Information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6) I have a 2006 ducati sport1000 motorcycle [xxx] [xxx] with a fuel tank which has become disconnected from the mounting to the frame of the motorcycle. This is due to a well known defect on ducati sport classic motorcycles, in which the fuel tank slowly spreads apart, so that the rubber mounts no longer properly engage. This is both a safety and emissions risk. This defect was documented in my motorcycle by ducati seattle on march 5, 2010, but the design flaw is known to have existed from the date of manufacture.
2006 Ducati Sport Classic fuel system complaints
Page 3 of 4: complaints 41 to 70 of 74, newest first, as owners wrote them.
I have a motorcycle that was included in a recall for a defective fuel line connector: the federal safety agency campaign id number: 07v017000 component: fuel system, gasoline:delivery:hoses, lines/piping, and fittings because of an oversight by either ducati north america, or the dealership where I bought my motorcycle, eastside motorsports, or where I had recently had service, ducati seattle, I was not informed of the recall. Instead, my engine failed while on a curved on-ramp, which was very dangerous. Nobody knows why I wasn't informed, or who is responsible.
After only 3000 miles, the gas tank warps and spreads until it is not secure on the frame. This is possibly due to gas interactions. Nothing has been done by ducati.
The fuel tank on my ducati motorcycle is spreading and has fallen off into frame mount on the left side and is coming close to falling off on the right side. This is a common problem on the sportclassic series. There is a potential for deformation at the fuel pump sump. I'm worried about leaks and the potential for fire.
The plastic fuel tank on my motorcycle expanded, 'bubbled' and warped to a point that it was unsafely attached to motorcycle. The dealer replaced fuel tank with an identical copy, which worries me about future issues.
I purchased a '06 ducati sport classic sport 1000 in august 2007. It was a new old stock motorcycle. Within 1 year of purchase the gas tank started to deform, and after 1 1/2 years the plastic gas tank had distorted it's shape enough to come completely off it's front mounts. The tank could be lifted straight up off the bike and the only restraint being the single bolt at the rear of the tank. Ducati replaced this tank with an exact duplicate under the two year warranty. Since the replacement tank is the same material as the original, I expect the "spreading " problem to re-occur. The problem is in the material used in the construction of the gas tank. Ducati is giving us (this is a widespread and well known defect in this particular ducati product) defective tanks to replace the defective tanks already on the bikes. They need to design and produce a metal tank or one of different material that will not deform under use creating a fire hazard in the event of a crash and provide it under warranty even for those bikes like mine that are now out of the factory warranty period. This loose fuel tank issue is a serious safety hazard to anyone operating these motorcycles.
I have a 2006 ducati motorcycle, model ps 1000 le. Due to the material used for the gas tank, any ethanol fuel used in the tank causes the tank to deform by expanding. This expansion caused the main mounting points to expand so that they are not held by the frame brackets. The result is that the gas tank does not secure to the motorcycle. The tank expansion occurred in the summer of 2009 and the gas tank was replaced under warranty. However, the tank was replaced with the same model replacement part and has the potential to repeat the defect.
I purchased a 2006 ducati sport classic motorcycle in dec 08. The plastic fuel tank started "spreading apart and the tank became loose on the front mounts. Ducati replaced that tank in jan 09, but the new tank has started to spread the same as the old tank. The tank is warping and can be lifted off the front mounts without undoing the bolt. I am concerned that the tank would detach in an accident and become a fire hazard.
The gas tank on my 2006 ducati sport classic was spreading and warping, which made it loose from the front tabs/clamps and could be lifted from the frame. I just received a replacement tank from ducati about 2 weeks ago. However, I found out that this tank is no different from the previous defective one, which means that it will eventually spread and warp again making it unsafe. I purchased this ducati on september 1, 2007, used. The warping began around the 9000 mile mark. It now has a little over 10000 miles.
Within 2 months of purchase of my motorcycle the gas tank "spread". This means the plastic gas tank distorted it's shape enough to come completely off it's mount on the right side of the gas tank. Ducati is replacing this tank with an exact duplicate. Since the replacement tank is the same material as the original, I expect the "spreading " problem to re-occur. The problem is in the material used in the construction of the gas tank. Ducati is giving us defective tanks to replace the defective tanks already on the bikes. I am on my third tank replacement. The ducati dealership kept giving me the run around until finally they agreed to do the third replacement.
Gas tank on 2006 ducati sport classic has spread enough to be pulled off brackets by hand. Bike is on 2nd warrantied gas tank.
The gas tank has started to deform and does not mount properly to the motorcycle. This is the second time that this has occurred and was replaced at no cost by the ducati dealer. This second tank the dealer is giving me a bit of hesitation and wants to shim the tank. I believe shimming will not stop the tank from spreading and will eventually be a bigger problem.
My motorcycle is a 2006 ducati sport 1000 which has a plastic gas tank which has begun to expand and deform. The outside dimensions of the tank have increased and it now does not sit correctly in the frame. The rubber mounts no longer sit on the frame. I have made no modifications to the fuel tank or fuel pump. In the first quarter of 2008 I took the bike to the dealer who submitted a claim to ducati north america (the importer/factory) and they authorized the replacement of the tank with a new one, which was fitted at that time. I was not given a reason. Within one year the new tank started to expand and deform in the same way. So I just recently took it to another ducati dealer. They got me another replacement tank, which was fitted 2 weeks ago. They told me the tanks have not changed and ducati has not come up with a solution for this problem (I.e. New tank design, or different materials used in its construction) other than repeatedly replacing the tanks with the same type as they expand/deform. I am very concerned as to the safety of this motorcycle. The tank's swelling makes it very loose. If the tank swells enough I am concerned that it might split open while I am riding and cause an accident and/or life endangering fire.
2006 ducati sport classic 1000, fuel tank deforming, the fuel tank on this vehicle is fabricated out of plastic and it is deforming to the point of not being fastened to the body of the motorcycle.
A newly purchased ducati sport classic motorcycle, purchased from an authorized ducati dealer in march of 2006, is exhibiting out of spec gas tank expansion, which is creating unsafe mounting onto motorcycle frame. That is, the gas tank is warping out of shape and no longer securely mounted onto frame. No owner abuse, accidents, or extreme exposure to the elements has caused this gas tank warpage. This appears to be a factory defect.
I own a 2006 ducati sport classic motorcycle. The gas tank is plastic and the tank is spreading apart from the mounting brackets to the point where the brackets do not engage the tank any longer. I am very concerned that this is a safety problem as the tank could separate from the motorcycle. I read on owner forums that this is a very common problem that the manufacturer has so far failed to address. I also read that this was being investigated by the federal safety agency and that I should file a complaint. I first observed this condition in september 2008 and it has continued to worsen.
The plastic fuel tank on my 2006 ducati paul smart 1000 motorcycle is spreading in width, so that it no longer sits securely on the mounts that attach it to the vehicle. The top of the fuel tank is also becoming dimpled, was smooth when new. I suspect it may the polymer used in the fuel tank reacting badly with the ethanol we have in USA gasoline.
I own a 2006 paul smart 1000le, from the sport classic line by ducati. The gas tank, which is made from some sort of plastic has begun to spread apart and is not connected to its mooring points. Based on what I have read on www.ducati.ms, this appears to be a manufacturing defect in these tanks, and I am worried that it may fall off while riding and perhaps even start a fire. It is my understanding that others have gotten replacement tanks only to have the same spreading occur.
Plastic gas tank has deformed causing it to become unattached from the two front mounts. Only thing holding tank to motorcycle is one bolt in rear. Obvious bulge in top of tank from the deformation. Plastic may crack and allow gas to escape and leak over engine which is directly below the tank.
The fuel tank is loose on the front mounts almost to the point that it can be lifted up off the frame. I shimmied the mounts outward from the frame with washers a year ago to hold the tank tight, but it is again loosening. It appears the plastic fuel tank is distorting and getting wider over time. I feel this is a safety issue that should be addressed by the manufacturer as the tank could separate from the motorcycle and cause an explosion or fire even in a low speed crash or drop of the machine.
1.) I bought a 2006 ducati sport classic 2.) the gas tank bulges and deforms (apparently with temperature) and does not always seat in the mounting brackets as the tanks shape changes. I am concerned the expanding/contracting material will eventually fatigue to the point of leaking gasoline. 3.) dealer told me ducati north america is aware of the issue but they aren't doing anything about it but I could purchase another (similarly flawed) gas tank for $1900 that will do the same thing.
Plastic gas tank on motorcycle is wider than the factory mounting which is supposed to hold it in place. If you shift the tank it can be lifted out of the "cups" that are supposed to hold it down. Then only the rear mount of the tank keeps it in place. Pointed out problem to dealer and checked 2 new exact same models (but newer) in showroom and the tanks can be lifted upwards on a brand new bike that hasn't even got gas in it yet. I'm monitoring mine for now. Dealer doesn't feel it is a problem yet. I'm unsure at this time, but there are many questions surrounding this problem on how much "spreading" is 'allowable and why are the tanks growing wider over time. Watching for other defects reported in club network. Personally I think gas tanks from at least the model year I'm reporting should be recalled. If this gas tank ever splits open from spreading it would create a major fire hazard while stationary or injury or death while riding the motorcycle. Honestly have not heard any reports yet of tanks splitting yet, getting wider over time, developing bumps, and pimples all stemming from gasoline inside the tanks.
Plastic gas tank on 2006 ducati sport classic motorcycle does not hold shape. Becomes free of rubber mounts and can rub against frame, etc. Also can be struck by controls in tight turn. Bought bike new 11/06. Tank replaced by ducati 12/07, second tank replaced 11/08. No change in product or issue - now out of warranty and just as unsafe.
Motorcycle was purchased new in september 2007; fuel tank was fitted snugly against the frame at that time. In spring 2007, I noticed the fuel tank had about 3cm of play from side to side on the frame due to the plastic spreading where it attaches to the center frame with two brackets that rest on bushings. On an internet message board, I found that many people had the same issue. Some had the tank replaced under warranty, only to have the second tank spread the same way. For others, the dealer had simply shimmied the brackets that hold the tank in front. I performed this fix myself, but I'm concerned it will not stop the deformation of the tank and could be a safety issue.
Gas tank spreading out of its brackets. Worried that the tank may unexpectedly fall off. Dealership has bulletin to shim out brackets, not cure the problem of the tank spreading.
The fuel tank on my bike is warping to the point that it no longer is securely attached to the motorcyle. This represents a design flaw that could quickly become a safety concern.
The material of the fuel tank on my 2006 ducati sport 1000 seems unstable over time. The surface shows bubbles (blisters) and dimples and the tank seems to be "growing". When new, at full steering lock left or right, none of the controls on the handlebars would hit / touch / interfere with the tank. Now, both sides do. In addition, cracks are developing in the recessed area of the tank where the filler-cap resides. I have brought this issue to the attention of the dealership where I've brought this motorcycle and they acknowledge the problem. Four weeks ago, they have ordered a new tank under warranty, but I have not yet received this replacement. My concern is that the new tank will develop the same problem over time, as the people at the dealership indicated that the material and production-process for these replacement tanks is no different than for the original ones.
Motorcycle: 2006 ducati sport classic 1000-gas tank gets loose and no longer fits brackets. The gas tank is not holding its molded shape and continues to get worse, while spreading away from its mounting bushings and brackets under the front of gas tank. This can cause paint bubbling, possible leakage of fuel and a fuel tank that ultimately fall off during riding. Highly dangerous. The original gas tank has already been replaced under warranty with the same problem 2 years ago. Now im seeing the same problem again and fear of replacing again, since my warranty has expired and a new gas tank cost about $1700.
I purchased a 2006 ducati sport classic 1000 motorcycle new, and within a couple of months noted the fuel tank shifted in position and found it had an inch or so of slop on it's front tank mounts. It is close to coming completely out of it's mounts and is a danger/safety hazard. The tank appears to have spread out and is made of plastic. Distortion of the tank is noted on the top surface as well, which may also be the result of the spreading tank and also may be caused by substandard materials ducati is using for these fuel tanks.
2006 ducati sport 1000. Fuel tank swelled to the point of being loose on the motorcycle. Common , I have found.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2006 Ducati Sport Classic?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history