On XXX, I was driving my 2022 GMC Yukon XL Denali equipped with the 6.2L L87 V8 engine, with my [XXX] stepson as a passenger, when the engine malfunctioned and stalled, leaving the vehicle disabled in traffic. The vehicle registered diagnostic trouble code P0016 (Crankshaft Position–Camshaft Position Correlation, Bank 1 Sensor A). Prior to this incident, the vehicle had undergone GM's L87 Engine Loss of Propulsion Safety Recall 25V‑274 (GM Campaign N252494000). The vehicle passed the required engine inspection and was cleared to receive the prescribed oil viscosity change from 0W-20 to 0W-40. Under GM's recall service procedure, vehicles displaying P0016 during the inspection were required to be quarantined rather than proceeding with the oil-change remedy. Therefore, the completion of the prescribed remedy indicates that P0016 was not identified during the earlier recall screening. Despite passing GM's engine inspection and receiving the recall remedy, the engine subsequently experienced a failure involving P0016 and a complete loss of propulsion. This raises significant concerns about whether GM's inspection procedures and oil viscosity remedy adequately identify and prevent engine failures in affected vehicles. While our Yukon was disabled in traffic due to the engine stall, another motorist failed to stop and struck the vehicle from behind. The collision caused extensive damage, and the vehicle was subsequently declared a total loss. Although the other driver failed to stop, the engine failure was the initiating event that left our vehicle stranded and exposed to approaching traffic. At the time of the collision, I was [XXX] pregnant and required ambulance transportation, emergency medical evaluation, head imaging, and fetal monitoring. I subsequently experienced post-concussion symptoms and a mandibular-joint injury. My [XXX] stepson was also inside the vehicle. Vehicle can be held for inspection w/letter sent. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
2022 GMC Yukon XL: engine stalls while driving
11 of the 176 complaints about the 2022 GMC Yukon XL describe engine stalls while driving.
- owner complaints
- 11
- of this car's complaints
- 6%
- typical mileage
- 60,000
- recalls
- 1
Engine stalls while driving by model year
What owners say
Engine failure occurred while driving with two children in the vehicle, creating a serious safety hazard. The vehicle experienced a sudden loss of power and stalled completely while in motion, with no prior warning lights, alerts, or messages. Prior to this failure, the vehicle had already failed the GM PICO test related to the known L87 engine issue, and the recommended corrective action was changing the oil to 0W-40 synthetic and replacing the oil cap. Despite that intervention, the engine still failed at approximately 49,000 miles. A sudden complete engine stall without warning while driving created a dangerous situation, particularly with children in the vehicle. This raises concern that the prior corrective action did not resolve the underlying defect..
On [XXX], my 2022 GMC Yukon Denali XL (VIN [XXX] ) experienced a complete loss of propulsion while I was driving on [XXX] in El Paso, Texas, with my wife and two young children in the vehicle. Mileage was approximately 50,364. While in motion, the vehicle was displaying abnormal behavior, concerned the vehicle would stall on the highway, I exited at the Geronimo exit. As the vehicle slowed, it shut down entirely. Multiple restart attempts failed. The dashboard cycled on and off, displaying a "Service 4WD" warning while the vehicle was in 2WD mode. The transmission locked, and the vehicle became inoperable in the middle of the roadway with traffic passing on both sides. OnStar SOS was activated to communicate the unsafe location. The El Paso Police Department was requested to divert traffic. A city tow vehicle arrived after approximately fifteen minutes; my family was assisted across the roadway. Roadside assistance did not arrive for approximately three hours. This was the second loss-of-propulsion event on this vehicle in less than twelve months. The first occurred in March 2025 and resulted in engine replacement under the federal safety agency Safety Recall 25V274 (L87 Engine Loss of Propulsion). The [XXX] failure occurred after the recall remedy had been applied and the engine was replaced. The vehicle was towed to the dealer who replaced the throttle body, intake air duct and a service item titled "Repair open ground circuit". I am filing this report to document a second loss-of-propulsion event on a vehicle that already received the remedy under Recall 25V274, and to ensure the federal safety agency has visibility into the potential pattern of recurring or inadequate remedy on the L87 platform. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The contact owns a 2022 GMC Yukon XL. The contact stated that while driving approximately 65 MPH, the vehicle stalled. The failure was a consistent failure. No warning lights were illuminated. The message "Press START Again" was displayed, and the contact restarted the vehicle, and the message "Engine Oil HOT" was displayed on the instrument panel. The contact stated that the vehicle was repaired under an unknown recall prior to the failure to prevent the failure; however, the failure reoccurred. The vehicle was towed back to the dealer to be diagnosed; however, the diagnostic result was pending. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 80,000.
The contact owns a 2022 GMC Yukon XL. The contact received notification of the federal safety agency Campaign Number: 25V274000 (Engine and Engine Cooling). The contact stated that while driving approximately 75 MPH, the oil warning light illuminated, and after 15 seconds, the vehicle lost motive power and stalled. There was smoke coming from the engine compartment. The contact pulled over to the side of the road; however, the vehicle failed to restart. The vehicle was towed to an independent mechanic, and the contact was informed that there was no oil in the engine, causing the engine to seize. The vehicle was not repaired. The vehicle was then towed to the dealer, where an unknown diagnosis was provided. The manufacturer was notified of the failure but declined to repair the vehicle because the failure was not associated with the recall. The failure mileage was approximately 60,000.
The contact owns a 2022 GMC Yukon XL. The contact stated that while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate, and the engine stalled. No warning lights were illuminated. The contact stated that the failure occurred while driving on a busy highway, and the contact's wife and four minor children were also occupants of the vehicle. The contact stated that the incident was significantly scary. The vehicle was driven to the shoulder of the road, which the contact considered unsafe for him and his family. The contact stated that both the contact and his family, which included a one-year-old child, had to walk to a safe location and sat for more than 40 minutes. The vehicle was towed to the dealer, where it was diagnosed that the engine had failed and needed to be replaced. The vehicle was not repaired. The dealer informed the contact that the repair was covered under the federal safety agency Campaign Number: 25V274000 (Engine and Engine Cooling), but the repair could take two months, and the parts needed to be ordered. The manufacturer was made aware of the failure, and a case was filed. The failure mileage was approximately 72,020.
Reported electrical issues beginning one month after purchasing the vehicle. I reported issues for the first year including the running boards not working, entertainment system not operating, hard engine restart/stalling and the reverse camera not engaging. February 2024 the car was driving down the highway and a loud noise began in the engine. Entire car stopped running. Placed in the shop for 29 days to replace the engine, battery, computer, and other items. The next day engine began to stall again. Monday at 10am the car stalled again and was unable to be turned back on. Car was then taken for another 15 days fuel injectors, spark plugs and other items changed. Again received the car back and had issues with stalling and engine revving issues. Turned into dealership and bought another GMC Yukon. GMC refused to admit an issue and refused to help.They only changed out the initial engine and paid for the rental. Car under full warranty for manufacturer plus maintained my extended warranty. Reported to BBB.
BATTERY: Vehicle died at highway speed 1/12/23 with 25,404 miles on it. Towed to dealership, battery died while driving. Vehicle would not start 12/01/24 at 88,013 miles, battery was dead. ENGINE: Reported engine knocking and high idle 1/30/23 with 26,608 miles on vehicle. In service department until 03/03/03 with no issues found. Took vehicle to another dealership service department 06/06/23 with engine knocking and high idle, no issues found. Received back 06/12/23. Filmed the engine noises and high idle on 06/22/23, engine light came on and returned to service department at 37,265 miles. Engine was replaced after a lengthy wait time for replacement. Cam and Lifters were the issue in original engine. Received vehicle back 08/30/23. MODULES: Reported the display changing 1/30/23 with 26,608 miles, service documents state related to telematics controls. They replaced the module. Vehicle had a delay in shifting, reported on 06/06/23 with 36, 303 miles. Transmission control module was out of calibration and was reprogrammed at a dealership service department. Vehicle shifted into neutral multiple times. Reported to service department 09/08/23 at 38,183 miles. The transfer case lost communication with the brake control module, but they started communicating again without repairs according the service invoice. Then there was a recall for the screen switching displays, which it has done the entire ownership, even after replacing the module. Turned into dealership for that recall, it was updated, the displays still change screens while the vehicle is in use.
The contact owns a 2022 GMC Yukon XL. The contact stated while driving at an undisclosed speed, the vehicle stalled. The contact stated that there was no warning light illuminated. The contact stated that there was a loud clanking sound coming from the engine. The contact stated that the vehicle lost motive power with the check engine warning light illuminated. The vehicle was not able to restart. The vehicle was towed to the dealer where it was diagnosed with engine failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 55,000.
The contact owns a 2022 GMC Yukon XL. The contact stated that while his wife was driving 60 MPH, the vehicle lost motive power, prompting the driver to pull over to the shoulder of the roadway where the vehicle then stalled and was unable to be restarted. No warning lights were illuminated. The vehicle was towed to the dealer, who diagnosed a failure with the engine due to metal fragments being found in the engine. The contact was informed that the engine needed to be replaced. The vehicle was not yet repaired. After investigating the failure, the contact related the failure to the federal safety agency Action Number: PE25001 (Engine and Engine Cooling). The manufacturer was notified of the failure, a case was opened, and the contact was referred to the federal safety agency Hotline for assistance. The failure mileage was 44,000.
Vehicle stalled in the middle of highway. Truck decelerated rapidly with no warning. Was able to pull over before on small strip of shoulder before vehicle shut completely off. Law enforcement was called to shut down adjoining main lane as vehicle was in between main slab and on ramp. Vehicle was towed to local dealership. Problem was diagnosed by dealer as a fuel pump control module malfunction. Dealer and others in surrounding areas have multiple vehicles with same issue in their service department with no parts available through GM. There is a recall on 2021 models for this issue but not due 2022 models.
Service bulletins that may apply
- Condition where the connecting rod and/or crankshaft engine components in these vehicles may have...
- Under Field Actions N252494000, N252494001, the service procedure includes performing a PICO test on...
- Condition that could
- This technical bulletin provides a procedure to replace the camshaft actuator magnet to correct customer...
- This service bulletin provides information on replacing the intake manifold when the engine is replaced...
- This bulletin advises the tech to inspect deeper into what may be to main
- The service bulletin advises the tech of a normal transmission shift condition and the delay in throttle...
- This service bulletin provides information to dealership personnel for new vehicles with less than 1,000...
Related recalls
Engine and engine cooling: engine: hard parts internal/mechanical
- What is wrong
- General Motors LLC (GM) is recalling certain 2021-2024 Cadillac Escalade and Escalade ESV, Chevrolet Silverado 1500, Suburban, and Tahoe, GMC Sierra 1500, Yukon, and Yukon XL vehicles equipped with a 6.2L V8 gas engine. The connecting rod and/or crankshaft engine components may have manufacturing defects that can lead to engine damage and engine failure.
- Risk
- Engine failure increases the risk of a crash.
- Remedy
- Dealers will inspect the engine, and as necessary, repair or replace the engine. For vehicles that pass inspection, dealers will add higher viscosity oil, install 6 oil fill cap, replace the oil filter, and update the owner's manual. Repairs will be performed free of charge. Owner notification letters were mailed June 18, 2025. Owners may contact Cadillac customer service at 1‑800‑333‑4223, Chevrolet customer service at 1‑800‑222‑1020, or GMC customer service at 1‑800‑462‑8782. GM's number for this recall is N252494000.
Recall number 25V274000 · Recall details
Questions about the 2022 GMC Yukon XL stalling
Is engine stalls while driving a common problem on the 2022 GMC Yukon XL?
11 of 176 owner complaints about the 2022 GMC Yukon XL (6%) mention engine stalls while driving. The model year with the most reports is 2021.
Is there a recall or service bulletin for this on the 2022 GMC Yukon XL?
There is 1 recall and 205 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2022 GMC Yukon XL
Engine failure 76Loss of power 32Check engine light 25Knocking 18Won't shift 8Won't start 7Fuel pump 5Harsh shifting 5Oil consumption 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2022 GMC Yukon XL?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history