2001 Chrysler Sebring visibility problems

Filed Jul 29, 2011 · Electrical, Visibility · 90,000 miles · SC

Tl* the contact owns a 2001 chrysler sebring. The contact stated the horn and the drivers rear window failed to function properly. The horn would not work and the window would not open or close. The vehicle was taken to a local mechanic who performed a diagnostic test that located the failure within the window regulator and the horn wires. The vehicle was not repaired. The failure mileage was 90,000 and the current mileage was 100,000. Updated 8/30/11 *cn updated 09/26/11

Filed Jun 30, 2010 · Electrical, Visibility · 87,600 miles · ID · fire

1. Normal use of fan blower with A/C or heater in a 2001 chrysler sebring sedan lxi. 2. Blower becomes inoperative intermittently at all speeds with either A/C or heater on. The intermittent part of the problem has been occurring since my wife bought the car new. Fan blower motor was replaced twice, blower resistor block was replaced three times. In troubleshooting the problem, I found that the contacts of the power wire from the blower fan to the blower resistor at the resistor electrical connector developed a high resistance thus causing the contacts to overheat. The contacts overheated to the point of melting both sides the connector's plastic together. In order to replace the resistor, I had to break the plastic of the resistor connector in order to remove it. Further examination revealed the presence of a smoke trail coming from the pin 1 (power wire) side of the connector. Several days before, I thought I detected the odor of a burning electrical component. If the contact had not changed, thus lowering the resistance, a fire would definitely result. The melted plastic of the connector ends leads me to say that a fire did occur. The resistance was high enough to melt the plastic, but not blow the 30 amp fuse. 3. The electrical connector blower resistor was cut off. Since there are no replacement connectors available, I used insulated female "spade" quick disconnect terminals crimped to each wire to connect the blower resistor. A small dab of rtv silicon was applied to each terminal to help lock them in place. Before reinstalling a new blower resistor, I enlarged the hole to the air duct where the resistor mounts into. The original hole cut out from the factory was too small for the resistor to easily fit into. This I feel contributes to the problem. I have kept the old parts as evidence.

Filed Jun 16, 2010 · Engine, Suspension · TX

S10 appropriate handling-letter from regarding 2001 chrysler sebring *tgw the consumer stated when he turned the steering wheel to the left or the right, he could hear a grinding sound. The dealer found the left lower ball joint was worn, which was the cause of the noise. Also, the front struts, oil pan and cooler lines were all leaking, and the drive belts were cracked. The heating and air condition controls were not performing as designed.

Filed Jan 26, 2007 · Engine, Steering · LA

Since I bought my vehicle in 2001 I had problems with my window, steering clicking, power train computer and transmission computer, tapping in the engine, engine failure, crankshaft, now servere knocking. I will not advice anyone to purchase a sebring from chysler. It's sad that chysler not helping correct the problems that their vehicle has.

Filed Nov 2, 2005 · Body, Engine · 10,066 miles · PA

Consumer replaced rear defrost on chrysler sebring on numerous occasions. *ts the rear defroster does not work. The rear vision glass needed to be replaced. Chrysler offered the consumer a 50/50 split. Also the drivers side window rattled, red fluid was found in the consumer's driveway due to transmission pan and cooler line leakage, the convertible was leaking on the drivers side window area due to weather strip and there was a slow leak in the r/r tire due to a hole.

Filed Aug 19, 2005 · Visibility · 21,000 miles · AZ

When car bought shared driver interior door handle loose. Took back in for warranty repair. Months later power window buttons are falling through same door handle, rendering window inoperable. Upon me taking it apart to see if I could fix, found the plastic stems that interlock power window buttons to the handle, are disentagrating.that when I took in for above mentioned warranty work, all that was done, they glued handled to upolstry. The rear window driver side has now also bedome inoperable due to same disentegaration. This is a safety issue in the event of an accident and/or fire and unable to open door to escape one would become trapped unable to lower a window to get out.

Filed Jun 24, 2005 · Airbags, Visibility · FL

December of 2002 - rear window defogger quit. Wire connector came loose from rear window. Could not be repaired. Window had to be replaced to fix problem. May of 2004 - air bag indicator came on and chime sounded. Sensor or some sort replaced at an expense of over $300.00 june of 2005 - repeat or above problem. Appointment to bring car in for servicing on june 28th. June of 2005 - repeat of rear window defogger. Item has not worked for months. I have run a report on mycarstats.com and have found both of these problems with other owners of this model. Appears we have a problem here. I should not have had to pay for the air bag problem the first time and I certainly shouldn't have to pay next week when I bring it in for servicing.

Filed May 21, 2003 · Brakes, Steering · CA

Nary 05/21/2003 *mr the consumer experienced rear brake suspension, transmission slippage, rear window sealant loose, and steering problems.

Filed Mar 17, 2003 · Body, Electrical · 7,980 miles · CA

After it rained, water collected in a puddle on the back interior floorboard. The dealer previously suspected the water came from the door seals and replaced them, however the leak resurfaced and it did not come from door seals. Consumer believed the leak came from the chassis. *jb other problems are as followed: cd player malfunctioned, A/C unit failed and was repaired two times, the door panel was replaced, the steering column was replaced/squealed when turned/repair kit was installed/clockspring was replaced, the vehicle wouldn't start, there were electrical problems, a loud sound had come from the brakes, the window buttons were loose at the switch, and the engine cranked but did not start and was found to be flooded. Scc

Filed Mar 5, 2002 · Visibility · NJ

Rear window is like looking through a dissorded of water, replace rear window, did not fix the problem.