1991 Freightliner FL-60 problems

What is wrong

Vehicle description: heavy duty truck. The shoulder bolt which holds the grote turn signal switch case and components together can loosen resulting in the turn signal malfunctioning.

Risk

If the turn signal function is lost, following motorists would not be aware of the turning vehicle, increasing the risk of a vehicle crash.

Remedy

Dealers will inspect these vehicles and tighten any loose bolts and in the turn signal switch within 2 years from the date of the recall notification letter. The shoulder bolt will be removed, cleaned, and reinstalled with loctite. Owners can also request loctite and repair instructions so they can fix the vehicles themselves.

Recall number 97V114001 · Recall details

What is wrong

The parking brake lever may not travel far enough over center to assure that it remains in the proper position allowing the vehicle to roll away while parked.

Risk

If the vehicle is not properly parked with the transmission in the correct position, and if the vehicle is parked on a grade, it could unintentionally roll away increasing the potential for an accident.

Remedy

Dealers will remove and replace the parking brake lever with a lever that requires a 25 lb. Effort to release.

Recall number 95V094000 · Recall details

What is wrong

The brake chamber mounting studs can loosen or pull through due to fatigue in the brake chamber housing caused by foundation brake chatter.

Risk

This condition can result in loss of braking capability.

Remedy

Dealers will change the brake lining materials, replace the wing bracket with a reinforced bracket and install brake chambers with reinforced chamber housing and larger (1/2") mounting studs.

Recall number 95V018000 · Recall details

What is wrong

The windshield wiper arm support cracks where the wiper arm pivot mounts to the support brackets causing failure of the system.

Risk

Failure of the windshield wiper system reduces drivervisibility in inclement weather which could result in an accident.

Remedy

Remove and replace the windshield wiper arm support bracket with a redesigned support bracket.

Recall number 93V148000 · Recall details

What is wrong

A number of cabs were assembled with fewer welds than specified in the upper b pillar near the anchorage for the seat belt. Welding materials used on the inboard anchorage bracket under the cab deck will not meet fmvss no. 210 load test requirements when three seating positions are provided.

Risk

Safety belt anchorage systems that do not comply to theload test requirements subject the seat occupant to greater risk of injury inthe event of a sudden stop or accident.

Remedy

Add reinforcement welds in the upper b pillar and add fasteners to the lower deck anchorage bracket.

Recall number 92V057000 · Recall details

What is wrong

The hook size of the throttle return spring is too small resulting in a tight fit around the anchor nut, causing the throttle return spring to break prematurely.

Risk

If the throttle spring breaks, the engine will return to idle speed, which may cause a highway hazard and result in a vehicle crash.

Remedy

Install throttle return springs with larger hooks.

Recall number 91V177000 · Recall details

What is wrong

Reservoir interior paint was allowed to enter the air reservoir check valve, and the valve is not properly seated.

Risk

Lack of proper seating causes the reservoirs to failto comply with the requirements of fmvss 121.

Remedy

Clean and reseat the air check valves as needed.

Recall number 91V178000 · Recall details