Dodge Neon headlights problems

Filed Dec 10, 2018 · Lights, Suspension · 169,000 miles · NJ

As I was driving down the street, my rear passenger end was leaning a little to the side. I was a smooth paved road and it felt as though I was hitting potholes. I pulled over to the side of the road thought my tire was flat. I t0ok the car to a shop to get checked out. They stated that my rear shot blew. On 11/20/18 my defrosters are no longer working. My headlights are dim. I tried replacing the bulb. However, it still isn't bright enough to drive in the dark.

Filed May 20, 2016 · Driver assistance, Electrical · 150,300 miles · CA

I was driving to downtown los angeles with my friends and all of a sudden there is smoke coming out of my dashboard right in front of my steering wheel something was burning. I then later notice my brake,fog,high beams, and turn signals light do not work. I went on a forum to see if it's a common problem and I saw cars that were burned and I saw that it was a connection that was faulty. I remove my turn signal switch and I found out that it was burned too the exact same place. We were lucky that the car didn't catch fire. I went to a junk yard to see if I could get one and all the dodge neons that I got to they were all shots and burned. I want to get a recall for this that cannot be possible that all the cars even my friends car has that too and it's a dodge neon. Can something please be done about this

Filed Jun 27, 2015 · Lights · 107,326 miles · CA

My headlights are too low. Hard for me to see. Especially when going around a corner, I can't see far enough ahead. Afraid of wrecking. I tried cleaning the outside headlights thinking they may have a film on them, but it didn't help. If their are no reflective markers on the road it is very hard to see the white line.

Filed Apr 8, 2015 · Electrical, Lights · IN · fire

Started vehicle during rainy, foggy, 40 degree weather. Headlamp indicator did not come on within gauge cluster. Upon checking outside the car, only parking lights were functioning despite headlights switch being in the "on" position. Burning smell occurred within 15 minutes of driving and multifunction harness connector is melted.

Filed Jan 24, 2015 · Electrical · 114,000 miles · PA

Odor of burning plastic, caused by overheated wiring (pin 16) on turn signal and light control. Light would only function on low beam ; while high beam indicator was lit . Fog lamps have been lit ,when switch is headlamp on position, for three years. They could not be turned off unless you used left turn signal. When headlamp malfunctioned I bought replacement switch. During installation, found wiring harness terminal was difficult to remove, as it was malformed and brittle due to excess heat. I took pictures to document wire position; there is no pin 15 or 10 : also no wire to terminal positions 15,10, and 12. There is a pin 12 on the switch.

Filed Jan 18, 2015 · Steering · 244,517 miles · AL

As I was driving down the road with my lights on, I began to see and smell smoke coming from steering column. I turn the lights off and the smoke cleared up and went away. After some time, I turned the lights back on with no problem to be found at this time. A week or so later the headlight switch would not work unless you pulled the high beam switch, then and only as you held the switch the lights would work. ( if you have never sit and held the switch while driving at night ( of course ) to get home it is no fun. ) that week end I pulled the covers off the column and pulled the harness out of switch to find it was melted. Needless to say I am down a vehicle until this is fixed. Luckily there was no fire.

Filed Nov 4, 2014 · Electrical, Lights · 200,000 miles · UT

Started to see smoke and then the headlights stopped working properly. After disassembling the wiring connector from the headlight switch, I discovered the connector had overheated to the point it was charred and crumbling to pieces. This is not a misuse by operator, but a safety failure of the electrical system. This could have resulted in a fire as the fuse protecting this circuit did not fail when the circuit obviously overheated and melted and charred the plastic connector.

Filed Aug 8, 2014 · Brakes, Lights · 15,000 miles · KY · 1 injury

Unfortunately I ran into a driver whom was in front of me due to low visibility & bad brakes. My headlights are extremely dull & foggy. Also, whomever own the car before me had the brake vacuum replaced due to recall & ever since I've purchased the car there's been a brake problem. Such as needing a new master cylinder, new propositioning, new brake shoes, and wheel cylinder. I have receipts of all work completed. I have a one year old whom ride along and I'm highly concerned about his safety. I love the car but if it continues I will junk out my car and look to sue dodge chrysler and whomever else associated with the making of the vehicle.

Filed Mar 19, 2014 · Electrical, Lights · 120,000 miles · VT

Smelled hot wiring and headlights stopped working properly. After disassembling the wiring connector from the headlight switch, I discovered the connector had overheated to the point it was charred and crumbling to pieces. This is not a misuse by operator, but a safety failure uf the electrical system. This could have resulted in a fire as the fuse protecting this circuit did not fail when the circuit obviously overheated and melted and charred the plastic connector. I have pictures of the part if you would like them.

Filed Sep 12, 2013 · Lights · 135,000 miles · VA

Tl* the contact owns a 2002 dodge neon. The contact stated while driving various speeds, she noticed that the both low beam headlights would point downward and illuminated an inadequate brightness towards the road. The vehicle was taken to an independent mechanic who stated both head lamps needed to be replaced. The vehicle was repaired; however, the failure persisted. The manufacturer was not notified of the problem. The approximate failure mileage was 135,000.