't tell if there's a problem, and no cruise control. Took car to private dealer and diagnosed clock spring, but chrysler says its not under recall protection any longer!!! Crazy, I know! Also, since purchase have many probs with electrical dash probs ie flashing on/dimming and radio just turning off...also not covered! And had strange humming noise since purchase while driving...finally found out what it was and had to replace both front hubs. All of these safety issues seem to be a continuing prob with other drivers as per the complaints I've read here at least as far back as I read (thru 2006). Why is chrysler not being made to rectify at least the air bag (clock spring) issue they already admitted to???? Really kind of the same thing with the elect issues too, but I kind of understand poss issues with that after so many miles. Would really like help/advice on how to make chrysler take responsibility for that expensive clockspring/air bad issue.

Filed Oct 30, 2008 · Electrical, Engine · 82,000 miles · OH

Tl*the contact owns a 2001 chrysler sebring. Whenever the contact comes to a complete stop, the vehicle will suddenly shut off. Occasionally, the vehicle does not immediately restart. He also noticed that the vehicle would suddenly stall while accelerating past 60 MPH. In addition, the radio and instrument panel lights stop working whenever the check engine indicator illuminates. The vehicle has not been diagnosed by the dealer. The current and failure mileages were 82,000. Updated 11/28/08 *bf the consumer believed the camshaft sensor was rubbing the wiring causing it to heat the wiring under the protective shield and slowly grounding out the electrical system. Updated 12/02/08.