Driving down road started to hear a weird growling knocking sound and noticed a reduction of power. also noticed lower then normal oil pressure. Changed oil found metal shavings in the oil. sent to chevy dealership. Diagnosed "rod bearing failure" needs new engine.
2020 GMC Sierra 1500: engine knocking or ticking
50 of the 484 complaints about the 2020 GMC Sierra 1500 describe engine knocking or ticking.
- owner complaints
- 50
- of this car's complaints
- 10%
- typical repair cost reported
- $12,700
- typical mileage
- 110,000
- recalls
- 0
Engine knocking or ticking by model year
What owners say
While driving down interstate noticed drop in oil pressure and immediately a noise in engine with loss of power. immediately took it to dealership and they diagnosed rod bearing failure. Gm refuses to pay for engine.
The contact owns a 2020 GMC Sierra 1500. The contact stated that while driving 74 MPH, the vehicle made a loud banging sound, reduced engine power, and was losing oil pressure. The dealer associated the failure with the federal safety agency Action Number: EA25007 (Engine, Engine and Engine Cooling). The dealer was contacted and the vehicle was diagnosed with rod bearing failure. The manufacturer was contacted by phone and made aware of the failure. The failure mileage was approximately 124,000.
5/5/25 woke up back seat entire truck flooring soaking wet back glass cracked. 4/8/25 transmission went out 117,000 miles 7/3/25 exhaust leak and placed nox 1. 7/8/25 127551 mileage exhaust leak replace gaskets, belt , tensioner, and pulley, 6/8/2025 3 knock sensors replaced and replaced intake manifold.
Misfire on 2 cylinder, noise on start up diagnostic code P0300 P0302 P050 I was driving home and the engine started making a strange sound, vehicle would could no increase speed normally. The dealership did basic analysis from the onboard computer and did a compression test. Heavy knocking sound on passenger side of the engine. The issue happened on Aug 5th 2026. The issue is due to the AFM that causes the lifter to fail and dealership says I need a new engine $15787 or replace cam shaft $14530.
The truck starting making a ticking noise within 24 hours the check engine light was on and it starting shuttering. I got it to the dealership were they informed me of lifters failure, and catastrophic engine failure. Dealer is recommending replacing engine since it's a 2020 and not part of recall.
• While driving a loud popping and clicking noise started coming from the engine and the truck started shaking. The vehicle is available for inspection • It was a busy two lane road and I had to continue about 30mph under the speed limit to safely get off the roadway • upon start up the engine clicks and pops with rough idle and the truck shakes. A mechanic looked at it and stated it sounds like a lower rod bearing noise • No further inspections have been done • A Service ESC warning popped up when the engine started making noise during the incident. The truck had been taken in twice for rough idle and engine noises prior to 100k miles, but the dealership stated that the noise and feel was normal for the 6.2L engines
While driving at night, a low oil pressure warning light illuminated on the dashboard. The following morning, I checked the oil level using the dipstick, which indicated a normal reading. Based on this, I proceeded to drive the vehicle. Shortly after departing, the engine began knocking severely. I immediately stopped and returned home. The vehicle was towed to a GMC dealership for diagnosis. The dealership determined that the engine had experienced catastrophic failure and required complete replacement. I was quoted $11,000 for the repair.
2020 GMC Sierra 1500 began experiencing a slight knocking sound - mechanic diagnosed as a crankshaft issue. As of last night, 5/10, the truck's knocking sound got extremely loud, the exhaust pipe emitted smoke, and the truck began "bucking." No warning messages or lamps appeared.
We heard a knocking noise and took the truck to the nearest GM dealership. The engine had to be taken apart. The engine is a L87 6.2 liter V8. The GM dealership service department diagnosed camshaft damage that caused lifter failure. We have since been informed that GM has known about the failure of this engine for many years. In our case, we were fortunate that the engine did not fail when we were on the expressway. This is a huge safety issue. There were no warning lamps or messages from the vehicle, but we heard the knocking noise. We are facing a minimum of a 10,000 dollar repair and will not feel confident that this engine will not put our safety at risk in the future. We understand that the federal safety agency has initiated an Engineering Analysis regarding this engine for the model years 2019 to 2021. (EA25007). We wanted you to have the information of another dangerous engine failure.
On 6/27/22 my 2020 gmc sierra 1500 at4 6.2L had lifter failure. The dealer fixed that problem and on 7/1/22 again has lifter failure. The dealer fixed that problem again. On 7/13/22 a third time engine had lifter failure again. I requested they need a different engine to be installed and GM agreed andthey install an L87 2022 engine. This engine seemed weak and not right since it was installed. On 10/13/222i took the vehicle in to the dealer with a complaint of ticking noise from engine area and complaint of shifting hard. The fix the shifting but nothing was wrong with engine according to the dealer. On 3/15/24 the noise are worse and I can smell fuel and noticed white milky residue on the oil cap plus a growling nose coming from engine. Coolant keeps going low and white smoke out the exhaust. The dealer does diagnosis and again nothing is wrong. Now starts the oil consumption testing and me letting the dealer know that I can smell oil and exhaust but they can't. On 8/29/2024 I take truck in for another diagnosis for rattle sounds I'm hearing under the hood from the engine especially when you accelerate. I pay $149.49 for the dealer to find the noise and they tell me they can't find anything, but everyone who has rode in the truck can. On 1/27/2025 I take the vehicle in again and the dealer does the valve cover leaking and replaces that is covered. On 2/3/2025 again vehicle back to dealer cause I can smell antifreeze and burning oil smell. The only thing they found was the muffler had a Lil leak so they wanted me to get it welded which i did and so can smell the oil. On 6/16/2025 I take the vehicle in for oil change and leave to go home then go to work about 95 miles or more and noticed after I parked and was working before I was going to head home there was a huge puddle of oil under the vehicle. I took pics. Found after inspecting my vehicle the oil cap was not in filer tube but instead sitting up on air shelf above radiator. Oil filter was about 3 turns loose.
There is a click/ticking noise when vehicle is started. Noise gets louder and faster when accelerating. Have taken vehicle to 2 mechanic shops and been told by both places it is bad lifters and exhaust manifolds. I took this truck in because of loss of power. This issue has put me in unsafe/ dangerous positions on multiple occasions.
Service bulletins that may apply
- This technical bulletin provides a procedure to replace the camshaft actuator magnet to correct customer...
- This informational bulletin advises the technician of a part number change for long block engines used in...
- This service bulletin provides information on replacing the intake manifold when the engine is replaced...
- This bulletin advises the tech to inspect deeper into what may be to main
- The service bulletin advises the tech of a normal transmission shift condition and the delay in throttle...
- This service bulletin provides information to dealership personnel for new vehicles with less than 1,000...
- This bulletin advises the tech that the Exhaust Roller Follower may be the issue with the engine Ticking...
- This warranty administration bulletin provides policy information on vehicles outside of a California...
Related recalls
No recalls on record for this model year.
Questions about the 2020 GMC Sierra 1500 knocking
Is engine knocking or ticking a common problem on the 2020 GMC Sierra 1500?
50 of 484 owner complaints about the 2020 GMC Sierra 1500 (10%) mention engine knocking or ticking. The model year with the most reports is 2021.
How much does it cost to fix engine knocking or ticking on the 2020 GMC Sierra 1500?
Owners who mentioned a price put the repair at about $12,700 (median of 7 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
Is there a recall or service bulletin for this on the 2020 GMC Sierra 1500?
There are 0 recalls and 372 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2020 GMC Sierra 1500
Engine failure 86Check engine light 85Loss of power 54Misfire 26Transmission failure 20Won't shift 19Stalling 18Power steering loss 15Won't start 15Brake failure 14Warning lights 12ABS 11Fuel pump 11Harsh shifting 11Shudder 11Backup camera 10Jerking 10Oil consumption 10Ball joint 9Fire or smoke 9Hesitation 9Adaptive cruise 7Water leak 7Headlights 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2020 GMC Sierra 1500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history