1994 Ford F-150 technical service bulletins
92 technical service bulletins and manufacturer communications cover the 1994 Ford F-150.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- New transmission cooler flusher - service tips
- Lamp-brake-invadvertent disabling of brake shift interlock
- This aritlce is to provide information on replacement of old style hood lamp switch to the rvised...
- Brake shift interlock
- Some vehicles may exhibit heater core leaks
- Information regarding transmission fluid usage charts
- A condition may exist with possible electronc damage occuring to the compuvalve from voltage spikes...
- Subject regarding contamination from prior transmission concerns or excess wear may be trapped in the...
- TRANSMISSION-E40D-NO 2-3 upshift
- Transmission- E40D/4R100-1989-99-MAIN controls, separator plates and separator plate gaskets usage chart
- Vehicles may experience solid particle contaminants from prior transmission concerns or excess wear, may...
- Vehicles may experience parking brake pedal which goes to the floor with minimal effort- bronco and...
- Information regarding parking brake control assembly concerns- bronco and f-series built through 4/22/1994...
- Procedure for servicing parking brake- service tip- bronco and f-series built through 4/22/1994 and...
- Information regarding the new transmission cooler flusher- service tip
- Subject on a wire harness terminal repair kit available for repairing electrical wiring harnesses
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Information on identifying non-approved / alternate refrigerants which could cause safety, and performance...
- Conditions with the brake lamps inadvertently disabling the brake shift interlock
- Experiencing a whine / buzz type noise in the speakers of the entertainment radio or two-way radio on...
- Some vehicles may experience axle wind up and / or clunking, popping, ratcheting type noises when making...
- Experiencing a delayed or no 2-3 upshift, primarily when the transmission is cold on vehicles with ford...
- Subject regarding door trim panel replacement - service tip
- Ford motor company now recommends sae 5W-30 viscosity grade for servicing any ford gasoline-powered...
- Ford motor company has released a new electrical grease ( F8AZ - 19G208-AA ) to reduce the possibility of...
- Experiencing a " buzzing " or " rattling " noise from the exhaust system
- Information on a new transmission fluid usage chart
- Information on tire company telephone numbers for customer assistance
- Information on a buzzing or rattle noise from the exhaust system
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Service tip information regarding elimination of sanding rotors and drums
- Recommended guidelines for towing behind recreational vehicles
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
- The parking brake pedal may go to the foor with little or no effort during application
- A comprehensive pull and drift diagnostic procedure has been developed to assist technicians in resolving...
- A shudder / vibration and / or squealing heard while braking - revised front brake lining
- Subject regarding on-vehicle caliper-mount lathe machining setup procedures
- Some vehicles may exhibit a drift or pull to the left while braking
- Availability of hub-mount brake rotor machining equipment
- Some vehicles may exhibit a flashing transmission control indicator lamp (TCIL) and diagnostic trouble...
- Concerns with axle wind-up and / or clunking, popping, ratcheting type noises when making cornering maneuvers
- Subject regarding the availability of hub-mount brake rotor machining equipment
- Information on the defroster performance enhancement.
- Performance enhancement for defroster
- Some vehicles may exhibit a flashing transmission control indicator lamp (TCIL) and diagnostic trouble...
- Part number information for the use of a child seat tether
- New clutch slave cylinder with a redesigned lip seal
- Headlamp- headlamp housing melts- ambulance and emergency vehicles only
- Fuel economy- customer expectations versus vehicle usage
- Fluid- transmission fluid usage charts
- Frame- rivet replacement with bolts- service tips
- Accessory drive belts- fead belt comes off- vehicles with 4.9L engine
- The clutch may be hard to depress due to dust/contamination entering the slave cylinder
- Noise- "popping/creaking"- front frame or suspension brackets- frame- "popping/creaking"- fastener replacement
- Air bag lamp flash-out code 33 on vehicles equiped with a passenger side air bag
- Transaxle - torque converter replacement guidelines and torque converter/transaxle cooling system cleaning...
- Powertrain control module -reprogram powertrain control module (PCM) - service procedures - service tip
- When diagnosing an air bag lamp flash-out code 33 (passenger side air bag high resistance or open) on a...
- Wiring - electrical diode identification and service replacements
- Torque converter - leak test procedure - service tip
- Vibration - driveline vibration and/or driveline noise - regular cab 4X4 vehicles equipped with 7.5L...
- Diagnosing an air bag lamp flash-out code 33 (passenger side air bag high resistance or open)
- Information on aode/4R7W transmission main control & case replacement
- Windshield and interior glass - fog/film
- Brakes - elimination of sanding rotors and drums - service tip
- Air conditioning - compressor failure - insufficient amount of refrigerant oil
- Vehicles may exhibit an exhaust leak &/or noise due to warped exhaust manifolds
- Subject regarding a new transmission case and main control released for service on aode / 4R70W transmissions
- Service tip information regarding the reverse clutch piston and piston seal usage
- 4X4 front axles must use hypoid 4X4 gear oil p/n F1TZ-19580-A & high temp 4X4 front axle & wheel bearing...
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because...
- Generator-motorcraft 95AMP-FRONT bearing CONCERN-FD1060/1460 engines- vehicles built before 7/3/95
- Engine- 'knocking' noise - when operating engine at 200-2300 RPM - FD1460 engine
- Vehicles experiencing occasional harsh reverse engagement concerns
- Revised design transmission rear case bushing
- Delayed forward engagement and/or heat stained forward clutch plates after installing center support service
- Unknown
- Hydromounted cab - evaporative emission lines rubbing on the fender
- Revised mounting torque for bumpers
- The front bumper mounting torque specification has been revised for better overall bumper retention and...
- Vehicles with 7.3L direct injection diesel engines may experience one or more of the following conditions:...
- Green condensate or white smoke coming from exhaust pipe
- A rattle from the split seat bench may be due to a loose or missing seat bushing
- Knocking noise on initial start-up
- Revised oil fill procedures
- There may be an intermittent loss of torque during or just after the 3-4 upshift or in 4TH gear on some...
- Under hood wire harness may become chafed
- Revised oil pan gasket
- Early wear of fead tensioner pulley on vehicles with 5.0L/5.8L engines
- New design transmission range sensor
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 Ford F-150?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history