GMC Sonoma recalls
There are 15 safety recalls on record for the GMC Sonoma, covering 4,159,194 vehicles in total across all the models in each campaign. Newest first.
GMC Sonoma recalls by model year
2004 12003 12001 12000 31998 31997 21996 61995 31994 21993 21992 11991 1
All recalls
Equipment: other: labels
- What is wrong
- Certain pickup trucks and sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 208, "occupant crash protection."
- Risk
- Some of these vehicles include incorrect statements on one of the air bag warning labels.
- Remedy
- Owners will be provided with correct labels and installation instructions. Owner notification began on june 4, 2004. Owners should contact chevrolet at 1‑800‑630‑2438 or gmc at 1‑866‑996‑9463.
Recall number 04V132000 · Recall details
Equipment: other: labels
- What is wrong
- Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles were built with incorrect payload information on the vehicle certification label. The payload shown on the label is greater than the maximum validated payload. If the vehicle were loaded to the incorrectly labeled payload, it may not ride and handle in the manner that the driver expects.
- Risk
- This could result in a loss of control of the vehicle or an inability to stop the vehicle within expected stopping distances.
- Remedy
- Owners will be sent a new label for installation on the driver's door of the vehicle.
Recall number 00V258001 · Recall details
Exterior lighting
- What is wrong
- Vehicle description: light duty pickup trucks and sport utility vehicles. These vehicles fail to comply with the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment." the daytime running lights built with a candela value greater than 3,000 cannot be mounted higher than 864mm above the road surface.
- Risk
- These vehicles do not comply with requirements of fmvss no. 108.
- Remedy
- Dealers will install a revised wiring harness that changes the drl's from high beam to low beam drl's, and install new long-life low beam bulbs.
Recall number 00V220000 · Recall details
Seat belts
- What is wrong
- Vehicle description: passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."
- Risk
- In the event of a vehicle crash, the occupant may not be properly restrained.
- Remedy
- Dealers will inspect the vehicle's safety belt buckle assembly date codes and, if necessary, will replace any safety belt buckle assembly.
Recall number 00V228003 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- Vehicle description: light duty pickup trucks equipped with 4-wheel disc brakes. Some of these vehicles have an antilock brake system (ABS) motor containing an out-of-specification spring clip. This clip could allow the motor bearing to become misaligned. If misalignment occurs, eventually the ABS would be non-functional.
- Risk
- The base brakes would remain fully functional, but the dynamic rear proportioning (drp) system, which optimizes front to rear brake balance, would become inoperative.
- Remedy
- Dealers will replace the brake pressure module valve assembly.
Recall number 00V055000 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- Vehicle description: s -trucks equipped with 2 wheel drive. These vehicles may have had the right-hand antilock brake system (ABS) module feed pipe and/or brake crossover pipe tube nuts tightened without seating the pipe-flared-ends enough to withstand normal assembly and vehicle inputs without partially unseating. This does not comply with requirements of fmvss no. 105, "hydraulic service brake normal, emergency, and park braking performance."
- Risk
- If this occurred, the seating seal could be broken during vehicle assembly, or from early road inputs or brake fluid cycling, and a leak could occur increasing the brake stopping distance.
- Remedy
- Dealers will inspect the brake pipe union for signs of brake fluid, and if necessary, install a new brake pipe union.
Recall number 99V220000 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive can malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.
- Risk
- If this occurred at a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
- Remedy
- Dealers will replace or repair the 4-wheel/2-wheel drive switch.
Recall number 99V193000 · Recall details
Visibility: windshield wiper/washer
- What is wrong
- Vehicle description: light duty pickup trucks and sport utility vehicles, 2 and 4-wheel drive. Solder joints near the wiring harness connector can crack causing the windshield wipers to work intermittently.
- Risk
- This condition can result in inoperative wipers, reducing a driver's visibility, and increasing the risk of a vehicle crash.
- Remedy
- Dealers will replace the wiper motor circuit board and cover.
Recall number 98V150001 · Recall details
Electrical system: wiring: front underhood
- What is wrong
- Vehicle description: light duty pickup trucks and multi-purpose vehicles. An engine electrical wiring-harness clip can melt and drip onto the exhaust manifold.
- Risk
- The clip material on the exhaust manifold can ignite and subsequently ignite other combustible components resulting in a vehicle fire.
- Remedy
- Dealers are contacting owners by telephone to have their vehicles towed to the dealer and alternate transportation provided to them until the dealer can reroute the electrical wiring-harness.
Recall number 97V208001 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Vehicle description: light duty pickup trucks and multi-purpose passenger vehicles. A fatigue fracture of the rear axle right-hand brake pipe can occur causing a slow brake fluid leak resulting in a soft brake pedal. If the brake pipe breaks, the driver would experience a sudden drop in the brake pedal, the instrument panel brake light would illuminate, and there would be a loss of rear brake performance.
- Risk
- Partial loss of braking at a time when minimum stopping distance was required could result in a vehicle crash.
- Remedy
- Dealers will inspect and replace the brake pipe.
Recall number 97V218000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Vehicle description: light duty passenger pickup trucks equipped with 4.3l engines. The front brake line can contact the left-hand side of the engine oil pan causing the brake line to wear to the point of brake fluid loss during brake application.
- Risk
- Brake fluid loss can reduce braking effectiveness and increase stopping distances resulting in a vehicle crash without prior warning.
- Remedy
- Dealers will inspect the clearance between the oil pan and the brake line. If the clearance is 6mm or less, dealers will install an additional brake line clip and if there was contact between the oil pan and brake line, the front brake line will be replaced.
Recall number 97V146001 · Recall details
Seat belts
- What is wrong
- Vehicle description: extended cab pickup trucks equipped with 60/40 front bench seats and extended cab pickup trucks and 2-door utility vehicles equipped with manual locking recliner bucket seats. The outboard safety belt webbing on the driver's and/or passenger's seat can separate during a frontal impact.
- Risk
- If a separation occurred and there were secondary crash events or vehicle rollover, there would be no belt restraint of the occupant and increased injuries could occur.
- Remedy
- Dealers will install a protective cover over the recliner mechanism.
Recall number 97V096001 · Recall details
Visibility: windshield
- What is wrong
- The top coat paint severely peels due to overbaking of the powder primer prior to the top coat application. Since the windshield primer and adhesive adhere to the top coat paint onthe windshield opening flange, the windshield does not comply with federal motor vehicle safety standard no. 212, "windshield mounting."
- Risk
- In the event of a vehicle crash, the windshield may not stay in place as required by fmvss no. 212.
- Remedy
- All vehicles have been repurchased. This campaign is 100%.
Recall number 97V008001 · Recall details
Power train: manual transmission
- What is wrong
- Some of these trucks were built with transmissions containing parts which were not machined to gm's specifications.
- Risk
- These transmissions could seize and lock the rear drive wheels while the truck is being driven causing a loss of vehicle control increasing the potential for a vehicle accident.
- Remedy
- Dealers will inspect the transmission main shaft output torque using a special tool. If the output torque does not meet specifications, the transmission will be replaced.
Recall number 96V035000 · Recall details
Power train: automatic transmission
- What is wrong
- Significant wear can develop on the low and reverse clutch preventing the park pawl from engaging. This can prevent a "no park" condition to occur while the engine is running, causing unintentional movement of the vehicle without operator action. (the "no park" condition will not occur while the engine is off.)
- Risk
- Unintentional vehicle movement could result in a vehicle accident and injury to persons in the path of the vehicle.
- Remedy
- Dealers will check the transmission fluid for contamination which will indicate if the low or reverse clutch is worn. If the transmission fluid shows contamination, the transmission will be replaced.
Recall number 94V093000 · Recall details
Questions about the GMC Sonoma recalls
How do I check if my GMC Sonoma has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the GMC Sonoma have?
15, covering equipment, exterior lighting and seat belts.
VIN decoder
See the problems and recalls for an exact car
Buying a used GMC Sonoma?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history