1994 Ford F-250 recalls
There are 8 safety recalls on record for the 1994 Ford F-250, covering 6,942,513 vehicles in total across all the models in each campaign. Newest first.
All recalls
Vehicle speed control
- What is wrong
- On certain trucks equipped with speed control, gasoline or natural gas engines, the speed control deactivation switch may overheat.
- Risk
- Overheating could result in smoke or burn and an underhood fire.
- Remedy
- Dealers will install a fused wiring harness into the speed control system free of charge. The recall began on august 7, 2006. Owners may contact ford at 1‑866‑436‑7332. (note: also see recalls 05v017 and 05v388)
Recall number 06V286000 · Recall details
Vehicle speed control
- What is wrong
- On certain pickup trucks and sport utility vehicles equipped with speed control, the speed control deactivation switch may overheat, smoke, or burn.
- Risk
- A fire at the switch could occur.
- Remedy
- By letter dated september 12, 2005, owners were instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. Owners who have had their speed control deactivated are being notified that parts will be available and advised to make an appointment to reconnect the speed control beginning in february 2006. Owners who did not have their speed control deactivated are being notified to have their system remedied beginning in february 2006. Owners are urged to avail themselves of the free disconnect service as soon as possible because of the significant risk of fire. Owners may contact ford at 1‑800‑392‑3673. (note: also see recalls 05v017 and 06v286)
Recall number 05V388000 · Recall details
Seats
- What is wrong
- The wire harness for the power lumbar feature on the seat is underneath the front seat cushion support wires. The support wires on the driver seat can contact and damage the insulation harness resulting in a high resistance electrical short through the support wires.
- Risk
- Consequence of defect: over heating of the support wires could result, and melting, smoke, or possible igntion of the surrounding materials could occur.
- Remedy
- Dealers will inspect the seats on the affected vehicles. If no damage is found, the driver seat wire harness will be covered with a protective convolute tubing, wrapped with electrical tape and the harness will be rerouted. If damage is found, the wire harness will be replaced.
Recall number 96V064000 · Recall details
Parking brake: conventional
- What is wrong
- The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.
- Risk
- When the above occurs, it can result in parking brake system ineffectiveness. The parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
- Remedy
- A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. Also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.
Recall number 94V169001 · Recall details
Electrical system: ignition: module
- What is wrong
- In a heavily loaded vehicle, while in the cruise control mode, the throttle may not reduce immediately when the load on the engine is decreased (such as when the vehicle crests a hill.) this can result in increased vehicle speed without prior warning.
- Risk
- This can result in loss of speed control of the vehicle, and a possible accident.
- Remedy
- Dealers will replace the electronic engine control module.
Recall number 94V101000 · Recall details
Structure: body: bumpers
- What is wrong
- The u-clip style nuts that retain the front bumpers to the front bumper inner arms can fracture.
- Risk
- If one of the u-clip nuts fractures, the bumper will loosen and rattle causing fracture of the remaining u-clip nuts, resulting in separation of the bumper from the vehicle. If the bumper were to detach from the vehicle while it is being driven, a vehicle collision could result.
- Remedy
- Inspection and replacement of the four u-clip nuts and the associated bolts.
Recall number 94V018000 · Recall details
Air bags
- What is wrong
- These vehicles were built with nonfunctional air bag diagnostic modules intended for certain vehicles over 8,500 bls. Gvwr.
- Risk
- The air bag supplemental restraint and the air bagwarning light will not function. This could result in reduced occupantprotection in the event of a collision that should activate the air bagsupplemental restraint system.
- Remedy
- Dealers will inspect these vehicles and, if necessary, install the correct air bag diagnostic module.
Recall number 93V184000 · Recall details
Air bags
- What is wrong
- The design of the air bag diagnostic monitor causes the driver's side air bag to deploy when the passenger door is slammed while the ignition key is turned to the start position.
- Risk
- Inadvertent deployment of the air bag can result ininjury to the driver.
- Remedy
- Install a redesigned air bag diagnostic monitor.
Recall number 93V155000 · Recall details
Questions about the 1994 Ford F-250 recalls
How do I check if my 1994 Ford F-250 has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 1994 Ford F-250 have?
8, covering vehicle speed control, seats and parking brake.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 Ford F-250?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history