1995 Ford Ranger technical service bulletins
157 technical service bulletins and manufacturer communications cover the 1995 Ford Ranger.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Low line pressure reading at wide open throttle (WOT), slipping shifts and / or delayed engagements with...
- Clicking/popping noise from upper steering column area when turning
- Remote keyless entry (RKE) - service tips
- New transmission cooler flusher - service tips
- Engine-gear driven synchronizers-incorrect installation-camshaft position synchronizer (CMP) installation...
- Incorrectly installed gear driven camshaft position (CMP) sensor synchronizer assemblies causing surge,...
- Lamp-brake-invadvertent disabling of brake shift interlock
- Some vehicles equipped with an automatic transmission and a 4.0L ohv engine may exhibit a noise /...
- Experiencing a clicking / popping noise from the upper steering column area when turning the steering wheel
- Some vehicles may exhibit a no 1-2 upshift, no 2-3 upshift, a no engine braking condition in manual 1 or...
- Some vehicles built prior to 9/15/2001 may exhibit low line pressure readings while in drive, no 2ND gear,...
- Engine oil system priming procedures, service tips for reports of premature engine failure
- Some vehicles equipped with 4.0L ohv engines may exhibit a loud a/c clutch engagement
- Some vehicles equipped with the 4.0L ohv engine may exhibit an engine noise which may be perceived by the...
- Owner notification program supplement 7 revised information - regarding replacement of wilderness at tires
- Information on climate control, loud a/c clutch cycling noise
- Brake shift interlock
- Some vehicles may exhibit heater core leaks
- Information regarding transmission fluid usage charts
- Some vehicles may exhibit a loud compressor cycling noise
- Some vehicles may exhibit loud a/c clutch cycling noise condition
- On some vehicles, engine oil may continue to leak from the engine oil pan gasket area after an engine oil...
- Some vehicles may exhibit a chatter or binding condition when operating the power side windows either in...
- Subject regarding contamination from prior transmission concerns or excess wear may be trapped in the...
- Information regarding pump alignment tools
- Information on 5R55E - 4R55E - 4R44E pump alignment tools
- Information regarding the new transmission cooler flusher- service tip
- Some vehicles may experience a condition of no 4 x 4 low range engagement or a stuck in 4 x 4 low range
- During extreme cold ambient temperatures and under certain driving conditions, moisture in the crankcase...
- A temperature gauge fluctuation and / or a knocking / thumping noise may be audible inthe passenger...
- Some vehicles may exhibit a condition of no 4X4 low range engagement or a stuck in 4X4 low range, with no...
- Some vehicles equipped with manual transmission may exhibit neutral gear rollover noise (a light metallic...
- All vehicles with electronic shift on the fly transfer cases will display contact plate pids opposite of...
- Experiencing very light steering vibration / shimmy / nibble at engine idle or low speeds (parking lot...
- All 4X4 vehicles with electronic shift onthe fly transfer cases will display contact plate pids opposite...
- Subject on a wire harness terminal repair kit available for repairing electrical wiring harnesses
- Some vehicles may exhibit a condition of no 4X4 low range engagement or a stuck in 4X4 low range, with no...
- Vehicles equipped with manual transmission may exhibit neutral gear rollover noise which occurs at idle...
- Exhibiting very light steering vibration / shimmy / nibble at engine idle or low speeds
- Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material...
- Information on identifying non-approved / alternate refrigerants which could cause safety, and performance...
- Service tip information on revised oil pan gasket replacement procedure
- Some service manuals may list the incorrect camshaft position sensor alignment tool for vehicles with...
- Information regarding camshaft position (CMP) sensor alignment tool chart
- Experiencing an audible pinging or creaking (not a clunking noise) heard from the driveline when engine...
- Some vehicles may exhibit a malfunction indicator lamp (MIL) on with diagnostic trouble code (DTC) P0125...
- Some vehicles may exhibit an engine noise which may be perceived by the customer as a piston / connecting...
- Information on the new flush and fill tool available through rotunda
- Some vehicles may exhibit an occasional hoot / moan from the idle air control (IAC) valve
- Some vehicles may exhibit an audible pinging or creaking noise that may be heard from the driveline when...
- Conditions with the brake lamps inadvertently disabling the brake shift interlock
- Information designed to aid in the diagnosis, testing and repair of noise, vibration and harshness (NVH)...
- Experiencing a whine / buzz type noise in the speakers of the entertainment radio or two-way radio on...
- Some vehicles may experience axle wind up and / or clunking, popping, ratcheting type noises when making...
- Subject regarding door trim panel replacement - service tip
- Ford motor company now recommends sae 5W-30 viscosity grade for servicing any ford gasoline-powered...
- Information on maintaining tire pressure
- Information regarding reprogramming powertrain control modules (PCMS)
- Ford motor company has released a new electrical grease ( F8AZ - 19G208-AA ) to reduce the possibility of...
- Information on vehicles exhibiting steering wheel shimmy, vibration or grunt on slow speed turns
- Special field action regarding revised waranty information
- Mass air flow (maf)- sensor contamination- service tip
- Revised message regarding steering wheel shimmy, vibration or grunt on slow speed turns action on sohc...
- Vehicles may exhibit a climate control issue of lack of heat
- Some vehicles with power windows may exhibit window chattering or jerking motion when operating in the...
- Some vehicles may exhibit a climate control issue of lack of heat
- Experiencing a " buzzing " or " rattling " noise from the exhaust system
- Steering wheel shimmies, vibration or grunt on slow speed turns..
- Outside rearview mirror manual replacement.
- The driver's and passenger's door glass chatter when operating the window in down mode.
- Steering wheel shimmy, vibration or grunt on slow speed turns
- Some vehicles with 2.3L engines may experience a malfunction indicator light with diagnostic trouble code...
- Some vehicles with 2.3L engines may experience a malfunction indicator lamp light with diagnostic trouble...
- Information on a new transmission fluid usage chart
- Information on tire company telephone numbers for customer assistance
- Concerns with false ABS activation while light braking at low speeds
- Symptoms with the gear dtc's and extended / delayed / no shift / flashing fault indicator lamp
- Concerns of cold engine upper knock / tick
- Some vehicles may experience various concerns such as intermittent windshield wiper operation without...
- Intermittent wiper operation without command; dome lights remaining on; or the door chimes remaining on. tt
- Information on a buzzing or rattle noise from the exhaust system
- Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use
- Service tip information regarding elimination of sanding rotors and drums
- Recommended guidelines for towing behind recreational vehicles
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable
- A grabbing and/or sticking condition during the first few brake applications when the brakes are cold or...
- Availability of hub-mount brake rotor machining equipment
- Concerns with axle wind-up and / or clunking, popping, ratcheting type noises when making cornering maneuvers
- The driver's and/or passenger door glass may
- Subject regarding the availability of hub-mount brake rotor machining equipment
- Subject regarding a new service center support that uses a thrust bearing (#3 and #4) in place of thrust...
- Gear dtc's and extended/delayed/ no shift
- Concerns with "pinging" or "creaking" being heard from the driveline when shifting from park to drive or...
- Experiencing a "thumping" noise or tempeature gauge fluctation with some vehicles
- Only vehicles equipped with power door locks and power windows will have right hand illuminated entry
- New clutch slave cylinder with a redesigned lip seal
- Authorized warranty part replacement of brake pads to correct excessive brake noise
- Only rangers equipped with power door locks and power windows will have right hand illuminated entry
- Fuel economy- customer expectations versus vehicle usage
- Brakes- "squealing" noise and/or sticking during first few brake applications after a rainfall and/or when...
- Fluid- transmission fluid usage charts
- Frame- rivet replacement with bolts- service tips
- Gem concern - check for more than one gem controlled component that is inoperative or for a string of...
- Lamp- "check engine" malfunction indicator lamp (MIL) illuminated- diagnostic trouble code (DTC) P1405...
- Electronic control modules vary on vehicles based on option content & have different diagnostic code...
- Tire wear- cannot adjust camber to specs
- Rear brakes "grab" when cold or damp
- The ngs displays incorrect date for the ing gem pid on the vehicles
- Vehicles with an unusual negative camber reading, and cannot be adjusted to within the proper camber...
- If DTC P1443 returns after TSB 96-0608 has been performed, lay out a clean white piece of paper on flat...
- 4.0L equipped vehicles may experience temperature gauge fluctuation that may be accompanied with a...
- 4.0L equipped vehicles may experience temperature gauge fluctuation that may be accompnied with a thumping...
- If DTC P1443 returns after TSB 96-06-08 has been performed, lay out a clean white piece of paper on a flat...
- The ngs displays incorrect data for the ign gem pid on the vehicles
- Diagnosing four wheel drive electronic shift operation concerns on 95/96 model year ranger
- Some vehicles may not be put into alignment- camber readings
- Cold engine knock/tick noise
- Four wheel dirve electronic shift operation
- Clutch cover adjustment procedure prior to installation was omitted from the service manual
- Transaxle - torque converter replacement guidelines and torque converter/transaxle cooling system cleaning...
- Powertrain control module -reprogram powertrain control module (PCM) - service procedures - service tip
- Wiring - electrical diode identification and service replacements
- Torque converter - leak test procedure - service tip
- Noise - pinging or creaking from driveline when vehicle is put into gear
- Instructions for replacing diagnosed failed parts
- Cold engine knock/tick noise
- Diagnostic instructions for servicing evaporative emission purge flow system
- Information on aode/4R7W transmission main control & case replacement
- Vehicles may experience unexplained MIL light codes &/or irregular shifting (A4LD)
- Windshield and interior glass - fog/film
- Brakes - elimination of sanding rotors and drums - service tip
- Long crank - sticking idle air control (IAC) valve - vehicles built from 11/1/94 through 3/30/96 -stall -...
- Mass air flow sensor - replacement as an assembly - service tip
- Air conditioning - compressor failure - insufficient amount of refrigerant oil
- Vehicles experience chaffing on the 14401 wire harness causing the accessory fuses to become open...
- For stalling concerns, reflash the PCM w/ 96 calibration (R11 level)
- 2.5L duratec engine exchanges no longer include front end accessory drive component, oil level indicator,...
- When replacing an internal wiring harness on 4R44E/4R55E transmissions built before 11/30/95 with a new...
- Rangers w/ 2.3L, for all issues relating to water pump leakage during warranty period, call jim shopp on...
- 4X4 front axles must use hypoid 4X4 gear oil p/n F1TZ-19580-A & high temp 4X4 front axle & wheel bearing...
- The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because...
- Availability of high altitude transmission
- On transmissions built before 6/20/95 (fig 1) an extended shift and a higher engine RPM than expected...
- Lamp - 'check engine' malfunction indicator lamp (MIL) illuminated - diagnostic trouble code (DTC) 1405...
- Light clicking sensation or looseness as the steering wheel is turned
- Exhuast leak or ticking noise while accelerating
- The speed control switch illumination may flicker and horn operation may be intermittent when steering...
- Vehicles may have exhaust leak at y-pipe to exhaust manifold
- Speed control switch illumination may flicker and horn operation may be intermittent when steering wheel...
- Unknown
- Vehicles may have flashing o/d off indicator light, check engine light on and/or improper transmission...
- Fast burn process introduced to improve fuel economy causes a low frequency metallic noise during the...
- New radiator manufacturing process/modification
- Excessive clutch air gap on FS-10 a/c compressors CAN allow the clutch disc to move away from the pulley
- New electronically controlled transmission for 1995 explorer and ranger
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 Ford Ranger?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history