I got in my 1997 expedition and the brake went to the floor when having the back brakes installed the mechanics noticed the lower on troll arm was rusted out. He the looked at my 1998 and it is the same way. He said I cannot drive them like this. I drive on the interstate daily.
1998 Ford Expedition: brake failure
11 of the 836 complaints about the 1998 Ford Expedition describe brake failure.
- owner complaints
- 11
- of this car's complaints
- 1%
- typical mileage
- 148,515
- recalls
- 0
Brake failure by model year
What owners say
While driving down the road at approx 35 MPH, the vehicle in front of me stopped hard. I immediately stepped hard on my brakes. The brakes initially applied and then failed. I swerved into a parking lot and applied my brakes again with no success. My brake pedal went to the floor. I then put the gear selector in park while moving at a fairly high rate of speed in order to stop. The vehicle ground to a halt. The vehicle was towed to a repair facility and I was notified that the brake line was rusted and due to the pressure of attempting to stop hard, the line ruptured and the entire braking system failed.
Tl* the contact owns a 1998 ford expedition. The contact stated that when attempting to stop the vehicle the brake pedal went to the floor. The contact mentioned that he had to engage the emergency brake in order to stop the vehicle. Also, the contact stated that the hydraulic brake fluid leaked from the vehicle because the brake lines had rusted. The vehicle was towed to the dealer and was told that all of the brake lines had to be replaced. The failure and current mileage was 117,831...updated 01/30/13 *bf updated 2/4/2013
This complaint involves the complete failure of all brake lines due to rust on my 1998 ford expedition. All lines have completely rusted through from the outside in only 12 years. The first line (from the master cylinder to the ABS control) failed about a week ago, resulting in total loss of brakes. Fortunately I was on a country road about 2 blocks from home and was able to get it back home. After replacing that line ($70 for the part) I took it out for a test drive. The second time I hit the brakes they again failed! This time the line going to the rear failed. The truck is presently at a ford dealer. They say all lines are rusted through and need to be replaced. Cost: $3000! I feel that brake lines should not rust out in only 12 years on a vehicle that has been garaged all it's life. I believe that ford motor company has some liability in this issue. I can't be the only one with this problem. Thank you for your time and consideration in this issue.
Suspected failure of ABS control module resulted in total loss of braking. Disabling the ABS by removing the fuse results in reliable braking. Ford wants to replace the module, but if the module fails again then there will be a loss of brakes. The braking is more reliable without the ABS activated.
I have a 1998 ford expedition, and the cruise control stopped working, the anti-lock brakes stopped working, the brake lights stopped working, and I could not put the car in gear. I looked at the fuse box and found a fuse blown. When I replaced the fuse, the engine compartment in the car started smoking profusely. I pulled the fuse out right away, and had someone watch as I put it back in. The smoking started again, and it was coming from some type of brake switch on the front of the master cylinder. I took the car to airport ford in florence, ky, and they said it was the same problem that the 2000 fords were being recalled for. I asked them if it was covered under the re-call, and they said it was not the right year or VIN. They said they didn't know why because it was the exact same switch causing the exact same fire that others are experiencing. I had to pay $158.14 plus $15.00 "shop supplies" plus $10.39 in taxes, totaling $183.53 for a design and safety flaw - the same one that they say only affects the 2000 models. Ford is trying to keep from taking care of the problem for other models even though even their own dealership technicians say is the same exact problem.
Consumer was sitting in a drive-thru and had put vehicle in park when it experienced sudden acceleration, consumer states it started shaking and making a loud squealing noise, the brakes did not work and vehicle crashed into a concrete guard post, the airbags did not deploy, consumer suffered a mild concussion, ford states they can not find any cause for the problem and can not help consumer any further.
Consumer was traveling on highway and another vehicle rear ended. Consumer applied brakes, and there were no brakes, and then hit another vehicle. There was a chain reaction to other vehicle. Abs braking system didn't work. Vehicle at dealership. There were no injuries.
Consumer was driving car home when the brakes failed, and the pedal went all the way to the floor. Also, brakes made a loud sounding noise, and brake fluid leaked.
Anti-lock brakes failed.
When applying the brakes, the pedal went to the floor and the vehicle did not stop. Dealer has seen four times, and replaced master cylinder, but still can't find the problem.
Service bulletins that may apply
- Some vehicles may exhibit amber anti-lock brake system (ABS) lamp on with undefined diagnostic trouble...
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Subject regarding anti-lock brake lamp illumination, increased break pedal effort and / or false anti-lock...
- Vehicles may exhibit an anti-lock brake system (ABS) indicator lamp with no diagnostic trouble code (DTC)...
- Some vhicles may exhibit an anti-lock brake system (ABS) indicator lamp with no diagnostic trouble codes (DTC)
- Some vehicles may exhibit an anti-lock brake system (ABS) indicator lamp on with no diagnostic trouble...
- Vehicles experiencing increased brake pedal effort and / or false ABS cycling at low speeds, or ABS lamp...
- This bulletin mentions that for all vehicles with antilock brake module concerns that require a module...
Related recalls
No recalls on record for this model year.
Questions about the 1998 Ford Expedition brake failure
Is brake failure a common problem on the 1998 Ford Expedition?
11 of 836 owner complaints about the 1998 Ford Expedition (1%) mention brake failure. The model year with the most reports is 1997.
Is there a recall or service bulletin for this on the 1998 Ford Expedition?
There are 0 recalls and 14 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1998 Ford Expedition
Fire or smoke 61Adaptive cruise 33Tire blowout 30Ball joint 29Wipers 27Stalling 18ABS 13No deployment 12Seat belt 12Engine failure 9Headlights 9Loss of power 9Won't start 9Grinding brakes 8Door locks 8Knocking 8Sudden acceleration 8Transmission failure 8Check engine light 7Hesitation 6Overheating 6Pulling 6Won't shift 6
VIN decoder
See the problems and recalls for an exact car
Buying a used 1998 Ford Expedition?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history