While driving my 2016 Chrysler Town & Country around 45mph in active traffic, the vehicle suffered a sudden, catastrophic, and complete loss of motor power. The engine remained running, but the transmission completely lost all hydraulic pressure, leaving me unable to accelerate and leaving me completely stranded in a highly dangerous situation. I am a mother of four children who were inside the vehicle, and this sudden stalling created an imminent crash hazard and an extreme risk to my family's safety.The vehicle was towed to an authorized dealership, Lithia Chrysler in [XXX], for a formal diagnostic check under Chrysler Corporate Case #XXX. The dealership's certified master technician pulled an electronic computer scan and confirmed an active P08 fluid pressure fault code. The dealer physically verified that the primary transaxle oil pump failed, which caused extensive consequential damage, filling the transmission fluid with heavy metal shrapnel and a burnt smell. The dealer explicitly documented that the entire transmission assembly requires a complete replacement due to this internal destruction.This mechanical failure sequence, the component involved, and the life-threatening safety symptoms perfectly mirror the federal safety agency Campaign 16V‑461 (Manufacturer Safety Recall S44) for the transaxle oil pump. Despite this identical failure, Chrysler Case Management denied repair assistance on the grounds that my VIN sits outside their arbitrary manufacturing window. It is clear that the original recall parameters were too narrow and failed to encompass all defective pumps. I am waiting for a federal safety investigation into expanding Recall S44 to protect outside-window consumers left stranded by this severe defect. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Chrysler Town and Country stalling problems
1,514 of the 13,494 owner complaints about the Chrysler Town and Country describe engine stalls while driving, most of them for the 2010 model year.
- owner complaints
- 1,514
- worst model year
- 2010
- typical repair cost reported
- $1,000
- typical mileage
- 85,000
By model year
Often reported together
Loss of power 121Power steering loss 96Check engine light 86Won't start 70Fuel pump 61Wipers 45Headlights 35Warning lights 29
Trouble codes mentioned
P0302 4P1790 3C121C 3P0868 2P0300 2U0141 1P2533 1P0944 1P083B 1P0792 1
What owners say
The contact owns a 2016 Chrysler Town and Country. While the contact’s spouse was driving, the vehicle stalled in the middle of the road. The vehicle was towed to the dealer, where it was diagnosed with transmission pump failure. The contact was informed that the transmission needed to be replaced. The contact referenced the federal safety agency Campaign Number: 16V461000 (Power Train); to the dealer, however the VIN was not included in the recall. The technician from the dealer stated that the failure was associated with the recall. The manufacturer was notified of the failure. The failure was confirmed by the dealer.
The contact owns a 2010 Chrysler Town and Country. The contact stated that while pulling out of the parking space or while driving at an undisclosed speed, the vehicle started stalling. The contact stated that the ignition key was loose, and whenever the key was jiggled, the vehicle became inoperable. The contact associated the failure with the federal safety agency Campaign Number: 14V373000 (Electrical System, Air Bags); however, the VIN was not included in the recall. The dealer was contacted; however, the vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure and referred the contact to the federal safety agency Hotline for assistance. The failure mileage was approximately 130,000.
The contact owns a 2016 Chrysler Town and Country. The contact stated that while the vehicle was in reverse(R), the vehicle stalled, and the power steering became inoperable. Additionally, the failure recurred while making right or left turns at various speeds. The contact depressed the brake pedal, shifted to park(P) and restarted the vehicle after each failure. The failure recurred intermittently. The check engine, power steering, and the ABS warning lights and other unknown warning lights were illuminated. While researching on the website, the contact associated the failure with the federal safety agency Campaign Number: 16V461000 (Power Train). The dealer was contacted and confirmed that the VIN was not included in the recall. The dealer referred the contact to the federal safety agency Hotline to report the failure. The vehicle was not diagnosed or repaired. The manufacturer was informed of the failure. The failure mileage was approximately 125,002.
The vehicle will be started and running and shut off. Driving down the road and all of the electrical shuts off, stops running and no gages work. You have to put the vehicle in N and restart. This is extremely dangerous as you never know when it will happen. driving down the interstate at 80mph or driving when you can't just pull over to get started again. Failure in the ignition is what we think. There is an active recall but not for our VIN 2013 Chrysler Town & Country vehicles may stall or shut off while driving due to a known recall regarding a faulty Wireless Ignition Node (WIN) module, which can allow the key to move from the "run" to "accessory" or "off" position.
The tipm fuel pump relay is faulty causing the car to start intermittently. It also stalled on a main road without any warning with my kids in the car. Luckily I was able to put the flashers on and drift to the side and others were able to get around without any accident. However they came close to hitting myself and others. I have spent over $1,000 at this point fixing items that didn't need to be fixed only to finally find out online that others have this issue and its a known issue for Dodge, Jeep, and Chrysler Town and Country but for some reason the recall is only for Dodge and Jeep.
The contact owns a 2015 Chrysler Town and Country. The contact stated that while driving at various speeds, the vehicle shuddered while depressing the accelerator pedal. There was no warning light illuminated. The vehicle was taken to an independent mechanic, where a transmission flush was performed; however, the failure persisted, and the vehicle started stalling after the repair. An independent mechanic was informed about the failure, and the contact was informed that the transmission fluid flush would take a while to take effect. The contact was informed to monitor the issue to see if the failure continued or worsened. The failure persisted, and the vehicle was taken back to the independent mechanic, who diagnosed it with transmission failure. After negotiating with the mechanic about what to do with the vehicle, the mechanic suggested that replacing the torque converter would repair the transmission. The contact agreed to replace the torque converter. Less than a week after the repair, the check engine warning light was displayed on the instrument panel. The vehicle was taken to a local independent mechanic, and DTC: P0868 (Transmission Fluid Pressure Low) was retrieved. The vehicle was taken back to the original mechanic, and the mechanic was informed about the fault code. The contact was then informed that the transmission oil cooler hose assembly needed to be replaced, and the contact had the part replaced. While the contact's husband was driving home after the repair, the vehicle stalled upon approaching a stop sign. The driver continued driving, and the check engine warning light illuminated. The vehicle was taken back to the local mechanic, and DTC: P0868 was retrieved. Upon investigation, the contact discovered the federal safety agency Campaign Number: 16V461000 (Power Train); and associated the recall with the failure. The manufacturer was notified of the failure, and the contact was informed that there were no recalls associated with the VIN. The vehicle was not repaired. The failure mileage was approximately 98,000.
It stalls to turn on even when I changed everything from, fuel pump, fuel pump relay, heater pumps, alternator, new battery. And it still won’t turn on it’s been happening for 4 months now. And I changed things that were recommended. I do my oil change every time I need as well.
The contact owns a 2016 Chrysler Town and Country. The contact stated while driving at an undisclosed speed in traffic, the vehicle stalled. The contact shifted to neutral(N) and was able to drive to the intended destination. The contact stated that while driving and attempting to stop the vehicle, the vehicle required to be shifted to neutral(N) repeatedly. In addition, the contact stated that on another occasion, the vehicle independently accelerated, prompting the contact to immediately depress the brake pedal to stop the vehicle. The contact stated that the failure had occurred several times. In addition, the check engine warning light later illuminated. The contact used a fuel treatment to clean the fuel; however, the failure recurred. The vehicle was taken to an independent mechanic, where it was diagnosed with thermostat and transmission failure. The contact was provided DTC: P0128 with DTC Severity of 2 of 3. The contact was informed that the thermostat and transmission needed to be replaced. The contact stated that only the thermostat was being replaced. The dealer was made aware of the failure and informed the contact that the VIN was not associated with any recall. The contact referenced an unknown recall with a similar failure description, but the VIN was not associated with the recall. The manufacturer was made aware of the failure. The failure mileage was approximately 133,000.
Vehicle randomly shuts off while driving. No warning lights are illuminated. Shutoff can occur at any speed and causes loss of power steering, braking etc. Shutdown requires immediate pull off to the side of the road. Once key is turned off and back on, car restarts.
Related recalls
Engine and engine cooling
- What is wrong
- Chrysler is recalling certain model year 2012 chrysler vehicles, including 200 and town and country models, dodge vehicles, including charger, durango, grand caravan and journey models and jeep grand cherokee vehicles manufactured from august 31, 2011, through september 13, 2011, that are equipped with 3.6l engines. These engines may experience connecting rod bearing failure due to debris inside the engine block.
- Risk
- Connecting rod failure may lead to engine seizure which may increase the risk of a crash.
- Remedy
- Chrysler will notify owners and replace the engine free of charge. The safety recall is expected to begin on or about november 18, 2011. Owners may contact chrysler at 1‑800‑853‑1403.
Recall number 11V487000 · Recall details
Questions about the Chrysler Town and Country stalling
Which Chrysler Town and Country years have engine stalls while driving problems?
The model years with the most reports are 2010 (359 complaints), 2008 (273 complaints) and 2005 (111 complaints).
How much does it cost to fix engine stalls while driving on the Chrysler Town and Country?
Owners who mentioned a price put the repair at about $1,000 (median of 61 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used Chrysler Town and Country?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history