Poping noise in the steering while the vehicle in motionand dealership charge me $1,642.00
2010 Dodge RAM 1500 steering complaints
Page 2 of 3: complaints 11 to 40 of 41, newest first, as owners wrote them.
Truck will start, run, and drive. But while you are driving with no warning it will die, leaving you without power steering and power brakes. Put in neutral and it will start back up. You can't guess when it will die, or how many tries it will take to start again. It doesn't matter if you are in motion, turning, going fast or slow, or stationary. The problem happens in all situations.
2010 dodge ram 1500 with 61,000 miles with the steering column bearing failing- through research other 2010's are having the same issue. The steering wheel is popping, grabbing and catching. Called manufacturer they said out of warranty, not their responsibility- starting to feel dangerous to drive
Safety recall 12v‑474 for 2010 ram 1500 could not be performed due to parts not available. Currently, safety recall 17v‑821, which could case a parked vehicle to suddenly roll away, does not have a remedy due to lack of parts. Both of these recalls are either unable or were unable to be performed due to lack of parts. 12v‑474 is the exact same recall as 12v474000, chrysler number m34, "the nut securing the rear axle pinion my loosen because an adhesive patch was not installed during vehicle assembly. If the nut loosens, the axle can lock up with little warning, resulting in a loss of vehicle control and/or a crash". I was told by chrysler recall group that my vehicle is not eligible for the buyback program, even though my vehicle is the same model year with the same recalled issue (12v‑474) loose pinion nut as those eligible. In addition, there is now another drive train recall for which I cannot receive repair due to lack of parts.
Tl* the contact owns a 2010 ram 1500. While driving 25 MPH, the vehicle hit a bump in the road and the front driver side tire detached without warning. The vehicle was towed to mac haik dodge chrysler jeep ram (11000 north fwy, houston, tx 77037 (281) 447-9500) where it was diagnosed with a front driver side ball and tie rod fracture that needed repair. The vehicle was currently at the dealer for repairs. The contact found the federal safety agency campaign number: 10v657000 (steering) online at the manufacturer was notified and informed the contact that the VIN was not included in the recall. The failure mileage was 111,000.
This vehicle has a binding wireless ignition module (win) resulting in a condition where the key may be removed from the ignition switch prior to placing the shifter in park. Exactly the same as the federal safety agency recall reference #10v200000. This vehicle simply does not have the matching part numbers of the recall. But exactly the same thing happened and wireless ignition node (win) needs to be replaced.
When travelling at apprx 65mph after about an hr commute, the truck started shaking/trembling badly, steering wheel shaking side to side, I had to drop my speed to 25/30 MPH to regain control of steering and shaking... After about 15 mins or so, it was back to normal... But once I started travelling again same distance & MPH the issue started again... This issue is random, there are times it does it and times it doesnt, but most times its once the vehicle is at a high speed.
Tl* the contact owns a 2010 ram 1500. While driving between 20 and 65 MPH, the vehicle began to sway all over the road. The failure also occurred when turning corners. The vehicle was not taken to a dealer. The manufacturer was not made aware of the failure. The failure mileage was 110,000.
2010 dodge ram 1500 hemi traveling at highway speed when instantly the gauge cluster started acting erratic. First the tire pressure display said that different tires were showing a multitude of different pressures the gas gauge started flickering between full and empty as well as the stop working of the speedometer and tachometer air-conditioned, power steering and continual windshield wiper on even though they were off at the switch. Radio intermittently on and off and ABS and airbag light on and off intermittently. All four windows fail to operate and interior lighting will not come on. Gauge function fluctuates every couple second.
Trying to do buyback program. I paid over $37,000, only have 55000 miles , good condition and only being offered $12000. I still owe $3025.00 on my loan. I thought it was fair market value? Please help. I have 6 kids I drive every day to 3 schools plus work. The trucks steeering is loose, brakes are crazy and im afraid im going to loose control or not be able to stop but the offer is rediculous.
The 2010 dodge ram 1500 has suspension problems with the front ball joints being too small. This leads to my truck skipping on the highway and any bumpy roads and has caused me many, many times to suddenly loose control. On bumpy dirt roads it can happen at 35-45 MPH. On the highway it is very bad between 55-60 MPH if you hit any bump or even in a tight curve. This truck is highly unstable. When pulling a boat where less weight is on the front wheels, it multiplies the problem. I am forced to never go faster than 50mph on any curves that are remotely sharp. The second problem is not a active safety problem but is a horrible problem for emission. My truck has the infamous hemi tick. This is caused by faulty manifold bolts that either back off, rust off, or break off leaving gaps between the head and the manifold. Co2 is leaking out of the engine prior to going into the exhaust system. The epa should get involved...
Tl* the contact owns a 2010 dodge ram 1500. While driving at approximately 10 MPH, the steering wheel seized without warning. The vehicle was taken to an independent mechanic where it was diagnosed that the front lower control arm and rack and pinion were fractured and needed to replaced. The vehicle was repaired but, the failure recurred. The manufacturer was made aware of the failure. The failure mileage was 62,700.
Tl* the contact owns a 2010 dodge ram 1500. While driving at an unknown speed, the steering wheel shook violently. The vehicle was towed to an independent mechanic who inspected the vehicle and discovered that the front tie rod assembly failed, which caused the steering bearing assembly to fail. The steering assembly and the front tie rod assembly were replaced. The contact also stated that the engine stalled numerous times while driving; however, the independent mechanic was unable to locate a failure code for the engine failure. The manufacturer stated that the vehicle was not included in the federal safety agency campaign number: 13v529000 (steering). The failure mileage was 83,600.
Driving on the freeway approximately 70 MPH I hit a few bumps causing a wobble in front end and steering making the truck almost jump out of its lane. This caused other cars to swerve. No accident but this is a major safety issue.
Tl* the contact owns a 2010 dodge ram 1500. While driving at 65 MPH, the steering wheel would vibrate and the front wheels would wobble. The vehicle was taken to an independent mechanic for inspection. The technician was unable to duplicate the failure. The vehicle was included in the federal safety agency campaign number: 10v657000 (steering) however, the recall remedy failed to fix the failure. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 48,000.
I was driving down the road when all of a sudden my front end started to shake violently, I started to slow down but it didn't help until I came to a complete stop . I then heard light grinding coming from my front left side of truck. Before I could make it home witch was about 10 miles, the grinding and loss of steering had got so bad that I was driving 5-10 miles an hour. Barely made it home. The next morning I drove it to the best service shop in town which was 1/2 mile from where I lived and it took them a month and $1700.00 later to repair. Front axle,front bearing,calipers, a new disc and brakes,a front nuckle and drive spindle for the 4 wheel drive.
I parked my vehicle, turned it off went inside for a few minutes. Came out started it up. With my foot on the brake, I tried to put it in gear (automatic transmission) would not go in gear the shifter wouldn't move. I tried a few more times and it finally went into gear. This has happened 2 times on the same day on 3 different days.
While exiting off route 37, my vehicle completely shut down. This is the second time this has occurred the last being august 1, 2015. I checked the battery cables both times and they are still tight. I had to put the vehicle in park to start back up.
The steering wheel pops and clicks when turning and will suddenly changes lanes.when putting it in park the gear shift will not allow the key to come out of the ignition switch.the ram 1500 should have a steering recall just like the rest of them they use the same parts.
Violet shaking of the whole vehicle, and won't stop until you slow, more riders-worse the affect.
Wife was driving done the rode at about 35 miles and the truck went dead , no power steering or brakes. Pulled it over and it started right up. Brought in to dodge dealership and the replaced something in the computer and said it was fixed. I was driving it on the highway the next day and it died on me crossing the highway, semi truck almost killed me, put it in park and it started right up. Took it to the dealership and they said it was the spark plugs, dished out 225 dollars for that, said its fixed again. Did it again to my wife the next day with my kids in the vehicle. Brought it back in dodge had it for two weeks, know there telling me its the fuse box module at 1400 dollars. Don't know what to do, talking to dealership manager about wife not feeling safe in the vehicle, she said electrical work is hard to find out what's wrong with it. Don't know what to do know, you spend 30,000 plus on a vehicle you would thing they dodge or chrysler would back there vehicles before someone gets killed with this truck.
Tl* the contact owns a 2010 dodge ram 1500. The contact received a recall notification for the federal safety agency campaign id number: 13v529000 (steering) and stated that the part needed was unavailable for the recall repair. The manufacturer was not made aware of the issue. The contact did not experience a failure.
Tl* the contact owns a 2010 dodge ram 1500. The contact stated that she was concerned for her safety since the parts were still not available to do repairs for recall the federal safety agency campaign number: 13v529000 (steering). The dealer was contacted. The manufacturer was made aware of the problem. The vehicle had not experience the failure. The vehicle current mileage was 110,000.
We were driving our 2010 dodge ram 1500 on a county highway when we heard a loud whirring noise. As we approached a downhill section and my husband took his foot off the gas the noise went away, but came back louder as soon as he put his foot on the accelerator. Instantly there was a big boom and the rear end of the vehicle locked up, the front end of the vehicle swerving with the back end jack knifing on the road while bouncing/bucking like motion given the tires felt as though they were also locked up. We could feel and hear something under the car bashing the undercarriage. There were no oncomers fortunately and my husband did manage to stop the vehicle just short of the guardrail and going over the ravine. The car was still half in the lane .. Horizontal to oncoming traffic. He turned on the hazards and I jumped out, it was dark with no lighting on the road and hard to see until the car behind us stopped to see if we were ok and said our drive shaft had disconnected. We removed our 2 young children from their carseats, waited on the side of the road and the men tried to move the truck out of oncoming traffic but the tires were locked. We called 911 for the police to give our children a safer place to stay out of oncoming traffic and to provide direction to oncoming traffic as we had a tow truck come out to bring the car to the nearby dodge dealership. The dealership looked at the car, informed us it was part of a recall but they didn't have the parts to fix it in stock. They did not offer an alternate vehicle to us and we are still awaiting word on what is happening at almost a week after this incident took place. For me the integrity of the entire drive shaft, undercarriage and all equipment/components of the vehile, tires which were showing signs of extreme wear and low on air are all now compromised.
Just bought this truck a few months ago and the rack and pinon steering rack is leaking and now has to be replace by the dealership.
Leaving work,I attempted to turn at intersection and steering seemed to lock, then I was able to turn with great effort.took to dealership and was told rack and pinion unit had failed.at 47000 miles this seems to be a manufacturing defect that needs attention before someone is seriously injured.
I own a 2010 dodge ram slt. I recently had it in to have the rear axle pinion nut replaced and was told I have bad tie rod ends. At 46,000 miles I found this hard to believe. After further investigation it was accurate that my tie rod ends were bad. I replaced both tie rod ends at 46,000 miles. Then had to pay for an alignment of course. This is a huge concern for me because I transport my children to and from school daily. How is it possible that at 46,000 miles my tie rod ends need replacement. This could have also LED to my tires needing to be replaced at 36,000 miles even though they were rotated every 6 k. Chrysler has issued a recall for ram 2500 and up for replacing the tie rod ends because of moisture and dirt that gets into the ball and socket. Maybe they should have included the 1500 as well.
Rear axle pinion nut recall - known to cause accidents upon failure - 4 cases already. Manufacturer acknowledged the safety recall in january 2013 and sent out safety recall notices to all consumers that the recall affects. I have called the local dealerships numerous times regarding the recall and they simply say that the parts are not available. Nine months after the recall notice distribution I contacted dodge corporate to find out why the parts are not available and they state that dodge has failed to secure a vendor to supply the product. This concerns me a great deal that dodge puts the consumer in danger by not being responsible and making the repairs needed. This recalled part can cause a driver to lose control of their vehicle and injure themselves as well as others.
The vehicle started making a grinding sound, then started jerking right before it abruptly came to a complete stop. Upon getting out of the vehicle to see what had happened, the rear drive shaft was disconnected from the truck and hanging down on the road. We then tried to put the vehicle in neutral and push it off of the main road we were on to a safer side road. The truck was completely locked up and would not move forward or backwards. Upon researching the problem, it has came to my attention that this is part of the safety recall that has been issued by dodge.
Tl* the contact owns a 2010 dodge ram 1500. The contact stated that while driving approximately 50 MPH, the brakes and the steering wheel failed without warning. The contact crashed into another vehicle. There were no injuries reported. The vehicle was taken to the dealer on several occasions where the failure was unable to be duplicated. The manufacturer was made aware of the failure and sent an investigator to further inspect the vehicle, but the investigator was unable to duplicate the failure. The vehicle was not repaired. The approximate failure mileage was 7,000 and the current mileage was 47,000. The VIN was not available.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2010 Dodge RAM 1500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history