Abs system worked intermittently. Brakes pulsated, and consumer had to jump the curb. Repair shop determined a module problem & repaired it. Subsequently, while consumer was going 15-20mph and pulling a boat, pressed on the brakes and ABS light came on. Consumer couldn't stop, and rearended vehicle in front. Consumer has been trying to get vehicle repaired; but, dealer didn't seem to have a remedy. *ak
1993 Ford Bronco: ABS light or ABS activating
6 of the 40 complaints about the 1993 Ford Bronco describe ABS light or ABS activating.
- owner complaints
- 6
- of this car's complaints
- 15%
- recalls
- 1
ABS light or ABS activating by model year
What owners say
When applying the ABS brakes pedal traveled to the floor,causing extended stopping distance . Please give any further details.
Abs system failed.
When applying the ABS brakes, the vehicle pulls to the right. Please describe.
While driving vehicle at 9,000 ft in the mtn., in 2nd gear, 2 wheel drive, started to apply brakes (ABS), brake pedal went completely to floor, brakes failed, no warning light, brake fluid evaporized, air in brake system came out.
Abs brakes; when applying brakes truck vibrates extensively worse when coming down hills. Dealers tried to correct (4) times. Tt
Service bulletins that may apply
- Vehicles may experience parking brake pedal which goes to the floor with minimal effort- bronco and...
- Information regarding parking brake control assembly concerns- bronco and f-series built through 4/22/1994...
- Procedure for servicing parking brake- service tip- bronco and f-series built through 4/22/1994 and...
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Concerns with false ABS activation while light braking at low speeds
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Service tip information regarding elimination of sanding rotors and drums
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
Related recalls
Parking brake: conventional
- What is wrong
- The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.
- Risk
- When the above occurs, it can result in parking brake system ineffectiveness. The parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
- Remedy
- A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. Also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.
Recall number 94V169001 · Recall details
Questions about the 1993 Ford Bronco abs
Is ABS light or ABS activating a common problem on the 1993 Ford Bronco?
6 of 40 owner complaints about the 1993 Ford Bronco (15%) mention ABS light or ABS activating. The model year with the most reports is 1994.
Is there a recall or service bulletin for this on the 1993 Ford Bronco?
There is 1 recall and 13 service bulletins for the same area of the car. Check them below with your VIN.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1993 Ford Bronco?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history