2004 Dodge RAM 1500 acceleration problems

Filed Oct 29, 2018 · Acceleration, Steering · 301,932 miles · GA

Tl* the contact owns a 2004 dodge ram 1500. The contact stated that while driving out of the driveway, an abnormal squeaking noise occurred coming from the steering wheel. The contact also stated that when making turns, an abnormal scraping noise occurred coming from the steering wheel. There were no warning lights illuminated. In addition, the contact also stated that while the driver was at a stop light and to go the vehicle jerked, then failed to accelerate. The contact coasted to the side of the road powered off the engine. The vehicle was restarted and was able to drive normally. No warning lights illuminated. The contact called hayes chrysler dodge jeep ram of gainesville ((770) 535-2835, 3115 frontage rd, gainesville, ga 30504) where it was determined that the VIN was not included in a recall. The vehicle was not taken to a dealer. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 301,932.

Filed Oct 30, 2017 · Acceleration, Electrical · 130,000 miles · AL

Turn signal, winshield wipers, and speed control has a mind of their own. Half the time not working the rest of the time the when signaling to turn right the right dont work then when signaling left the right side blinks instead of the left. The winshield wipers just randomly swipe sometimes when not even cranked and keys not even in the ignition.

Filed Nov 13, 2015 · Acceleration, Electrical · 77,000 miles · NY

Tl* the contact owns a 2004 dodge ram 1500. The contact stated that the vehicle stalled, the cruise control failed, and the speedometer failed to function properly. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failures. The failure mileage was 77,000.

Filed Nov 6, 2015 · Acceleration · 101,000 miles · PA

Tl* the contact owns a 2004 dodge ram 1500. While driving 60 MPH, the vehicle stalled. The contact stated that the failure occurred numerous times. In addition, the contact stated that the vehicle would not accelerate for a brief moment and then accelerated rapidly without warning. The vehicle was taken to be repaired, but the mechanic could not find a failure. The manufacturer was made aware of the issue. The failure mileage was 101,000.

Filed Aug 25, 2015 · Acceleration, Engine · 16,200 miles · IN

While pulling out of a parking lot to proceed on a main road the vehicle died when I attempted to pull out and cross multiple lanes of on coming traffic. I pushed the accelerator and the truck briefly accelerated and then just died. I was able to put it in neutral and restart the engine. I purchased this vehicle with approximately 6500 miles on it and now I have 204000 . This is the 4th occasion it has stalled while at low speed for no reason. The latest occasion just occurred on08/11/15 while I was going threw a round about. I entered the round about turning slightly to the right ,half way around coming out of the turn as it was straightening the truck just shut down. In all the occurrences I have been traveling at lower speeds 30 MPH or less. 2 almost causing a crash with another vehicle. On the last occurrence I was able to restart the truck while coasting in neutral ,even though the side of the dash that the gear range is burnt out so you cant actually see what gear you are in. All the times it has stalled it has been during summer months hot outside and no precipitation. At times the truck will hit a low RPM while at an idle but will recover. The vehicle has gone years in between stalls first 2 when the truck had less than a 80k, and the last 2 stall outs about a year apart. No codes stored in the computer. Totally random events.

Filed Aug 16, 2015 · Acceleration, Transmission · 133,000 miles · KY

My family and I was driving down the road. (we had just had the truck serviced about 4 days prior at our local dealership.) all the sudden the truck makes this sound. I slowed down, rolled my window down trying to figure out if it was my vehicle or not. Very faint at first and increased with a loud boom. I get out to find my drive shaft on the ground. And the pinion nut nowhere to be seen. Gone. Luckily we were on a country road and my family is safe.

Filed Jul 11, 2015 · Acceleration, Transmission · 80,000 miles · CA

Was driving at about 25 MPH had just made a left turn, and out of no where my truck went side ways heard a screeching tire sound then a bang, then the whole truck started to shake very violently. I braked immediately and the banging continued, I was in the middle of the roadway and tried to give it gas to get to the edge of the street but the banging go worst, turn off and exited the truck, noticed a big piece of metal in the middle of the road along with a lot of oil , ran up to it to only notice it was half of my drive shaft, it had snapped in two still attached to a piece of the rear end, along with fragment pieces all over the floor of the differential housing, seemed like something blew up in the differential. I looked under the truck and noticed the banging noise and violent movement was coming from the other half of the drive shaft that was still attacked to the transmission that was still spinning when I had it in gear. The car behind me had to avoid the drive shaft that snapped off since he said it flew out the rear of my truck as I was driving. Had to get towed home and have the differential oil cleaned of the road way. I went home and notice there was a recall for this very same thing at it covered trucks manufactured january 28 of 2004 through august 3, 2005, my truck was manufactured april 2004 so it should be covered but the dealer and manufacture are giving the run around. Please help!

Filed Jan 15, 2015 · Acceleration, Engine · 198,000 miles · CA

While coming to a stop, the truck lost all power and stalled. I immediately restarted the truck and proceeded to the next intersection, and it lost power and stalled again while braking to a full stop. I was able to make it two miles closer to my home, came to a stop and the engine revved up slightly, and then idled low to the point where I thought it was going to stall again. I got it home and had it towed to my mechanic. The truck was checked out, the truck did not stall after repeated testing for the next week. I picked it up, got a quarter mile down the road and it lost power and stalled again. I immediately returned it to the mechanic and, again, the truck did not duplicate the stalling, but the mechanic did see it rev up when coming to a stop. The mechanic replaced the idle positioning sensor and I picked up my truck only for it to stall on my way home. My mechanic has had my truck more than I have over the last two months and the problem remains undiagnosed. After basic research on dodge forums, this is a problem that many other people are dealing with and nothing has been done to address this issue. This is a major safety issue considering that the truck loses power and stalls without warning in the middle of turns and coming to a stop. Please help resolve this issue before it costs someone their life. I am not the only person having this problem.

Filed Mar 30, 2014 · Acceleration, Engine · 86,400 miles · NC

While driving in my neighborhood at 25 MPH vehicle lost power and didn't want to take the gas then cut off. Would not restart , engine would rotate but not start. Pumped the accelerator then engine restarted and ran rough with no power . Had vehicle towed to dealership to be check. I was told that the engine was blown . When I check the dash the throttle elec. Light was on.

Filed Aug 26, 2013 · Acceleration, Engine · 95,000 miles · UT

In the fall of last year the check engine light came on in my 2004 dodge ram 1500. The code that came up was misfire in cylinder 8. I took it to a mechanic and they said it was the fuel injector which they replaced. A few days later after getting my truck back the light came on again. This time the code was misfire in cylinder 6. I took it to a very trusted mechanic who stated it was a rocker arm that had come off due to junk in the engine. Once it was fixed again the light came on saying misfire in cylinder 8. The mechanic said it was the rocker arm on that cylinder and replaced it. This happened 4 more times in the next month. The mechanic, who is very reputable, believes this is a manufacturing defect that will continue to occur no matter how often it is repaired. He also stated he has seen this in many many dodge trucks and most notably in the 474 engine. It is an engine and safety issue due to loss of throttle which occurs very often when the problem is on going and is definite risk of causing an auto accident. This code is coming up every other day now and I believe it needs to be recalled.