1994 Ford Probe technical service bulletins
89 technical service bulletins and manufacturer communications cover the 1994 Ford Probe.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Remote keyless entry (RKE) - service tips
- Lamp-brake-invadvertent disabling of brake shift interlock
- Some vehicles equipped with the CD4E transaxle may exhibit harsh and delayed 1-2/2-3 upshifts after...
- Brake shift interlock
- Some vehicles may exhibit heater core leaks
- Information regarding transmission fluid usage charts
- Some vehicles equipped with CD4E auto transaxles may exhibit diagnostic trouble codes for gear ratio or...
- Some vehicles may exhibit no forward gear ranges due to the misalignment of the forward / coast clutch...
- Information regarding the new transmission cooler flusher- service tip
- This bulletin addresses an issue with the automatic transmission fluid seeping from the vent, resulting in...
- Subject on a wire harness terminal repair kit available for repairing electrical wiring harnesses
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Information on identifying non-approved / alternate refrigerants which could cause safety, and performance...
- Service tip information on revised oil pan gasket replacement procedure
- Information on the new flush and fill tool available through rotunda
- Information on servicing the left steering rack bushing
- Conditions with the brake lamps inadvertently disabling the brake shift interlock
- Information on "whining" / "buzzing" noise coming through entertainment or two-way radio speaker caused by...
- Experiencing a whine / buzz type noise in the speakers of the entertainment radio or two-way radio on...
- Ford motor company now recommends sae 5W-30 viscosity grade for servicing any ford gasoline-powered...
- Ford motor company has released a new electrical grease ( F8AZ - 19G208-AA ) to reduce the possibility of...
- Mass air flow (maf)- sensor contamination- service tip
- Minimal clearance of the CD4E transaxle to subframe makes transaxle installation and removal more difficult
- Experiencing a " buzzing " or " rattling " noise from the exhaust system
- Information on a new transmission fluid usage chart
- Information on tire company telephone numbers for customer assistance
- Concerns of a hard start or stall condition on some vehicles
- Experiencing a whining / buzzing noise in the speakers of the entertainment radio or two-way radio
- A new silicone gasket and sealant
- Information on a buzzing or rattle noise from the exhaust system
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Service tip information regarding elimination of sanding rotors and drums
- Recommended guidelines for towing behind recreational vehicles
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
- Availability of hub-mount brake rotor machining equipment
- Subject regarding the availability of hub-mount brake rotor machining equipment
- Transaxle- 4EAT- harsh shift from 1ST to 2ND gear- 2.0L (1993 only) and 2.5L (1993-95) engines
- Fuel economy- customer expectations versus vehicle usage
- Interior- leather seat cleaning procedure- service tip
- Leak- automatic transmission fluid- CD4E transaxle in fluid collection on main control assembly
- Fluid- transmission fluid usage charts
- Transaxle- CD4E- harsh shift and/or engagement- diagnostic trouble code (DTC) 628 or P0741- service tip
- Harsh shifts and/or harsh engagement accompanied by dtc's 628 or P0741
- Malfunction indicator lamp- diagnostic trouble code 181 or P0171 may be stored in memory- rough idle-...
- Harsh 1-2 upshift concern
- Vehicles exhibiting a top of engine knock noise when starting a cold engine
- Vehicles exhibiting harsh shifts and/or harsh engagement accompanied by dtcs 628 or P0741
- Noise - buzz/vibration in reverse and/or clicking noise accompanied by vibration on right hand turns...
- Metallic ticking noise from upper engine
- Engine - 2.5L - tapping noise from rear cylinder head camshaft friction gear - vehicles built between...
- Transaxle - torque converter replacement guidelines and torque converter/transaxle cooling system cleaning...
- Transaxle - CD4E - harsh shift and/or engagement - diagnostic trouble code 628 or P0741
- Restraint system - air bag module - diagnostic fault code 51 - improved diagnostics and repair
- Axke leaks - fluid leaks from front of vehicle at axle shafts - new design replacement cv joint boots
- Concerns of transmission popping out of 3RD or 5TH gear
- Wiring - electrical diode identification and service replacements
- Torque converter - leak test procedure - service tip
- Concerns of intermittent stalling while driving at low speeds
- Metallic ticking noise from upper engine
- Information on aode/4R7W transmission main control & case replacement
- New oxygen sensor now available
- Windshield and interior glass - fog/film
- Brakes - elimination of sanding rotors and drums - service tip
- Mass air flow sensor - replacement as an assembly - service tip
- Weld connection concern w/ the forward/direct/coast clutch cylinder & hub assy
- Unknown
- W/ 2.5L, investigations have produced updated info
- W/ 2.0L, engineering is investigating a lifter bleed down concern when at operating temp & idling
- Engineering is investigating a concern on the CD4E transaxle where transmission fluid mists from the...
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because...
- Door-glove compartment-improved lock assembly available-probes through 7/1/94 and escort/tracers built...
- TRANSAXLE-CD4E-DELAYED 1-2 or 3-4 upshift-band wear and/or inoperative direct CLUTCH-2.0L vehicles with...
- Noise - rattle - from engine compartment during stop - and - go acceleration vehicles with 2.0L engine and...
- Engine - modifications to cylinder head and piston
- The combination switch/turn signal lever, in the steering column, may be slow to cancel
- Intermittent headlamp door operation
- The combination switch/turn signal lever may be slow to cancel after making a left hand turn
- Revised EGR valve wiring harness
- Vehicles may be hard to start due to corrosion or short to ground at a wiring splice
- Roughness concern during brake application
- Erratic distance-to-empty and fuel gauge readings
- New radiator manufacturing process/modification
- New level design water pump
- Vehicles may be hard to start or will not start
- The a/c compressor may be inoperative due to incorrect routing of wiring harness
- Fluid leak from pump body of transaxle
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 Ford Probe?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history