Tl* - the contact' owns 1997 dodge dakota. The contact complained that brake warning light turned on. The contact took the vehicle to two different brake repair facilities, and both stated that the brake warning light stayed on due to the sensor, which meant that the ABS were turned off. The sensor was located on the master cylinder. The contact stated that the repair facilities didn't know why the sensor was failing. When they inspected the brakes they couldn't find anything wrong with the vehicle. Also, the contact stated that while applying the brakes in wet conditions the vehicle had a difficulty stopping, causing it to slide.
1997 Dodge Dakota: ABS light or ABS activating
12 of the 444 complaints about the 1997 Dodge Dakota describe ABS light or ABS activating.
- owner complaints
- 12
- of this car's complaints
- 3%
- recalls
- 2
Is there a fix? There are 2 recalls and 1 service bulletin for this area of the car. See below
ABS light or ABS activating by model year
What owners say
Brake pedal very hard then very soft (pushed to floorboard), ABS & brake light stayed on. Dealer said replace right front wheel speed sensor & brake module @ cost of $1425 + tax. Got 2nd opinion @ independent shop: cable broke near sensor. Spliced break/tested system for $56. System ok.
Abs light illuminated on several occaisions. Brake light also illuminates. Abs pulsation even on dry roads. Front pads and rotors replaced at apprx. 40000 miles. Service technician advised that "dodge rotors do not last very long." engine rattle began about 30000 miles. Diagnosed as a heat shield ratteling. Subsequently diagnosed and a loose timing chain.
Abs light illuminates while vehicle is in motion.
Abs braking system pulsates when applying brakes. This problem is due to a disc which is corroded from the inside and outside with visible blisters which has caused a hole in the plate. Please give any further details.
My ABS and brake light come on while driving. It has been into the dealer 6 times and has not been repaired.I do not feel safe driving this vehicle .I have tried to get it replaced from the manufacturer,but with no luck
Abs and brake light on instrument panel came on. Returned to dealer for service. Returned or remained at service 5 times for repair. Added brake fluid, reset computer, replaced ABS valves, replaced computer. All this over a 2 1/2 month period.
Abs light stays on due to failure of the engine wiring harness.
While driving at 5mph and the consumer went to apply the brakes, and the brakes went straight to the floorboard. By the consumer driving at a low drive, the vehicle stopped. The consumer had the vehicle in the shop twice due to the ABS light coming on, the ABS sensor shorting out, causing the brakes to fail.
Whenever stopping on loose gravel or mainly in reverse, the ABS system does not activate properly. Consumer has taken vehicle in four times for same repairs. Dealership, diablo chrysler plymouth--510‑676‑6800.
Abs brakes failed. In addition, replaced warped front brake rotors.
Abs; first accident occurred while driving between 5-10 MPH applied brakes and hit person in front car. Second time, vehicle impacted at 12:00 position, speed 15mph, applied brakes , experienced extended stopping distance, resulting in loss of control/crash.
Service bulletins that may apply
Related recalls
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Vehicle description: pickup trucks built with 2.5l engines. Some vehicles may have been built with inadequate clearance between the left front brake tube and the power steering hose.
- Risk
- A puncture of the left front brake tube can result in a loss of braking force at the front wheels, increasing the risk of a crash.
- Remedy
- Dealers will inspect the brake tube and power steering hose for wear. If wear is evident, the brake tube and/or power steering hose will be replaced. A power steering standoff bracket will be installed on all vehicles to ensure that adequate clearance between the brake tube and power steering hose is maintained.
Recall number 00V193000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Vehicle description: pickup trucks. Some vehicles may have been built with inadequate clearance between the rear axle vent hose and the brake hose.
- Risk
- A puncture in the rear brake hose will result in a loss of braking force at the rear wheels.
- Remedy
- Dealers will inspect the rear brake hose for evidence of wear. Worn brake hoses will be replaced. The rear vent hose will be shortened by 3 inches and a clip will be installed to assure clearance between the axle vent line and brake hose is maintained.
Recall number 00V198000 · Recall details
Questions about the 1997 Dodge Dakota abs
Is ABS light or ABS activating a common problem on the 1997 Dodge Dakota?
12 of 444 owner complaints about the 1997 Dodge Dakota (3%) mention ABS light or ABS activating. The model year with the most reports is 2002.
Is there a recall or service bulletin for this on the 1997 Dodge Dakota?
There are 2 recalls and 1 service bulletin for the same area of the car. Check them below with your VIN.
Other symptoms on the 1997 Dodge Dakota
Ball joint 118Grinding brakes 15No deployment 13Brake failure 10Fuel leak 10Premature wear 9Stalling 8Airbag light 7Fuel smell 7Headlights 7Adaptive cruise 6Fire or smoke 6Power steering loss 6Harsh shifting 5Jerking 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 1997 Dodge Dakota?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history