Took vehicle into dealer for recall repair on front steering linkage- waited over 9 months for repair part to be available (during which time I was afraid to drive vehicle). Dealer replaced the part but indicated adjacent ball joint worn at 20,xxx miles. Claimed 2 previous recalls regarding front end had nothing to do with premature wear. Ball joint failure has damage tire. Vehicle is unsafe to drive. I have read many online forum reports of premature ball joint failure on same model vehicles.
2008 Dodge RAM 4500: ball joint or control arm failure
6 of the 10 complaints about the 2008 Dodge RAM 4500 describe ball joint or control arm failure.
- owner complaints
- 6
- of this car's complaints
- 60%
- typical mileage
- 59,000
- recalls
- 0
Ball joint or control arm failure by model year
- 20123
- 20113
- 20091
- 20086
What owners say
Driver was turning the truck around in our lumberyard with a partial load on the bed and the left steering tie rod ball stud sheared off causing a serious problem with control of the vehicle he was going less than 5 MPH. The original tie rod was replaced by dodge in may 2011 we were under the impression the part replaced solved the shearing or fracturing problem with the steering.
Tl* the contact owns a 2008 dodge ram 4500. The contact stated while driving approximately 10 MPH the drivers side tie rod failed causing the steering to become unstable. The company vehicle was repaired by the company's mechanic. The manufacturer was notified of the failure but no solution was offered. The failure mileage was 59,000.
Tl* the contact was driving a 2008 dodge ram 4500. The contact stated while driving approximately 25 MPH the drivers side tie rod failed causing the steering wheel to become unstable. The company vehicle was repaired by their mechanic. The manufacturer was notified of the failure but no solution was offered. The failure mileage was 59,000.
Tl* the contact owns a 2008 dodge ram 4500. The vehicle was included in the recall associated with the federal safety agency campaign id number: 10v657000 (steering:linkages:tie rod assembly) and the vehicle was taken to an authorized dealer. The contact was informed by the dealer that the necessary parts needed to perform the repairs were not readily available and would need to be ordered. The contact was told that they would notify him when the parts became available but he had not been notified. The vehicle was not repaired. The failure and current mileage was 39,000.
Tl* the contact owns a 2008 dodge 4500. The contact was driving approximately 10 MPH when the steering wheel began to malfunction and became unresponsive. The vehicle was towed to the dealer where the technician advised that the tie rods would need replacing and that there was a recall for the driver side tie rod in which the contacts vehicle was included. The federal safety agency campaign id number was not available. The technician replaced the driver side tie rod and advised that the passenger side tie rod would not be repaired under the recall. The contact attempted to contact the manufacturer in regards to the repairs but to no avail. The vehicle was repaired. The VIN was unavailable. The approximate failure mileage was 115,000.
Related recalls
No recalls on record for this model year.
Questions about the 2008 Dodge RAM 4500 ball joint
Is ball joint or control arm failure a common problem on the 2008 Dodge RAM 4500?
6 of 10 owner complaints about the 2008 Dodge RAM 4500 (60%) mention ball joint or control arm failure. The model year with the most reports is 2008.
Is there a recall or service bulletin for this on the 2008 Dodge RAM 4500?
There is no recall or service bulletin for this area of the car on record.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2008 Dodge RAM 4500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history