1996 Ford E-250 technical service bulletins
49 technical service bulletins and manufacturer communications cover the 1996 Ford E-250.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- This SKU is a front upper ball joint
- A bump steer steering feeling, noted when the vehicle's front wheels/tires contact road surface irregularities
- Concerns with bump steer steering feeling noted when front wheels / tires contact road surface irregularities
- Some vehicles may exhibit a fuel fill valve sealing condition
- Repeat message regarding a hard start / no start condition
- Addressing tire balance hints
- Subject regarding tire balance hint
- Information on super duty models with 7.3L diesel engines exhibiting rough idle / miss condition
- Some super duty vehicles with 7.3L dit diesel engines may exhibit 4X4 lights on, 4X4 inoperative and / or...
- Information on super duty 7.3 dit diesel engine vehicles exhibiti lack of power
- Service information for vehicles exhibiting stall on deceleration condition
- Repeat message regarding vehicles exhibiting rough idle / miss condition
- Repeat message regarding vehicles exhibiting a lack of power
- Repeat message regarding a stall on decel condition
- Subject regarding external oil leaks - repeat message
- Repeat message, no change- rough idle/miss
- Repeat message, no change: hard start/ no start
- Lack of power due to failure of engine turbo boost
- Vehicle stalls upon acceleration
- Information on vehicles exhibiting rough idle / miss
- Brief information vehicles exhibiting hard start / no start condition
- Brief information on vehicles exhibiting lack of power condition
- Brief information on vehicles exhibiting a stall on deceleration condition
- Brief information concern vehicles exhbiting external oil leaks
- Some vehicles may exhibit brake rotor checking or signs of excessive heat build-up
- Information regarding the hotline survey
- Hotline contact id number on oasis
- Excessive white smoke
- Concerns with external oil leaks
- Cold engine upper knock/tick
- Procedures on caliper-mount lathe machining setup
- Vehicle stalls/quits while driving
- Dtc's P1211/1212 icp pressure higher/lower than expected.
- When the air cleaner is being replaced, the drain mechanism on the bottom of the air cleaner case is to be...
- Camshaft position sensor information
- Malfunction indicator lamp (MIL) illuminated - gaseous fuel prep (GFP) vehicles - powertrain control...
- A running change for the 7.3L to allow better definition on cylinder contribution tests in process
- Vibration- driveline resonance/vibration between 1400 and 2000 RPM with converter clutch engaged during...
- Check engine light, code P030X, with no driveability complaint
- Investigating 7.3L irregular idle
- E4OD trans may emit a tick/rattle noise when driving at light loads in 1ST gear at 1100 to 1800 RPM RPM
- Vehicles may exhibit an exhaust leak &/or noise due to warped exhaust manifolds
- For concerns of stalling, reflash PCM w/ 1996 calibration (R11 level)
- Firestone P235 tires may exhibit a high frequency vibration at 65-75 mph
- Vehicles w/ an ABS code 1095, may be caused by water intrusion into the hcu/ECU motor
- Information for when diagnosing concerns w/ factory installed cellular phones
- Subject regarding on-vehicle caliper-mounted brake rotor machining accessories from rotunda, for certain...
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Ford E-250?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history