My motorcycle, 2008 ducati s2r1000 (not an option on the next vehicle selector), has a plastic gas tank which has begun to expand. The outside dimensions of the tank have increased and it now does not sit correctly in the frame, and it presses against the ignition switch. Previously it opened and closed without problems, now I have to wedge it against the ignition switch to close it. The rubber mounts no longer sit on the frame which makes the gas tank sit to one side. I have not significantly modified my motorcycle except for an aftermarket exhaust and some cosmetic changes. I have made no modifications to the fuel tank, fueling system or fuel pump. I took the bike to the dealer who submitted a claim to ducati north america (the importer/factory) and they noted they would monitor it for replace. I am very concerned as to the safety of this motorcycle now. The tank's swelling has caused it sit incorrectly and have large bubbles. If the tank swells enough, it will split open and I am concerned this will happen while I am riding.
The worst 2008 Ducati Hypermotard problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
- Fuel system3
- Transmission1
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
- Fuel system3
- Transmission1
Recalls 1
Electrical system: 12v/24v/48v battery: cables
- What is wrong
- On certain motorcycles, the battery can move side to side inside the fuel tank mounting compartment. This movement could result in main wiring harness damage at the battery terminal. This condition could cause an electrical short consequently stopping the engine.
- Risk
- If the engine stops while the motorcycle is being driven, it could increase the risk of a crash.
- Remedy
- Dealers will install a battery mounting bracket and two double lock velcro strips on the bottom of the battery. The recall began on november 19, 2007. Owners may contact ducati motorcycles at 1‑408‑253‑0499.
Recall number 07V474000 · Recall details
Technical service bulletins for the 2008 Ducati Hypermotard 28
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Tips & Tricks Revision 03 Summary
- Tips & Tricks Revision 02 Summary
- Procedure for Assessing Front Fork Oil Leaks
- Guided Diagnosis for Front Brake System Bleeding
- Finial Drive Chain Maintenance Precautions
- Procedure for Analysis and Control of Oil and Coolant Leaks from Engine_Rev.01. Applicability: All Models
- Precautions to Follow During Crankcase Cleaning
- Procedure for Analysis and Control of Oil and Coolant Leaks from Engine
- Overview of Rear Brake System Updates
- CR235 –
What 2008 Ducati Hypermotard owners say
Most recent owner complaints, unedited.
Motorcycle stalls when coming to a stop or when pulling in the clutch. Has been to the shop 11 times and they have replaced , ecu, exhaust valve guide seals, and numerous items. Dealer can't fix the problem. It's unsafe when it just dies. It's a known problem with this bike but ducati won't do anything about it.
On july 11, 2008 I purchased a new ducati hypermotard 1100 motorcyle. Approximately 2 days later it started stalling upon initial start up. It would restart and idle rough. Then after moving off to my first stop (intersection ,light etc.) it would stall again. Once motorcycle was fully warmed up it wouldn't stall as much. I took the motorcycle to dealer where purchased and they reset the tps(throttle position sensor) and raised the idle. The bike would still stall out especially the warmer the outside temperature was. I brought bike back to dealer and they replaced the oxygen sensor and oil temperature sensor. The bike still stalls . It seems to stall more frequently when it is warm out. The warmer it is the worse it is. It will stall upon start up and then at the next few stops (intersection, light, etc.). Most times it will stall with no warning. Upon some research of my own I am not the only one with this problem. Most people are either living with it; or replacing the exhaust and putting on a performance ecu (electronic control unit) that comes with the exhaust. After speaking to another local dealer they told me the same thing. The only way to fix the stalling is replacing the ecu with a performance one. Which makes the motorcycle emission illegal. Ducati seems to know about this problem; because they have all sorts of test and forms for the dealers to fill out and do. But no remedy to the stalling. As of today october 16, 2008 the motorcycle still stalls out.
Compare the 2008 Ducati Hypermotard
Other model years
Questions about the 2008 Ducati Hypermotard
Is the 2008 Ducati Hypermotard reliable?
Owners have filed 3 complaints about the 2008 Ducati Hypermotard, 1.5 times a typical Hypermotard model year.
What is the most common problem with the 2008 Ducati Hypermotard?
Fuel and propulsion system, with 3 complaints. Next is transmission (1).
How many recalls does the 2008 Ducati Hypermotard have?
1 recall, covering electrical system.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2008 Ducati Hypermotard?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history