1995 Ford Contour visibility problems

Filed Apr 27, 2004 · Visibility · WV

Consumer was unable to use the power control to roll up the windows. Consumer had to manually push the window up to close. It. Dealership was notified, but did not resolve the problem.

Filed Jan 15, 2004 · Body, Engine · MI

I was rear-ended earlier this year and took my car in to the dealership for bumper replacement. Dealership did not inform me that ford discontinued my bumper model, so they repaired it instead of replacing it -- without my permission! Silver plastic strip that runs through center of bumper was re-installed as-is - cracked - since bumper was not being made anymore and new part wasn't available. Both horns were replaced, in spite of rarely being used. Rubber window strips loosen, pop up easily. One power window in rear can only go down about 6 inches, squeaking terribly as it moves down; too expensive to fix. Outer gas door release sticks. Both methods of opening the door (floor lever and trunk strap) stopped working this year. Paid for repair at dealership, but both methods stopped working again after a few days. I now have to open up my trunk every time I go to the gas station, pull the release strap and rap lightly on the outer door in order for it to pop open. I am scheduled for a new repair in a few days at the dealership for rough idle and stalling. Problem involves mass air flow sensor and/or PCM, and is detailed in tsb article no. 98-20-7. Had contacts cleaned on radiator tank and driver's door panel (beeping signal for when door opens and key is left in ignition stopped working). Had complete tune-up at dealership this summer, with mileage at only 40,000. Driver's side speaker wire has loosened, with sound drifting in and out depending on bumps hit on the road. Driver's door lock collapsed inside keyhole. Lock cylinders are only available in sets of five, so all five of my lock cylinders had to be replaced by dealership. Replacement cylinder on my glove compartment vibrates too much while driving. Reverse lights stopped working. Wiring had to be repaired. Paint is thin and scratches easily, even from non-abrasive contact. Driver's window opens all the way, sliding down at a quick speed. Very indifferent treatment by dealership.

Filed Jan 29, 2003 · Airbags, Electrical · 45,000 miles · PA

I have a ford contour 1995 manufactured in 12/94 I have some complaints about my car. There are some recalls out on this vehicle. But there are not list for my contour VIN # but I have the same problems. My car was taken to the robins ford delership in glenolden,pa for not starting. After they inspected the vehicle they called me and told me that I have a wiring harness defect that caused it to short circuit my spark plugs. They told me that the wires for this vehicle is out dated and for have been replacing them with updated wires. But they have not issued a recall for my VIN# but it is a known manufacturer defect with this car. I also have some problems that have just started that ford have recalls on but again not my so called VIN#. My seat belts on this car have been breaking off at the connection tab as well as my defroster not working. Both have recalls on them. I also have concerns about other recalls they have open on this car that are safty haszerds one for which is a fuel tank assembly filler that can cause a flash fire and a fuel tank leakage that can cause a fire they also have a recall for their air bags. I have children that makes me very concered about their safty in this car. And the lack of concern by their ford manufacturer. How can I get this things fix so their will be no accidents.

Filed Oct 20, 2002 · Visibility · UT

Contours have a history of heater resistor defects and I believe in my car this is related damage to that defect. Dt

Filed Sep 17, 2002 · Locks, Visibility · MI

Driver's side door cannot be opened from inside of vehicle. Also, driver's side window fails to roll up or down. Driver's side door can only be opened from inside. Consumer afraid in an emergency situation driver's side occupant would become trapped in vehicle. Consumer has contacted dealer, dealer has yet to determine cause of problem. Please provide further details.

Filed Jul 17, 2002 · Engine, Visibility · WA

Engine overheated and melted the positive temperature indicator device. Fan motor bearings were too tight. Please provide any information.

Filed Jul 5, 2002 · Visibility · SC

Recall 01f127000 repairs on heater blower switch were done, yet vehicle is still overheating on a regular basis.

Filed Apr 27, 2002 · Airbags, Engine · CA · 1 injury

Consumer states steam from the radiator caused her daughter to be injured, consumer also stated that other failures occurred due to the failed radiator.

Filed Apr 15, 2002 · Visibility · CA

No summary listed for above vehicle.

Filed Mar 4, 2002 · Visibility · IL

When consumer turned on the windshield wipers, the wiper assembly fell apart, there was a loud grindindg noise when she turned windshield wipers on.*ak during a rain storm the drivers side windshield wiper failed.*ak. The dealer informed consumer that the entire assembly housing needed to be replaced.