Dodge Dynasty recalls
There are 8 safety recalls on record for the Dodge Dynasty, covering 1,328,257 vehicles in total across all the models in each campaign. Newest first.
Dodge Dynasty recalls by model year
All recalls
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- The ABS hydraulic control unit can experience excessive brake actuator piston seal wear causing pump-motor deterioration.
- Risk
- If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.
- Remedy
- Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs.
Recall number 96V099000 · Recall details
Steering: steering wheel/handle bar
- What is wrong
- The zinc plating operation performed on the upper steering column shaft coupling bolt caused hydrogen embrittlement and breakage of the bolt.
- Risk
- Fractures of the upper steering column shaft couplingbolt result in a lack of coupling load on the shaft and loss of steeringcontrol.
- Remedy
- Replace the zinc plated bolt with a phosphate plated bolt.
Recall number 92V015000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.
- Risk
- Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
- Remedy
- Replace the ABS high pressure hose with a hose of different design and construction.
Recall number 91V191000 · Recall details
Visibility: defroster/defogger/HVAC system: fan/motor
- What is wrong
- Water leaking under windshield cowl in area above heater blower motor resistor block results in corrosion of the resistor terminals.
- Risk
- Corrosion of the resistor terminals increases electricalresistance, leading to overheating and possble ignition of the wiring connectorsand insulation, causing a fire in the cowl area.
- Remedy
- The blower motor resistor block will be replaced, and a mastic patch applied to seal the cowl against water entry. Damaged wire connectors will be replaced.
Recall number 91V004000 · Recall details
Seat belts: front: anchorage
- What is wrong
- Front outboard safety belt may become difficult to latch and or unlatch due to a webbing stiffener entering the buckle housing and dislodging the buckle latch guide.
- Risk
- Latch may open during accident or sudden stop, exposingseat occupant to increased risk of injury.
- Remedy
- Replace buckle latch engagement.
Recall number 91V122000 · Recall details
Service brakes, hydraulic: foundation components: disc: caliper
- What is wrong
- Front disc brake caliper guide pin bolts may not have been adequately torqued and could loosen.
- Risk
- This could cause reduced braking effectiveness and couldresult in an accident.
- Remedy
- Properly torque front brake caliper guide pin bolts to 250 pounds.
Recall number 90V162000 · Recall details
Air bags: frontal: sensor/control module-inactive
- What is wrong
- Air bag inflator modules may not contain diffuser holes between the ignitor and propellant chambers.
- Risk
- Air bags would not deploy in an impact situation, which could lead to driver injury.
- Remedy
- Replace air bag inflator modules with properly machined modules.
Recall number 90V080000 · Recall details
Engine and engine cooling: engine
- What is wrong
- The engine valve cover gasket may dislocate and allow an engine oil leak at the gasket.
- Risk
- The leakage of oil in the engine compartment could causea fire.
- Remedy
- Replace gasket cover with revised cover, and rtv sealant will be applied in place of a gasket.
Recall number 89V237000 · Recall details
Questions about the Dodge Dynasty recalls
How do I check if my Dodge Dynasty has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the Dodge Dynasty have?
8, covering service brakes, hydraulic, steering and visibility.
VIN decoder
See the problems and recalls for an exact car
Buying a used Dodge Dynasty?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history