The worst 1994 GMC K35 problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 4
Seats
- What is wrong
- The seat recliner to seat frame attaching bolts on these vehicle could loosen, fatigue and fracture, allowing the seat back to suddenly recline.
- Risk
- If this were to occur to the driver's seat, this could result in a sudden loss of vehicle control increasing the risk of a vehicle accident.
- Remedy
- Dealers will remove all foam and/or fabric sandwiched between the recliner assembly and the seat frame, install washers between the seat recliner and the seat frame at each attachment point, and install new attaching bolts torqued to a higher specification. These corrections will be made to both the driver's and passenger's seats.
Recall number 95V246000 · Recall details
Suspension: front: control arm: lower arm
- What is wrong
- Trucks were assembled with the left-hand lower control arm to frame rear nut tightened below the specified torque. Low torque on this nut may allow the attachment bolt to loosed and subsequently fatigue and break. The bolt breakage can cause the left hand control arm to separate from the frame.
- Risk
- If this occurs, a loss of vehicle control and a crash could result.
- Remedy
- Dealers will tighten the left-hand lower control arm to frame rear nut to the proper torque specification.
Recall number 94V060000 · Recall details
Seats
- What is wrong
- The seats have been assembled without bolts that connect the upper slave hinge to the seat back frame, or without bolts that connect the seat to the seat adjuster. In either case, the vehicles fail to conform to fnvss no. 207, "seating systems."
- Risk
- The missing bolts may cause the driver's seat to becomeloose and in a sudden stop or accident may subject the occupant to increasedrisk of injury.
- Remedy
- Dealers will inspect seats for missing bolts and install bolts if required.
Recall number 93V216000 · Recall details
Service brakes, hydraulic: pedals and linkages
- What is wrong
- The brake pedal push rod retainer is missing, mispositioned or not properly seated.
- Risk
- Brake pedal push rod problems can cause the stop lampswitch and the brake booster push rod to disconnect from the brake pedal,resulting in loss of brake operation, and a vehicle crash could occur withoutprior warning.
- Remedy
- Inspect vehicles to assure the brake pedal push rod retainer is present and fully seated in its correct position.
Recall number 93V152000 · Recall details
See all 4 recalls for the 1994 GMC K35
Defect investigations
Front seat back collapse
Front seat back recliner attachment bolts loosen, fatigue, and fracture, allowing the seat to collapse backwards without warning.
PE95050
Technical service bulletins for the 1994 GMC K35 1
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
Compare the 1994 GMC K35
Other model years
Questions about the 1994 GMC K35
Is the 1994 GMC K35 reliable?
Owners have filed 0 complaints about the 1994 GMC K35.
What is the most common problem with the 1994 GMC K35?
There are not enough complaints to tell.
How many recalls does the 1994 GMC K35 have?
4 recalls, covering seats, suspension and service brakes, hydraulic.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 GMC K35?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history