1994 GMC K35 recalls
There are 4 safety recalls on record for the 1994 GMC K35, covering 777,338 vehicles in total across all the models in each campaign. Newest first.
All recalls
Seats
- What is wrong
- The seat recliner to seat frame attaching bolts on these vehicle could loosen, fatigue and fracture, allowing the seat back to suddenly recline.
- Risk
- If this were to occur to the driver's seat, this could result in a sudden loss of vehicle control increasing the risk of a vehicle accident.
- Remedy
- Dealers will remove all foam and/or fabric sandwiched between the recliner assembly and the seat frame, install washers between the seat recliner and the seat frame at each attachment point, and install new attaching bolts torqued to a higher specification. These corrections will be made to both the driver's and passenger's seats.
Recall number 95V246000 · Recall details
Suspension: front: control arm: lower arm
- What is wrong
- Trucks were assembled with the left-hand lower control arm to frame rear nut tightened below the specified torque. Low torque on this nut may allow the attachment bolt to loosed and subsequently fatigue and break. The bolt breakage can cause the left hand control arm to separate from the frame.
- Risk
- If this occurs, a loss of vehicle control and a crash could result.
- Remedy
- Dealers will tighten the left-hand lower control arm to frame rear nut to the proper torque specification.
Recall number 94V060000 · Recall details
Seats
- What is wrong
- The seats have been assembled without bolts that connect the upper slave hinge to the seat back frame, or without bolts that connect the seat to the seat adjuster. In either case, the vehicles fail to conform to fnvss no. 207, "seating systems."
- Risk
- The missing bolts may cause the driver's seat to becomeloose and in a sudden stop or accident may subject the occupant to increasedrisk of injury.
- Remedy
- Dealers will inspect seats for missing bolts and install bolts if required.
Recall number 93V216000 · Recall details
Service brakes, hydraulic: pedals and linkages
- What is wrong
- The brake pedal push rod retainer is missing, mispositioned or not properly seated.
- Risk
- Brake pedal push rod problems can cause the stop lampswitch and the brake booster push rod to disconnect from the brake pedal,resulting in loss of brake operation, and a vehicle crash could occur withoutprior warning.
- Remedy
- Inspect vehicles to assure the brake pedal push rod retainer is present and fully seated in its correct position.
Recall number 93V152000 · Recall details
Questions about the 1994 GMC K35 recalls
How do I check if my 1994 GMC K35 has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 1994 GMC K35 have?
4, covering seats, suspension and service brakes, hydraulic.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 GMC K35?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history