2000 Dodge RAM 1500 transmission problems

Filed Aug 4, 2018 · Transmission · 199,418 miles · NC

Driving my vehicle down a city street I started to approach a stop sign. As the vehicle came almost to a stop I heard a scraping noise and then the vehicle abruptly stopped. When I pressed the accelerator pedal the engine would rev and the truck would act like it was in park while in "d". I got out of the truck to inspect and found my driveshaft was no longer attached at the rear of the vehicle, to the transfer case. No abnormal noises were heard prior to this, or any running issues that would have indicated a problem. The truck will not move in forward position, but will roll backwards in neutral. Once I was able to remove the driveshaft from the transfer case and inspect, I found that the pinion nut had backed off and was still encased inside the rear flange attached to the driveshaft & u-joint. Fluid had been blown out and covered all of the rear axle and differential. I was able to roll my vehicle in neutral backwards out of the roadway. We hauled vehicle home using one of our other vehicles and a trailer with a come-a-long wench. Vehicle is still not repaired at this time. I have contacted dodge directly at the dealer as well as through their customer service chat. Both instructed me that nothing could be done at this time. It was suggested that I fix the vehicle and that if a recall was released at a later date then reimbursement could potentially be issued. The reason I contacted dodge was due to the fact that this is a known issue with model years that are slightly newer than my vehicle. A recall was issued for almost 300k vehicles for this exact same complaint. I feel dodge should have done further investigation into how long they had been using this particular design for their rear differential pinion nut and extended the recall further.

Filed Oct 17, 2014 · Transmission · 183,000 miles · MT

I was driving down a dirt road at about 35mph. The rear end of my 2000 dodge ram 1500 sport 4x4 started grinding. I started slowing down and the rear drive shaft hit the pavement. I came to a stop and looked under my truck. The rear drive shaft was hanging and the pinion gear was pointed up towards the bed. I tried to move the truck farther off the road and the rear end was froze up. Once I got it to a mechanic we discovered that the pinion nut had backed itself off the pinion gear, causing the pinion gear to get wedged in the other gears.

Filed Oct 31, 2013 · Transmission · OK

Tl* the contact owns a 2000 dodge ram 1500. The contact stated that the vehicle was included in the federal safety agency campaign id number 13v038000 (power train) however, the contact was unable to have the vehicle repaired because the part was unavailable. The dealer was unable to provide an expected date for the remedy part to become available. The manufacturer was not notified of the problem. The contact had not experienced a failure.

Filed May 9, 2012 · Transmission · 180,000 miles · MO

Tl* the contact owns a 2000 dodge ram 1500. The contact stated that the vehicle was making a loud, abnormal noise. The contact was attempting to pull over to inspect the failure when the transfer case exploded. The vehicle was towed to a local mechanic and as the vehicle arrived, the drive shaft detached from the vehicle. The mechanic was unable to provide a cause for the failure. The vehicle was not repaired. The VIN was not available. The failure and the current mileage was 180,000.

Filed Nov 5, 2010 · Transmission · 74,200 miles · CA

Tl*the contact owns a 2000 dodge ram 1500. The contact stated that while driving 15 MPH, there was a squealing noise from the rear of the vehicle. The vehicle was taken to a local repair shop where the contact was informed that the rear differential had failed. The vehicle was repaired. The current and failure mileages were approximately 74,200. Updated 1/21/11 the clutch pack retainer failed and had to be replaced as well as the entire differential post unit. Updated 03/23/11

Filed Jan 14, 2010 · Transmission · 84,000 miles · CA

Truck purchased in 1999. Maintained regular recommended scheduled service. 2006, tcc transmission solenoid needed replacement. 2007, tcc solenoid replaced again. 2007, transmission with 84,000 miles needed replacement. Jan 2007, contacted chrysler corp for split of cost for new transmission. (denied). 2007, second new transmission replaced. 2008, long cracks on dashboard. 2009, compressor, clutch fan and AC system replaced. 2009, front and rear passenger speakers inop. 2010 second transmission slipping, od light and tran temp light on at 33,000 miles on new transmission.

Filed Sep 29, 2008 · Transmission · 80 miles · VA

I bought a 2000 dodge ram 1500 4x4 truck. It was 2 yrs this may/08, it is now in the transmission shop getting a rebuilt tranny at the tune of $3k. The electronics went out and it was full of metal!!! It had low mileage when I bought and seemed in great shape, boy was I screwed. One week after buying it I called clarke motors in virginia to tell them about this light coming on and they told me it was nothing , just a computer sensor - not to worry about it. It is a [xxx] crime that this company continues to build faulty vehicles and puts the consumer as well as their employees at risk. Where is the class action??? Where do I sign up? *tr information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).

Filed May 21, 2008 · Engine, Lights · 400 miles · AZ

Tl*the contact owns a 2000 dodge ram 1500. After putting 400 miles on the vehicle, it began overheating while driving uphill at an unknown speed. The vehicle was taken to the dealer and they replaced the transmission cap. When the windows were rolled down, they would not go back up. In addition, the headlights would dim when the windows were rolled up and down. While driving between 5-10 MPH uphill, the exhaust system fell off the vehicle. The bolts were not properly tightened. The cd changer had to be replaced after failing twice. There was also a grinding noise in the transmission when the shifter was placed into gear, and there was a hesitation when placing the gear into reverse or drive. The transmission has been rebuilt, but the vehicle is still grinding and hesitating when placed into gear, drive, or reverse. On may 22, 2008, the vehicle will be taken to the dealer for the driveshaft to be replaced in hopes that the grinding will cease. The current mileage was 73,500 and failure mileage was 400.

Filed Feb 8, 2008 · Body, Brakes · 74,000 miles · NC

First is the dash. I bought the truck in feb 04 with 74,000 miles on it and shortly after I noticed a crack in the dashboard, since then the dash is falling apart and is more brittle than a sporting clay. If you snap off a piece and look at it you can see that about 1/5th of the way down from the top is brown since it has cooked in the sun. So that proves that dodge uses very cheap plastic for the dashboards. I looked into replacing it about 6 months ago and the top piece of the dash cost about 200$ and now that I have gotten my tax returns back I was going to get a new one but the price is now 375$. I guess dodge finally realized the problem with these dashboards and decided to cash in on them. The torque converter went out on the drive home from the dealership also, but 50 bucks from me and 2100$ from the warranty people fixed that. Second is the asd relay which means automatic shutdown relay and it isn't kidding with the name. A couple years ago when I started my truck it would shut off right away and wouldn't run right until I feathered the gas for a little bit, after replacing the throttle body control solenoid, the idle air control motor and mass air flow sensor I did a little more research and found it to be a 10 dollar relay from napa. The third problem is a whooping noise coming from the engine that I still can't figure out what it is. The truck makes the noise when its sitting still so I know its nothing in the suspension, although its louder when idling over small bumps. The fourth was the speed sensor in the rear differential, ABS and brake light came on but didn't affect performance at all, replaced the sensor and didn't have any more trouble from it. Fifth problem is the back window leaks but I'm going to fix that with a generous blob of welder glue inside when I finally get around to pulling the headliner down.

Filed Jul 19, 2007 · Body, Transmission · 77,464 miles · FL

The dashboards of our dodge survey truck have failed and had to be replaced at our expense. Not only have the dashboards failed but the transmissions as well, and again replaced at our expense.