Check a VIN

1996 Ford Crown Victoria: engine stalls while driving

11 of the 276 complaints about the 1996 Ford Crown Victoria describe engine stalls while driving.

owner complaints
11
of this car's complaints
4%
recalls
0
Is there a fix? 19 service bulletins cover this area of the car. See below

Engine stalls while driving by model year

  • 2011
    1
  • 2006
    1
  • 2005
    6
  • 2004
    4
  • 2003
    4
  • 2002
    2
  • 2001
    2
  • 2000
    3
  • 1999
    3
  • 1998
    1
  • 1997
    6
  • 1996
    11
  • 1995
    8
  • 1994
    1
  • 1993
    2
  • 1992
    9
  • 1991
    3
  • 1990
    3

What owners say

Filed Jan 13, 2014 · Engine · 150,000 miles · SC

Tl* the contact owns a 1996 crown victoria. The contact stated that while driving approximately 55 MPH, the vehicle stalled without warning. The vehicle was towed to an independent mechanic, who diagnosed that there was a small fractured in the manifold. The vehicle was not repaired. The contact stated that the manifold failure was recurring. The manufacture was made aware of the problem. The approximate failure mileage was 150,000. Updated 3/21/14

Filed Jan 13, 2014 · Engine · 150,000 miles · SC

Tl* the contact owns a 1996 crown victoria. The contact stated that while driving approximately 55 MPH, the vehicle stalled without warning. The vehicle was maneuvered to the side of the road. The contact stated that the manifold had failed for the second time in ten years. The vehicle was towed to an independent mechanic. The independent mechanic diagnosed that there was a small fracture in the manifold. The vehicle was not repaired. The manufactured was made aware of the problem. The approximate failure mileage was 150,000.

Filed Feb 19, 2002 · Electrical, Engine · NY

While driving, the vehicle stalls in the middle of the road or during a turn, vehicle loses all power, causing loss of control, vehicle has crashed into a curb damaging tires and rims, dealer can not remedy the problem.

Filed Feb 5, 2002 · Engine · NY

Vehicle stalls when making slow turns. Vehicle taken to dealer 6 times, cannot find cause.

Filed Aug 6, 2001 · Fuel system, Transmission · TX

While driving vehicle engine stalled and fluid was coming from the bottom. Then, vehicle was towed to a near dealer, where they found out that there was a crack on intake manifold. Also, there was a recall, but did not include this vehicle due to VIN and mileage over the warranty.*ak vehicle was had also overheated, mechanic found the front of the plastic intake manifold was cracked badly at manufacturing seam and stated that this was a factory defect. Consumer states vehicle shudders, there are several service bulletins relating to this, however consumer states she paid for repairs and feels this too should be a recall item.

Filed Nov 6, 2000 · Engine · MA

On 10/26/2000, the mass air flow sensor was replaced due to the check engine light coming up and difficulty in starting the vehicle. After the replacement, these problems were solved. However, a new problem appeared. The vehicle stalled without any warning. It happened twice within a 24-hour period. In both incidents, it happened on a slow left turn after exiting an interstate highway. At the same time, the power steering was disabled. This created a major safety hazard since I had minimal control of the vehicle. In fact, I almost hit a lamppost. I contacted the dealer, but they could not identify the cause yet. In fact, they could not even reproduce the problem. I have a feeling that this is due to a defective mass air flow sensor, but the dealer does not agree. The dealer said that they are going to install a flight recorder on the vehicle to further investigate the cause of the problem.

Filed Oct 16, 2000 · Engine, Steering · NC

Whenever the vehicle is in low idle engine would stall. Problem is intermittent & would have no warning. Been to dealership 3 different times & mechanic can not locate cause of problem. Had air flow sensor replaced due to check engine light coming on.

Filed Sep 5, 2000 · Engine · NC

While driving about 5 MPH and making a sharp turn on a city street engine stallled without prior warning.had not happened again since this date.*ak vehicle stalled 2 more times since sep 2000

Filed Jan 30, 1998 · Electrical · NY

While driving the vehicle and getting ready to make a left turn and the vehicle stalls. When driving at 60mph hit a bump and the vehcile lost all steering. Took vehicle to the dealer and they replaced the wires on the vehicle, but the driver still is having the same problem. This has been an ongoing problem since the owner purchased the vehicle in 1996.

Filed Sep 30, 1997 · Acceleration · TX

Fast idling, causing uncontrolled acceleration, as well as stalling. Consumer contacted dealer, dealer has yet to find problem.

Filed Oct 18, 1996 · Engine · NY

Intermittent stalling when brakes are applied.

Questions about the 1996 Ford Crown Victoria stalling

Is engine stalls while driving a common problem on the 1996 Ford Crown Victoria?

11 of 276 owner complaints about the 1996 Ford Crown Victoria (4%) mention engine stalls while driving. The model year with the most reports is 1996.

Is there a recall or service bulletin for this on the 1996 Ford Crown Victoria?

There are 0 recalls and 19 service bulletins for the same area of the car. Check them below with your VIN.

Other symptoms on the 1996 Ford Crown Victoria

Ball joint 42Overheating 21Fire or smoke 14Steering lock-up 8Check engine light 7Adaptive cruise 5

All model years of the Ford Crown Victoria

VIN decoder

See the problems and recalls for an exact car

Buying a used 1996 Ford Crown Victoria?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history