2025 GMC Sierra 1500: engine knocking or ticking

Filed Oct 29, 2026 · Engine · MI

This is a follow up to my recent safety concern on my 2025 GMC Sierra 1500 with the 6.2 engine. Dropped off my vehicle to our GMC service dealer on 10/22/2026 - Oil change and 15K mile check up was getting close. Mileage at drop off was 14,278 and the engine was still making sounds/noise and getting louder. Asked the service advisor to check for metal in the oil or filter. Based on their service review and advisors response, metal was found in the oil filter and engine is ticking. Service department sent information to GM rep for further actions needed. Dealer rep stated that I need a new engine due to this new found issue. Waiting for response from a GM representative at this time. Truck is in my garage at home. I remain very concerned about driving this vehicle at this time. Just called the dealership as I have not heard of any follow up yet. Call went to voice mail of my service advisor. 6.2 Engine is ticking and metal has been found in the filter. Please add this to my original concern on this VIN #.

Filed Oct 22, 2026 · Engine · MI

Severe Engine Knock

Filed Oct 19, 2026 · Engine · MI

In April 2025, we purchased a new GMC Denali Sierra 1500 Ultimate pickup truck. Concerns – Many of these comments appear in the Dealer Service Reports 1st Service Visit 10/17/25 At our first oil change and scheduled maintenance (10/17/25) with mileage of 5403 miles, during the drop-off I informed the GM Service Advisor of a clicking sound from the engine which I thought might be a fan belt. When I picked up the truck from Service, the Service Adviser informed me that upon startup, a “clatter” type noise was heard, “reminiscent of bad lifters.” The Service Adviser reported that during the mechanic’s test drive, the “clicking noise would get louder with engine speed.” No trouble codes were found after being checked by the MDI. They checked for misfires and a few misfires were found but “not often. At “idle” during this service call, the Left Engine Bank had a “good click/metallic tap to it.” “When the idle was raised, the Right Bank would get loud and had a loud tapping sound.” The oil change did not show any visible metal particles. The GM Service Department recommended a “complete tear-down of the engine for further inspection,” tentatively scheduled in a few weeks, pending Service availability. The Service Adviser stated he would recommend an engine replacement. 2nd Service Visit 10/27/2025 While driving the truck, I noticed that the engine “ticking” had gotten louder, and a Check Engine light had gone on and off. I returned to the Service Department on 10/27/25 (mileage 5807). The Service Department inspected the vehicle and found no “stored DCTS” but found “noise is there for internal engine noise.” The team recommended “tear-down or possible new engine.” Service appointment was set for 11/3/2025 for 5-days. 3rd Service Visit 11/3-7/2025 Service department reported that there were no problems. Vehicle was not under recall..... Scheduling a oil change this week. 14,500 miles.

Filed Aug 29, 2026 · Engine · AR

FROM DEALER ASSESSMENT Concern - CUSTOMER STATES WHEN VEHICLE IS ACCELERATING THERE IS A RATTLE Correction - test drove and was able to duplicate rattle/knocking from the engine. checked oil level and condition verified both are good. checked for bulletins and followed 23-NA-170. compared vehicle noise to noise is video and noise is nearly identical. removed oil filter and inspected for debris, found heavy amounts of metal debris present in the filter. performed crankshaft end play mesasurement and found that the crankshaft end play is way over spec at 1/4 of an inch. recommend replacing the engine assembly per bulletin Parts) 1x ENGINE 2x (S)GASKET $0.00 $0.00 6x (S)BOLT 1x BOLT 1x exhaust pipe connector gaskets both sides $0.00 8x (S)GASKET 1x fuel feed pipes all $0.00 1x (S)SEAL KIT 1x (S)GASKET $0.00 1x (S)SEAL 1x W-(S)RADIATOR $0.00 1x (S)HOSE 1x coolant $0.00 1x oil filter 1x oil $0.00 Approved 2026-08-18 Labor: $0.00 Parts: $0.00 $0.00 $0.00 $0.00 $0.00 $0.00 $0.00 $0.00 Subtotal Line B: $0.00 *Subtotal is before Shop Charge and Taxes

Filed Aug 29, 2026 · Engine, Transmission · TX

Engine started knocking at 18k miles and took to dealer and they found metal in the filter and installed a new engine and also replaced the midplate gasket on the valvebody due to a harsh downshift without codes in the system this engine is going on 2k miles and it seems to be fine now but the problem with 6.2 was only supposed to be on the 21-24 models and mine is a 25 model and already had a replaced and nothing from gm was said to extend the warranty on this model and powertrain

Filed Aug 24, 2026 · Engine · IL

The 2025 GMC Sierra 1500 with 18,675 miles and the 6.2 gas engine failed during a road trip. I was on my way from [XXX] to [XXX] on the Interstate when about 7 hours in, just outside [XXX]. I was noticing a lack in power when I pulled out of a rest area. The truck would not accelerate over 60mph. I slowed down and as I was pulling off the side of the interstate, the truck died. There was knocking sound as I started to pull over. I attempted to restart the vehicle; it did not restart. I called roadside assistance and the tow truck to myself and the truck into Edwards Chevrolet Cadillac in [XXX]. They diagnosed the issue as spun or bad bearing in the engine, and it would need replaced. They told me that the last 6.2 engine took 60+ days to receive and they were now on backorder, plus they already had a truck in the shop waiting for one. There were no warning indicators on the console, and all my service has been done at GM dealers. The biggest safety issue was being stuck on the side of the interstate with rushing semi's going by. I was also going to be stuck in [XXX] until a resolution was found. I ended up purchasing a new 2026 GMC Denali Ultimate with the 3.0 diesel. It was the closest package that was on my 2025 and I wanted to stay the same, minus the 6.2 engine. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Jul 29, 2026 · Engine · AL

Engine started making a loud knocking noise and it sounded like the engine was about to throw a rod. Turned engine off and called GM. Vehicle was towed to dealership and it was diagnosed with a thrust bearing failure. My truck only had 14k miles on it. To fix the bearing issue, it will need a new engine. GM does not currently have engines to replace the faulty ones so it has sat at the dealership for 3 weeks with No ETA as to when it will be fixed. This is apparently a common problem in the 2025-2026 models LZ0 3 liter diesel. They are still selling these affected vehicles currently, knowing that they may have a problem. GM needs to issue a recall and take these vehicles back.

Filed Jul 7, 2026 · Engine · ID

What component or system failed or malfunctioned, and is it available for inspection upon request? The engine/powertrain failed. The vehicle is a 2025 GMC Sierra 1500 equipped with the 6.2L V8 engine. The engine developed a severe knocking noise and loss of power at approximately 5,545 miles. The vehicle was taken to the GM dealership, where an engine replacement was approved. The failed engine/component may be available for inspection through the dealership or GM, depending on whether it has already been removed or returned to the manufacturer. How was your safety or the safety of others put at risk? The engine failure created a safety concern because the vehicle experienced reduced power/loss of propulsion while being operated. This could have put me and other drivers at risk because a sudden loss of engine power can make it difficult to safely maintain speed, merge, tow, or move the vehicle out of traffic. The issue occurred at very low mileage and without enough warning to prevent the failure. Has the problem been reproduced or confirmed by a dealer or independent service center? Yes. The problem was confirmed by a GM dealership. The dealer diagnosed the engine failure and GM approved an engine replacement under warranty. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? The vehicle was inspected by the GM dealership. GM was involved in approving the engine replacement under warranty. To my knowledge, the vehicle has not been inspected by police or insurance representatives. Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? Prior to the failure, the vehicle developed a severe engine knocking noise and reduced power/lack of power. These symptoms appeared shortly before the engine failure at approximately 5,545 miles. I do not recall any specific warning lamps or messages before the failure, unless the dealership records

Filed Apr 16, 2026 · Engine · 26,634 miles · TN

The contact owns a 2025 GMC Sierra 1500. The contact stated that while driving at an undisclosed speed, the engine made abnormal knocking sounds. No warning light was illuminated. The vehicle was taken to the dealer, who discovered metal shavings inside the engine oil and determined that the crankshaft bearings had failed. The contact was informed that the engine needed to be replaced. The vehicle was not yet repaired and remained with the dealer. The manufacturer was made aware of the failure. The failure mileage was 26,634.

Filed Feb 23, 2026 · Engine · MI

2025 GMC Sierra 6.2 L V8 engine failed by locking up or seizing. Heard pinging / knocking sounds while driving 3 miles from my home to the dealer. Engine shut off without warning, vehicle shifted to Neutral. Coasted to a stop, attempted to restart the engine, would only crank. Dealer diagnosis is that the engine will need to be replaced. Sounds just like the 2021 - 2024 GM recall for this same engine. Vehicle has 11,670 miles on it. Safety risk: Loss of ALL power while driving. No Warning lamps or messages prior to engine failure.

Filed Jan 17, 2026 · Engine, Transmission · TX

I bought my truck new in June 2025. On the night of December 29, 2025, with around 9,300 miles on the odometer, I began to hear a knocking sound coming from the engine while I was driving it back to my house from my mother's house. The sound got progressively louder and louder. The truck eventually displayed a "reduced acceleration drive with care" warning. I thought catastrophic engine failure was imminent and did not believe I could make it home. I called my in-laws (they were closer to my location than my house), agreed to park it there overnight, and thankfully made it to their house. The next day the truck was towed to the GMC dealership. A week later, GMC diagnosed this issue as a thrust bearing/crankshaft issue and agreed to replace the entire engine. A crankshaft issue in a new diesel engine should not occur, yet it did. My vehicle is currently being repaired, so the dealership said they had no repair records to provide me. This is the link to the video of the sound it was making after I made it to the in-laws: [XXX] I had just dropped off my [XXX] child with my mother about twenty minutes earlier. I was extremely close to being stranded on the side of the highway at night in the December cold with a [XXX] baby. Thankfully, that did not happen, but it was a close call. My cousin also has had a similar issue with the exact same make and model of his truck. I believe this engine is not being manufactured according to the design specifications and it is a danger to the public until the manufacturing issue with the supplier is adequately corrected. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Jan 7, 2026 · Engine, Visibility · 18,000 miles · AZ

The contact owns a 2025 GMC Sierra 1500. The contact stated that while driving at 35 MPH, there was an abnormal knocking sound coming from the engine. No warning lights were illuminated. The vehicle was towed to the dealer, where it was diagnosed with a rough idle code, and that the thermostat coolant housing had failed. The contact was provided DTC codes: B1A76 with failure Code 0X15 (pending), P05D, U0075, U0101, U0146, U020C, U0265, U1614, and U1616, and the codes were active. The vehicle was repaired. The contact picked up the vehicle from the dealer after hours, and when the contact started the vehicle, the abnormal knocking sound was still coming from the engine. No warning lights were illuminated. The contact stated that when the A/C was turned off, the abnormal sound ceased. Additionally, the contact performed the oil changes on the vehicle and noticed that the engine was consuming an excessive amount of engine oil. The contact stated that there were no oil stains on the ground. The contact needed to add oil every 800 to 1,000 miles driven. The vehicle was taken to O'Reilly's Chevrolet, located at 6160 E Broadway Blvd, Tucson, AZ, for a diagnostic test, and it was determined that the air compressor had failed. The vehicle was not repaired. The vehicle remained at the dealer pending the repair. The contact stated that when the A/C was activated, the knocking sound in the engine compartment returned. The manufacturer was not made aware of the failure. The failure mileage was approximately 18,000.