1999 Ford Explorer Sport seats problems

Filed Jun 26, 2013 · Seats · 95,000 miles · GA

1999 ford explorer sport drivers seat back unlatched itself while driving. Luckily only 20 MPH! Rear passenger drivers side seat is folded down forward to hold drivers seat in place, until I can find another used seat.

Filed Jun 7, 2013 · Seats · 200,000 miles · CA

Was driving around the city when I reach into my pocket to get my phone and hear a loud thump coming from the seat and the next thing I notice is the seat reclining all the way back. I was able to bring it back up by folding the exterior passenger seat to provide some sort of support. When I arrived home I tried inspecting what the issue was and saw a large fracture right next to the reclining mechanism. This is potentially a hazard that can one day cause a severe accident. I was lucky enough to have been driving slow but if I were to be in the freeway then it might have been something more serious. This large fracture seems to derive from a poorly designed seat that weak metal of some sort.

Filed Jan 25, 2011 · Seats · 135,000 miles · SC

Tl* the contact owns a 1999 ford explorer sport. The contact was driving approximately 25 MPH when a child passenger in the rear of the vehicle pulled on the driver seat to recline herself and the seat reclined backward and fractured. The contact stated that the bolt that held the seta in place fractured. The manufacturer was contacted in regards to the federal safety agency campaign id number: 03v281000 (seats: front assembly: recliner) but the VIN was not included. The vehicle was not repaired. The approximate failure mileage was 135,000.

Filed Aug 25, 2009 · Seats · 70,000 miles · FL

This bolt was replaced on my vehicle in jan 2004 as part of the recall. The new bolt that was installed fractured creating a very serious crash risk. Ford says they will only replace once. Auto recall date: aug 05, 2003 vehicle component: seats:front assembly:recliner estimated vehicles affected: 1552880 model affected 1999 ford explorer 1999 ford explorer defect summary: on certain sport utility vehicles equipped with high back seats, the upper bolt on the driver's side high back seat, that attaches the seat recliner mechanism to the seat back frame, could fracture. If the bolt fractures and does not jam in the seat back frame, the seat back may recline until it makes contact with an object behind the seat, such as the second row seat cushion. Defect consequence: the driver could potentially lose contact with the steering wheel or foot pedals during such an event, increasing the risk of a crash. Remedy: dealers will replace the driver seat upper bolt with a metal spacer and bolt. In addition, seats with tubular back frames will have the fully threaded lower recliner bolt replaced with a partially threaded bolt. Owner notification began on august 29, 2003. Owners should contact ford at 1‑800‑392‑3673. Estimated vehicles affected: 1552880 notes: ford motor company 03s04.

Filed Apr 23, 2006 · Seats · 57,000 miles · NV

(1) driver's seat back latch broken (2) could not enter, or exit from, rear seat on driver's side (3) ford dealer replaced latch total cost about $200.

Filed Sep 8, 2005 · Electrical, Lights · 95,265 miles · CA

We were forced to take this vehicle from hansel ford in santa rosa when they felt we wouldn't be able to afford the 2004 ford f-150 we purchased they had sold my trade in hadn't made a deal with company for contract came a few day before first payment due and repoed it since we have had car nightmares the seat on driver side broke just regular time it does a lot of jerking and sputtering the light work when they want to etc..... Please get me a decent vehicle for after.

Filed Mar 21, 2005 · Electrical, Engine · 50,000 miles · AR

@ 50,000 miles radiator went out and we replaced w/ new radiator/ heads in the motor had to be replaced / electrical problems / re-built transmission put in / driver's seat recliner failure .

Filed Feb 16, 2005 · Seats · CO · 1 injury

This report concerns a 1999 ford explorer sport 2dr 4x4. Vehicle has 144,000 plus miles. Specifically this pertains to the front driver?s seat (non-power model). Over the last 5 years I have replaced the front drivers seat (bottom frame) three times. Each time the seat frame has broken in the same manner. The problem is that the frame metal rips/tears at the location of the mounting bolt for the recline lever. This tearing causes the seat back to recline without warning on the left side causing the driver to fall backwards away from the steering wheel. Ford has stated that they do not have any info on this. This is somewhat strange as they apparently directed dealerships approximately 2 yrs ago to replace this frame on all affected vehicles. The problem is very apparent and a very easy fix. The tearing occurs just to the front of the (front) bolt hole about 1/8 inch from the hole. There is a large spot welded plate inside the frame where the bolts for the recline lever insert into the frame. If this plate was extended about 4 inches or more past the frame holes this problem would not occur. I have detailed photos of this frame and problem area available for use to your office as well as the frame itself.

Filed Feb 7, 2004 · Seats · 50,800 miles · CA

Vehicle 1999 ford explorer sport (2dr) VIN [xxx] this involves a safety issue with the front seat recliner handles on the side of the seats. Ford has issued a recall (03s04) to replace the "driver seat recliner bolt." however, my complaint involves the recliner handles which fell apart on the front passenger seat of our vehicle. On below date, my wife exited the front passenger seat and used the handle to move the seat forward so our daughter could exit the rear seat area. The handle fell apart in two pieces and the back part of the seat flew forward to the dash. The back part of the seat will not hold a position and freely moves back and forth into the rear seat and forward to the dash rendering the seat unsafe and useless. On 2/6/04, I took the vehicle to south bay ford, 13900 hawthorne blvd, hawthorne, ca 90250 ph 310 644-0211 for the recall work. I also advised them that the passenger side seat had come free because of a faulty release handle. I was called later and advised it would cost over 400 dollars to repair the faulty release handles on both the drivers and passengers seats. The serviceman informed me the drivers seat release mechanism was also about to fail. It seems to me that ford definitly has a safety issue here involving their seats in this vehicle. Ford has already addressed one safety issure involving the reclining seats with the recall involving the faulty bolt. The bolt was replaced in order to prevent exactly what is occurring with their faulty recliner release mechanism. The recliner handle fell apart when my wife simply touched it and the other, according to the serviceperson, is about to fall apart. I would hate to imagine if this were to happen while driving the vehicle. I believe this is a matter the federal safety agency should investigate. *ak updated 07/27/2012 *js information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6)

Filed Oct 8, 2003 · Seats · 80,000 miles · FL

Recall repairs cannot be performed unless the reclining seat handle can be fixed. Although the initial recall problem caused the handle to be bent, the dealer wants the consumer to pay for it. Consumer feels he is being given the run around to get the vehicle fixed. Manufacturer has been notified.