My 1999 dodge ram 2500 slt turbo cummins diesel. Over $11,000.00 in maintenance in 5 years @ 122,000 miles. Most recently fuel pump, turbo injected over a $3,000.00 bill. 30 days ago it was $3,000.00 and several other issues.
1999 Dodge RAM 2500 engine complaints
Page 2 of 2: complaints 11 to 26 of 26, newest first, as owners wrote them.
The engine surges periodically, sometimes when going down the road. I believe if the throttle jams wide open injury could occur and vehicle would be uncontrollable. Diagnosed as a faulty throttle position sensor. Contacted the dealer, not under warranty, cost to replace, $550.00. Contacted chrysler, nothing can be done, except my paying for replacement.
Coolant loss, small amount at first. Inspected hoses, thermostat, core plugs and radiator for coolant seepage possibilities, labored to no avail . Over a period of time, it was brought to my attention a small crack in the block and through researching I have this information. My block is cast in brazil by a company named "tuby" and is identified by a #53 numbered on the block. It has become apparent to me that these are defective due to weak casting that resulted in thinner water jacket walls than other blocks so with coolant cavitation, corrosion, coolant pressure in the block, and torque they are more prone to crack. Chrysler will not honor my warranty, it has been more than 5 years but the mileage was at 94,891. Cummins powermaster advised me to take it to a local dealer in tampa and I did. They did a coolant pressure check and verified the cracked block. Cummins powermaster has offered to replace the block but I would be responsible for labor and other related cost in the neighborhood of $4,500. Cummins admitted to me that there are problems arising with these #53 blocks. I also have review other complaints on a question and answer diesel website and noted several complaints to the federal safety agency. If the numbers are legitimate there are about 100,000 blocks affected. It would be of interest to know how many of these blocks were replaced by chrysler while under warranty and how many cummins have replaced without charge to the consumer. I think it to be a symbolic gesture from cummins to want to assist me in this matter. I was told that if cummins had the warranty, my block with hole like that, even if it had 200,000 miles would be replaced absolutely free. Cummins does have a reputation to maintain since it is their 24 value cummins engine in the dodge ram. Chrysler wants to take no responsibility for the problem or even acknowledge the defect in manufacturing of this #53 block. Sb
Dt: block #53 on the 1999 dodge 2500 ram has a crack. First noticed last year, and crack is larger now and antifreeze pours out.
I have a 1999 dodge 2500 with a 24 valve cummins motor. I started to notice coolant loss and found a crack on the passenger side of the block behind the heat exchanger. I have since found this to be a very common problem with 99 - 01 with a 53 casting . I went to dealer, only to find I was just out of warranty. I wrote to daimler/chrysler and to quote "we are starting to see several of these appear and have approached cummins about this problem, but at this point they are dragging their feet on restitution or resolution." I talked to cummins and they said per their original contract they sold engines with no implied warranty to dodge, as they said they wanted to handle all warranty issues. They both agree that their was a defect with that casting and have corrected it on other years. I am looking at a $5000 plus repair bill that is not a wear issue, but a defect.
I have a cummins diesel. It has a 53 block. There was been alot of reports of these blocks cracking. I paid over $5000 for this option. It costs over $7000 to get it fixed. I don't have a problem yet. Just feel like I'm driving a time bomb. Chrsyler refuses to help any of the poor guys with this cracked block. This is a serious isssue of a defective block. Please help all of us with the 53 block.
All the brake components except the master cylinder were replaced 7 times starting at 7,000 miles because they either locked up or didn't function at times. An accident occurred due to this failure. Also, automatic transmission was replaced/rebuilt 8 times because it blew out, slipped, or dropped down from o/d to regular gear, which started at 5,000/20,000 miles finally, the engine head was replaced twice because it cracked on both sides, which started at 77,000-90,000 miles.
I and many other owners of 1998 thru 2001 dodge cummins diesel vehicles have or will experience a known defect of the designated 53 block in these vehicles. The 53 block can develop a crack behind the heat exchanger on the passenger side which results in coolant loss and a replacement block. Mine cracked at 5 years 2 months and 53k miles. Standard warranty for these engines is 5 years 100k. I like many owners have had to pay anywhere from $2000.00 and up to have a known defect repaired as chrysler will not cover the known problem if over the 5year 100k limit. There are many unsuspecting people out there that may not know of this defect and many used vehicles on used vehicle lots that may be sold to people that are unaware of this problem. Cummins has given some assistance, chrysler has given none. Either way the consumer still pays for the defect of an engine that was touted to last at least 350k miles and in my case only 53k. I paid an additional $4600.00 for the diesel option and then paid an additional $2400.00 to have the defect repaired. Like their present balljoint problem nothing will happen with the 53 problem unless the media gets involved. If you could give me any other information on who to notify I would appreciate it as selling a 32k and higher vehicle and turning your back on a known defect does not sit well with many owners. Thank you.
I have a 1999 dodge ram 2500 4 x 4 quad cab with the v-10 manual transmission. Since I purchased it new in march 1999, I have twice replaced the rr track bar ($200 part, not including labor) and the steering intermediate shaft ($89 part, not including labor). This truck wanders all over the road and a heavy clunk is felt in the steering wheel. The dealer mechanics keep telling me "that's typical of this vehicle," but there is no recall. Why? I have also noticed an abundance of coolant loss at each oil change since about 10,000 miles...up to 1 gallon per 3000 miles. The radiator pressure checked ok. Dealer mechanics and chat rooms have told me this is another "typical" problem with this truck. Apparently the antifreeze blows through the headgasket and into the exhaust system where it evaporates. Still no recalls. Why are automanufacturers getting away with this?
(1)dealer oil change, subsequent leak.(2)informed oil plug was 'cracked' and oil pan was 'concave' and required relacement@$800+. Informed this was not uncommon.old plug not returned. (3) $20@kragen got me gasket material and ptex#2, leak fixed.
While driving 65 MPH the oil pressure dropped to zero and the engine seized without warning. The dealer states the oil intake was clogged, which caused low oil pressure in the engine. Please provide additional information. *jb
While backing out of the driveway, the vehicle would intermittently stall. This stalling occurred six times. On one occasion, the dealer replaced the ignition coil, and on another occasion, the consumer kept hearing a pinging sound coming from the engine. The transmission was replaced, and the transfer case was still leaking. There had been a myriad of problems with this vehicle. Also, there had been several recalls associated with this vehicle. The consumer claimed that the vehicle was in the shop more than it was in her possession. *ak the vehicle experienced the following: airflow noise/sucked air due to a possible vacuum leak, the passenger mirror vibration due to the bug shields, engine ticking, undershield rusted along with the driveshaft, u-joints, and the bumper, there was rust on the rear box panels, engine ping/noise, the check engine light had come on two times, rear window leakage, transmission did not shift properly/transfer case leaked, hard jumping when in reverse, revvs out more RPM's than normal, engine ping had gotten louder, and there were many times when the engine died.
The vehicle stalled.*jg
Consumer states vehicle stalls without warning while driving. Dealer can not fix problem. Vehicle has been in for repair 7-8 times. Consumer stated the front rotors were warped and the rear drums were out of round, also the enging light stays illuminated, and the vehicle was leaking fuel, dealer replaced the o-rings.
Engine #1(3884 miles) we had only had the truck for two months, had not even made the second payment. We were 75 miles from home pulling our 21 foot boat when the first incident occurred. It was only the second time we had used the truck to pull--which is why we bought the v10 . A piece of the block came off and locked up the oil pump. We were without our truck for three weeks while the dealership tore down the engine to determine the problem and wait for chrysler to decide the best remedy which was a brand new 1999 engine. Chrysler wanted to ship a 2000 engine but it would not bolt up. Our summer was ruined & we did not pull anything again until this year. Engine #2(16,397 miles on truck but only 12,513 miles on this engine). On june 11, 2000, the second time to pull this year, we left on vacation pulling our 23 foot ultra lite pull behind camper. On monday, june 12, 2000, 250 miles from home, the engine started knocking. This time, it had thrown a rod. Our vacation was ruined. The truck was down for two weeks and we were stranded, unable to take our rental car out of state. Chrysler sent a rebuilt engine this time. Engine #3(16,462 miles on the truck but only 65 miles on this engine). We picked up the truck june 23, 2000 after the service people put it through a 24 mile test drive. We drove 41 miles pulling our camper and as we started up a long 5% incline, it began to lose power. About 1/4 mile up the hill, with the gas pedal on the floor, it had dropped to 30 MPH--no power--so we pulled off of the road & stopped. Stranded once again, we called chrysler. After three hours, we were finally rescued. It was taken to a dealer and determined at the present time to have "internal problems". We are once again without our truck. It is not even one year old.
While driving at 35 MPH steering went out, causing consumer to run into a tree. Also, when applying the brakes, they were hard and didn't stop the vehicle. In addition, engine sopped/ no deployment of driver's air bag upon impact.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1999 Dodge RAM 2500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history