Radius arm bushings malfunctioned. In addition, premature wear of brake pads.
1991 Ford Explorer brakes complaints
Page 3 of 5: complaints 41 to 70 of 123, newest first, as owners wrote them.
Brake master cylinder failed.
A recall was issued on vehicle. Repair of the defect was done. Owner states that the problem still exists.
Vehicles brakes do not work because the vacuum valve does not work and raw gas is going through the engine to the brake lines.
Sometimes when applying the brakes, the rear brakes lock up, took to dealer changed speed sensor , calipers and master cylinder were also replaced.
Applied brakes extremely hard, anti-lock and regular brake lights came on, remained on, according to dealer, could cause rear wheel lock up.
Brake failure, in for repair, replaced calipers on the front and pads/rotors, the pads are coming unattched from the calipers, causing them to come out of round and be damaged.
While riding on the freeway in stop & go traffic, owner states when ABS brakes were used driver lost control of the vehicle and pedal went to the floor, resulting in an accident.
When entering the freeway vehicle accelerated without applying gas pedal, when applying the brakes nothing happened, put emergency brake on and turned car off to stop it.
Brakes pulled from the left to right eventually causing the system to lock up.
The emergency brake cable has broken in the rear right side.
When driving vehicle started pulling to the left. Came to stop sign and wheel started shaking and front left brake locked up.
While driving the vehicle jerked to the right and vehicle went down the road sideways, when applying the brakes the vehicle would not stop. The truck has ABS. The truck then flipped over and skidded 150 ft.
While driving vehicle out of office garage, gas pedal suddenly went straight to the floor, the engine was racing, vehicle took off, tried to stop vehicle by applying brakes, vehicle slammed into a building, smashing the front of vehicle.
Brake shoes on the right rear wheel broke off the drum, lodged in the wheel, causing it to lock/accident.
The front brake rotors were replaced about four times, please describe .
When trying to come to a complete stop he experienced a brake failure.
Abs, rear wheel brake lockup, when applying brakes very forcefully expericenced lockup.
Failure of the brakes, consumer was driving and the vehicle suddenly accelerated the consumer was not able to stop the vehicle.
Experienced ABS failure. Please give more details.
The front calipers locked in on the on position which causes the car to brake on its own without pressing the pedal. Please describe.
The rear ABS system does not activate and also does not help stop the car. Please describe.
When ABS brakes are applied hard, brakes lockup and the rear of the vehicle goes into a spin.
Brake rotors failed twice prior to recall.
Applying brakes, pedal went to floor. While sitting flames shot from hood w/cause unknown. Routine maintenance performed previously. Please describe. Tt
W/rear ABS brakes; stop/go down incline applied brakes and pedal descended to floor board w/no activation of brakes. Please describe details. Tt
The ABS anti-locks in the truck locks up while driving with no reason. And the brakes with not work sometimes. Tt
Had to replace the disc caliper and disc rotor. Tt
Vehicles brake master cylinder failed and had replaced.its occuring again with mushy pedal to the floor. Tt
Abs brake system malfunctioned, wheels locked up when 40 MPH in wet surface, ABS indicator light came on prior to accident. Tt after the accident, the light did not come on.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1991 Ford Explorer?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history