Tl* the contact owns a 2010 ram 1500. The contact stated that the steering wheel failed. In addition, while driving the steering wheel emitted a humming noise and the rear suspension emitted a knocking noise. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 53,000.
2010 Dodge RAM 1500 suspension complaints
Page 2 of 2: complaints 11 to 29 of 29, newest first, as owners wrote them.
Trying to do buyback program. I paid over $37,000, only have 55000 miles , good condition and only being offered $12000. I still owe $3025.00 on my loan. I thought it was fair market value? Please help. I have 6 kids I drive every day to 3 schools plus work. The trucks steeering is loose, brakes are crazy and im afraid im going to loose control or not be able to stop but the offer is rediculous.
The 2010 dodge ram 1500 has suspension problems with the front ball joints being too small. This leads to my truck skipping on the highway and any bumpy roads and has caused me many, many times to suddenly loose control. On bumpy dirt roads it can happen at 35-45 MPH. On the highway it is very bad between 55-60 MPH if you hit any bump or even in a tight curve. This truck is highly unstable. When pulling a boat where less weight is on the front wheels, it multiplies the problem. I am forced to never go faster than 50mph on any curves that are remotely sharp. The second problem is not a active safety problem but is a horrible problem for emission. My truck has the infamous hemi tick. This is caused by faulty manifold bolts that either back off, rust off, or break off leaving gaps between the head and the manifold. Co2 is leaking out of the engine prior to going into the exhaust system. The epa should get involved...
While travelling on a highway (straight away) my left front wheel bearing let go causing tire and rotor to disconnect from vehicle causing significant damage. After having the vehicle towed to the nearest dealership they discovered that the front right wheel bearing was in very bad shape, needing replacement. Vehicle has under 65000 miles on it. Previous bearings on dodge ram trucks have been recalled for similar issues. There was no previous vibration or steering issue until the wheel came loose.
Tl* the contact owns a 2010 dodge ram 1500. While driving at approximately 10 MPH, the steering wheel seized without warning. The vehicle was taken to an independent mechanic where it was diagnosed that the front lower control arm and rack and pinion were fractured and needed to replaced. The vehicle was repaired but, the failure recurred. The manufacturer was made aware of the failure. The failure mileage was 62,700.
Tl* the contact owns a 2010 dodge ram 1500. While driving at an unknown speed, the steering wheel shook violently. The vehicle was towed to an independent mechanic who inspected the vehicle and discovered that the front tie rod assembly failed, which caused the steering bearing assembly to fail. The steering assembly and the front tie rod assembly were replaced. The contact also stated that the engine stalled numerous times while driving; however, the independent mechanic was unable to locate a failure code for the engine failure. The manufacturer stated that the vehicle was not included in the federal safety agency campaign number: 13v529000 (steering). The failure mileage was 83,600.
Tl* the contact owns a 2010 ram 1500. The contact stated that while driving approximately 65 MPH, there was sparks coming from under the hood and the steering wheel became extremely difficult to maneuver. The drive shaft had detached from the vehicle. The vehicle was towed to the dealer but was not diagnosed or repaired. The manufacturer was notified of the failure. The approximate failure mileage was 25,000. ..updated 09/03/15 *bf
Ignition turns off vehicle loses all power, loss of steering and brakes, I have to wait for vehicle two come to a stop place a neutral and restart dealer has no idea why this happens also front tire rods keeps coming loose, I had front end repaired several times
On 11-8-14, I took a 2010 dodge ram 1500 truck in for engine repairs. The mechanic noted both front lower ball joints needed replaced. A search for the needed parts revealed no replacement parts available for at least 30 to 60 days. Four weeks later on 12-5-14, a fluid leak was noted from the front end. It was found that the right front axle seal needed replaced immediately, due to a heavy leak.the normal repair would involve replacing the lower front ball joint to enter the axle to get to the seal. This could not be done since no lower front ball joints could be found to complete the repair. The mechanic accessed the axle seal by going thru the top of the axle. The seal will again have to be replaced when lower ball joints become available, at a cost of an additional $150. This situation presents a risk to the driver and motoring public, since the necessary parts can not be sourced. It creates a risk that the lubricating fluid inside the axle will leak out, which could result in the axle "tying up," causing the driver to loose control and crash. Chrysler will not, or can not make the necessary parts available to its dealers or independent mechanics. There are also no "after-market" parts on the market that could be used to safely complete repairs.
Violet shaking of the whole vehicle, and won't stop until you slow, more riders-worse the affect.
Tl* the contact owns a 2010 dodge ram 1500. The contact stated that while driving approximately 5 MPH, the front passenger's side wheel fractured while completing a turn. The vehicle was towed to an independent mechanic, who diagnosed that the lower control arm, cv axle and the passenger's side fender needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the problem. The approximate failure mileage was 71,493.
Tl* the contact owns a 2010 dodge ram 1500. The contact stated that while driving 70 MPH, the rear wheels seized. The vehicle was towed to the dealer for inspection where they stated that the pinion nut had become detached and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 35,879. The VIN was unavailable.
While driving my 2010 dodge power wagon ( cc, 5.7 liter engine with no modification) at highway speeds I hit a small bump and the front end began to "shimmy", really bounce out of control for a moment or two. I slowed down, gripped the steering wheel and it eventually settled down. This "shimmy" isn't consistent as it does not always happen, even over the same bump on the road. Help.
Tl* the contact owns a 2010 dodge ram 1500. The contact stated that while driving 40 MPH, the rear of the vehicle lifted from the ground and dropped. The vehicle was towed to the dealer where the failure was located at the rear differential bolt, which had become separated from the drive shaft. In addition, the transfer case was also damaged. The vehicle was repaired. The manufacturer was made aware of the failure. The failure and current mileage was 44,036.
This is to file a complaint about our recall on n08/the federal safety agency 13v‑038 notice on april 22, 2013. We have taken the truck twice and have been told burns motors that they do not have the parts. We are just documenting that we are still pending this recall.
Tl* the contact owns a 2010 dodge ram 1500. The contact stated that while traveling approximately 65 MPH, the contact heard a loud boom as the rear end dropped to the ground. The vehicle was moved to the shoulder and upon inspection, it was found that the pinion nut had failed. The vehicle was not repaired. The manufacturer was contacted about the failure. The failure mileage was 20,074.
I can not understand why it is taking so long to get this recall fixed on my truck. I have been calling every since they mailed it to me. I am always told so sorry we are still trying to get the parts shipped out to the dealers. Oh we do not know what is taking so long, oh yes we will call you when the parts are ready. Well this recall has been going on for quite some time now and I do not understand why they are so far behind. It says my rear axil can freeze up and cause a major accident...so if this is true then why do they not have the parts after this long? There has been no problem with the truck yet but then I do not drive it very far since it may lock up the rear end and cause me or my family to be hurt...along with someone else in their car!!!! I call my local dealer and I get the same crap for an answer.....
While I was driving on a highway, I heard a terrible sound out of the rear of my ram truck. I tried to stop my vehicle as soon as I could while the sound kept on getting even more terrible. When I stopped and looked at the bottom of the vehicle, the driveshaft fell off from the rear of the vehicle and oil spilled on road. There was no warning or no engine light signal in the vehicle electronics before or after this happened. Has the vehicle been on a freeway with a speedlimit of 100 km/hr or so, I think it would have been really tough to control the vehicle in this break-down and it could have resulted in a fatal accident. The vehicle was not in a position to be driven further and I had to get it towed to a nearest chrysler dealership in coquitlam, british columbia, canada. It has been days now and I have not yet heard back from chrysler dealership that what is the cause of this problem and what will be done to fix this issue. On checking with dealership, they say that they have no solution to this problem till now. Luckily, my vehicle is still inside the warranty period and so the dealership says that the cost to repair will be covered, but they have no fixed timeline on how soon they can fix it. I tried reaching out to chrysler and filed a complaint about this, but the response from chrysler is not very helpful and they are not at all worried about my sufferings and loss that I am currently facing due to this vehicle not being available/ready for my use yet.
Tl * the contact owns 2010 dodge ram 1500. The contact stated that while driving 30 MPH during inclement weather, the rear axle fractured in half and caused the vehicle to stall. The vehicle was towed to the dealer but not repaired. The failure and current mileage was 8,500.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2010 Dodge RAM 1500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history