Tl*the contact owns a 2004 dodge ram 2500. While driving 35 MPH, the contact heard a noise coming from the front driver side of the vehicle. The contact took the vehicle apart and stated that the cause of the failure was the front driver side wheel hub. Approximately one month later, the noise recurred when the vehicle came to a stop. The contact removed the front passenger side wheel and found that the universal joint failed. The failure mileage was 85,000 and current mileage was 91,000.
2004 Dodge RAM 2500 wheels complaints
Page 2 of 2: complaints 11 to 13 of 13, newest first, as owners wrote them.
Factory aluminum wheels prone to galvanic corrosion. Wheels corrode severely around circumference of inner wheel hub. Takes a sledge hammer to break wheel, tire, and rust free to change wheels at 10,000 mile intervals. Worry is that rust will progress to grain boundaries of lugs on rear axle and lug area on aluminum wheel and lead to wheel failure. Factory should address issue and provide solution. No way a person can change a wheel on the highway with the factory jack and lug wrench. Even the lock on the spare tire on my 2004 2500 ram 4 x 4 was corroded so severely that the key would not go into the lock key way. Luckily the flat happened on pavement in front of a friends house. The only way we could get the wheel of was to hacksaw the chain on the spare, lower the flat tire to the ground, loosen the lug nuts, hold the break and put vehicle in reverse to break the rust free and pop the wheel onto the loosened lug nuts. Even after the wheel broke free of the rust and the vehicle was jacked. I still had to place a large piece of wood against the wheel in the 6 o'clock position and beat on the wood with a sledge to break the wheel free of the hub. Aluminum wheel was severely corroded to include the inner hub and surface that fits against the rear axle.
Left wheel bearing on my 2004 ram 2500 truck has been replaced 8 times. The failure occurs under normal driving conditions. Two dealerships have worked on the problem but they have not been able to correct the malfunction. The seal of the wheel bearing has been broken every time. The first incident occured shortly after I purchased the truck. Mileage was approximately 2200 miles. Recently, the last four times, the seal was broken approximately every 3000 miles. Dodge dealership (arrigo dodge, west palm beach, florida) claims that chrysler will not authorize them to repair additional parts (spindles, front end, etc.), however, a chrysler representative has stated that the dealership has the authority to make any repairs that need to be done. Dealership claims that this is the first time that a vehicle has been brought in with this type of repair.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2004 Dodge RAM 2500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history